Question about 1996 Chevrolet Tahoe

1 Answer

My transmission is only workin on 2 gears could this be a sensor gone

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 97 Answers

Check Transmission Solonoid, Selectors

Posted on Nov 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can a bad knock sensor cause a tranny to go stay in 2nd gear(limp mode)on a 2008 dodge ram 3.7 liter.Got 2 codes a #2 knock sensor and tcm power low voltage


The transmission is in limp-in mode because of the second DTC - TCM (transmission control module) low voltage. The knock sensor code has nothing to do with that. You need to have the TCM and transmission checked out.

Oct 15, 2016 | Dodge Cars & Trucks

1 Answer

My 2004 nissan maxima shiff gear has stuck


Brake pedal sensor to transmission has gone bad, or transmission is bad.

Apr 13, 2014 | Nissan Maxima Cars & Trucks

1 Answer

My Automatic 2.0 petrol Trajet keeps sticking in 3rd gear when i rest/park car for a while the problem is gone then the cycle repeats,I changed crank shaft sensor this week but no good????


It is not surprizing that replacing the crankshaft position sensor did not fix your transmission shifting problem. The cranshaft position sensor is used for fuel and ignition control for the engine - it has absolutely NOTHING to do with the transmission.
i would recommend getting your transmission problem properly diagnosed by a professional that understands how your vehicle works.

May 19, 2012 | Cars & Trucks

2 Answers

Po720 code and po733 code plus leaking oil


P0720-OUTPUT SPEED SENSOR ERROR

WHEN MONITORED
The transmission gear ratio is monitored continuously while the transmission is in gear.

SET CONDITION
If there is an excessive change in output RPM in any gear. This DTC can take up to five minutes of problem identification before illuminating the M.I.L.

POSSIBLE CAUSES[*]Output speed sensor signal circuit open[*]Speed sensor ground circuit open[*]Output speed sensor signal circuit short to ground[*]Speed sensor ground circuit short to ground[*]Output speed sensor signal circuit short to voltage[*]Speed sensor ground circuit short to voltage[*]Output speed sensor[*Powertrain Control Module (PCM)[*]Intermittent wiring and connectorsi cen get you a full flow chart on how to check it out if you wish

p0733 Gear 3 Incorrect ratio

Jan 03, 2011 | Chrysler Voyager Cars & Trucks

2 Answers

Speedometer is not workin


Get the VSS checked. The most common problems is the vehicle speed signal sensor, as a result of which the speedometer stops working. If you notice problems in gear transmission or find the 'check engine' light on, it is because of a faulty speed signal sensor.Get it checked.

Nov 14, 2010 | 1995 Nissan Sentra

1 Answer

Auto transmission


system needs flushed out with kero/ diesal but dont drive to far aprox 1/2 km hope this helps

Aug 25, 2009 | 2004 Ford Explorer

2 Answers

2002 hyundai santa fe transmission will not engage


You might have lost your lower gears, I would have someone look at it to see if your gears are gone or if its just a faulty sensor.

Jun 15, 2009 | 2002 Hyundai Santa Fe

3 Answers

Transmission is not shifting correctly. Started problem when speedodmeter quit working nad acts like it is not shifting down into lower gears when slowing down or stopping. Problem was intermittent at...


most likely you would have to replace or rebulid ur transmission pending on the year and how many miles the car has.. is the check engine light on??

Sep 25, 2008 | 2000 Pontiac Grand Prix

1 Answer

Transmission problems


sorry the trannys gone DOA
check you options

Jul 08, 2008 | 1999 Ford Windstar

Not finding what you are looking for?
1996 Chevrolet Tahoe Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...