Question about 2003 Honda Accord

1 Answer

All doors lock when Dr.door closed with engine running

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

This is a common thiung on many brands of cars. they are supposed to unlock when you turn off the key.

Posted on Nov 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can't find the window fuse for 2003 caddy cts


Check inside trunk under carpet on rear seat back support.

Nov 12, 2016 | Cars & Trucks

1 Answer

My hatch won't release from the remote or the door switch. No solenoid sound at the hatch. How do I get it to open if it's not a bad fuse?


There are actually three relays , an there are controlled by the BCM - body control module !
When a door lock switch is activated in the lock or unlock position the BCM will receive a voltage signal on either the door lock switch lock or unlock signal circuits.
The BCM, upon receipt of a lock switch lock or unlock signal, will switch the appropriate lock relay control circuits to battery positive voltage. This will energize the appropriate lock or unlock relays. The relay will supply voltage to the door lock actuator lock or unlock control circuits to one side of the lock actuator. Since the opposing side of the lock actuators are connected to ground through the other lock actuator control circuit and the normally closed contacts of the lock or unlock relay, the doors and liftgate will then lock or unlock appropriately.
Three relays are used to operate the locks. DRV DR UNLCK relay, PASS DR UNLOCK and DR LCK relay. This is done to isolate the driver door lock actuator so it can be unlocked by itself using the keyless entry transmitter.
Rear Hatch/Gate Description and Operation
The liftgate can be opened by operating the switch on the instrument panel. Battery voltage is supplied to the liftgate actuator through the body control module (BCM). The BCM will pulse the liftgate actuator when a release input is received through the key fob, or the instrument panel switch.
Door/Lift gate Latch Assembly
  1. Install a 20-A fused jumper wire between the control terminal 3 and 12 volts. Install a jumper wire between the ground terminal 2 and ground.
  2. Verify the actuator turns on & off.
?‡'
If the function does not perform as specified, replace the applicable door latch.

Oct 01, 2015 | 2006 Pontiac Torrent

1 Answer

Automatic door locks will not lock while driving down the road. Doors are closed. What would stop automatic doors locks from working while engine is running?


Door locks are controlled by the body control module This module operates a relay that controls door lock function. The relay may be bad or the module may not be getting a signal from the speed sensor to let it know when to lock the doors when the vehicle is in motion. Check engine light on? Scan for codes that might pertain to this failure

Jul 10, 2015 | 2002 Ford Taurus

1 Answer

Why does my doge caravan doors lock when u start to warm it up as soon as you close the door you get locked out. Or when u have it started as soon as driver door closes the whole van locks?


You must have a "After Market Alarm" or something similar. The factory Auto door lock system doesn't lock the doors until the vehicle reaches 18 mph approximately.
So what I am saying is the Add-On Door Lock/Alarm System is malfunctioning - however some of those aftermarket systems can be programmed to lock doors with the engine running and Driver's door closed (they assume you will be sitting in the driver's seat at that time) It varies depending on which manufacturer built the system. I have seen on some of those systems they provide a small loopwire on the Module that can be cut to disable the Auto Door Lock feature - you might need the install manual to know which one.

Feb 20, 2015 | Cars & Trucks

1 Answer

2000 ml 430


This is a feature - it is normal, you have power door locks. It should also work that when you lock the drivers door all the other doors lock too.

Mar 24, 2014 | 2007 Mercedes-Benz ML500

1 Answer

2008 explorer door locks not locking from door switches


This is not a good thing. Ford uses a computer called the GEM and that means General Electronics Module. It controls:
  • Low Coolant Indicator On Cluster
  • Brake Indicator on Cluster
  • DRL - Control
  • Wipers
  • AutoLamps
  • Rear Defrost
  • Interior Lamps(dome)
  • High Beam Indicator only (cluster)
  • Low Coolant indicator
  • Key-in Buzzer
  • Seatbelt indicator only (Cluster)
  • Trunk Pop Relay
  • Power Locks
  • Door Ajar Sensors
  • Door Keyless entry pad
  • Remote Keyless Entry
  • One Touch Down (power window)
  • Air Bag Tone
  • Anti Theft (perimeter Alarm) (SEL, or SE(s) with mods)
  • Lift gate ajar (wagon)
  • Liftgate Pop
  • Accessory Delay signal (accessory that work after engine off, prior to door ajar)
  • Battery Saver Relay signal (accessory that work after engine off, 15 mins) Map lights, vanity mirrors

They are located behind the radio in the dash and they are $$$ about 600 USD.

Jan 27, 2014 | 2008 Ford Explorer

1 Answer

2011 chevy cruze engine running doors locked


not on these new cars.. its a child safety thing..may want to get a second key made..

Jan 05, 2014 | 2011 Chevrolet Cruze

1 Answer

Hi, I have a A4 Audi 1995. The problem is that when I unlock the car from the driver's door, the other doors remain closed and so I have to close the driver's door in order to unlock all the doors.What i...


These are run by vacuum if I am not mistaken. My first step would be to locate the vacuum junction, and be sure each branch of the vacuum sysem was sound. If you need help with this, contact me and we'll try to walk through it together. One question, did you by any chance have someone open your driver's door with a slim jim, or something like that. I've seen that cause this problem more than once. If so, remove your dr. door interior panel. It may be as simple as reattaching a vacuum line.

Mar 09, 2011 | 1996 Audi A4

2 Answers

NEED A WAY TO DISARM THE SECURITY ALARM


ive had this happen changing batteries on grand cherokees-close the doors and with the door key lock and unlock the drivers side door with only the key.then try seeing if the security lite goes out and start the car. sometimes this doesnt work on dr. side and you have to do the same on passenger door. this is for the factory alarm.

Aug 31, 2009 | 1993 Jeep Grand Cherokee

1 Answer

I have a 1996 volvo 850 4 dr. The power doors


Its your switch then. There is just a switch that closes the connection when you push down. after time that can wear down and not work. May be wiring but most likely the switch.

Jul 21, 2009 | Volvo 850 Cars & Trucks

Not finding what you are looking for?
2003 Honda Accord Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...