Question about 1991 Chevrolet S-10 Blazer

1 Answer

I have a 1991 s10 chevy blazer. it is a 2wheel drive six cylinder. when i start it up it sounds like it is out of gas or that the gas is not getting to the engine. i have used a carberator cleaner on it but no luck. i need to know where to go from here.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

I would try with ur fuel filter next "may be clogged" and then to the fuel pump and it just might be time to get ur carb adjusted.

Posted on Nov 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause my 91 s10 to flood out?


It could be the throttle body itself that is worn out. There is something called the throttle positioning sensor that regulates how much gas is dumped into the motor for six cylinders to run on either at idle or going down the road. I had the same issue with my 90 blazer that died on me on the road and would not start because it was flooded.

Oct 21, 2011 | 1991 Chevrolet S-10

3 Answers

1991 Chevy S10 Blazer 4.3 4x4


4170636.jpgThis is all I've got.Hope this helps?

Dec 20, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

1991 chevy S10 blazer fluctuating oil pressure


I assume from the year it has high mileage. With mileage comes wear in these engine's bearings allowing oil pressure to drop because of the excess clearance between cam and bearings, also the crank and bearings. When the engine is hot and idling the oil is thinner and goes by the bearings quicker. If you have good oil pressure while driving, I'd leave it alone, maybe use a thicker oil or some lucas additive. My 89 does the same thing sometimes in the summer, but don't remember it doing it this summer. I use Mobil-1 and an AC Delco filter.

Oct 17, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

1991 S10 blazer 4x4 4.3 popping coming from the front


the popping sound is the stabilizer links or the lower control arm bushings you can replace all bushings and both link kits for around 50.00 and the light is prob from the sensor on the transfer case or the front end i would remove and clean with dawn dishwashing liquid and put them back.

Jun 23, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

Bent A-Arm on a 1991 Chevy S10 Blazer...repair$???


I would guess $500 - $1500 to do this job depending on how much damage was done when the arm was bent.

"SMALL OIL AND TRANSMISSION LEAK AND THE RADIATOR LEAKS OUT SLOWLY." -- the radiator leak could get bad enough to require repair.

I think $400 obo is an okay price, can't get much lower for a vehicle that will get you to the store and back.

May 27, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

Need the fuse diagran fo chevy blazer s10 4wd 1991


go to autozone.com, enter your vehicle specs, and follow the prompts for the repair section, then to electrical diagrams..........and its FREE!

Apr 10, 2009 | 1991 Chevrolet S-10 Blazer

2 Answers

Problems with my 91 s10 chevy blazer


  1. check for fuel prusser if it going low than 35 psi u have to replace the fuel pump
  2. check for bad crank sensor
  3. make sure the TPS work fine
u need to send it to work shop

Apr 07, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

1986 Chevy s10 won't start


small gas engines 101. gas+air+compression+spark=vrrrrrrroooooommmm
i doubt its a fuse. make sure all cylinder have good spark. try and run some seafoam through the gas tank and i would look at the timing - im not sure how you know the timing didnt skip but that sounds like your problem.

Mar 31, 2009 | 1986 Chevrolet S-10 Blazer

1 Answer

91 chevy s10 junk


did you try changing the fuel filter or scanning for codes? This would be a great place to start.

Mar 12, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

My 1991 chevy s-10


when i start my 91 s10 blazer it try to stall so i have to give it gas to keep it running then when i leave out of the drive way and go down the road it has problem get the right amountof gas to go but once it hit 60 -70 mile an hour its fine

Dec 31, 2008 | 1991 Chevrolet S-10 Blazer

Not finding what you are looking for?
1991 Chevrolet S-10 Blazer Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...