Question about 2002 GMC Envoy

1 Answer

Blower motor will not work and when it does it will not shut off. Could it be the relay switch

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,608 Answers

It is your blower motor resistor.It is located on the passengers side under the dash.The resistor is next to the blower motor.There will be a 2 wire connector going to blower motor to the resistor.This is a common problem on G.M.Vehicles.

Posted on Nov 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

2005 dodge grand caravan blower will not cut off

Relays don't usually stick on. Look at the controller. It can be scanned.

Jan 28, 2015 | 2005 Dodge Caravan

1 Answer

I have a short somewhere on the ignition switch which leads to my blower fan. What should I do?

If the blower motor is just working sometimes,or is shutting off,at times,then coming back on,try this,when the blower is not working,bump the blower motor to see if it comes back on,if it does,replace the blower motor,if not,try looking on the back of the blower select switch to see if there is a burned connection,also replace the blower switch if there is a burned connector,along with the connector replacement.If you find that the connector is burned,the blower is the problem,it is drawing too many amps,even if it works good,and sounds fine,the blower caused the problem,also check the blower relay.

Aug 15, 2010 | 1993 Geo Metro

2 Answers

Blower motor will not shut off, even when car is turned off, removed 30 amp fuse to shut it off

could be a bad switch on dash, a bad switch will not open the circuit causing voltage to constantly be fed to blower motor.

Apr 05, 2010 | 2000 Pontiac Grand Prix

1 Answer

Blower working on top 2 settings but no air comeing from vents


Thanks for using FixYa. The possible causes due to which the blower is not working normally are fuse, blower resistor or a bad blower motor. Test the voltage at the blower with a test light. Please check the motor relay switch fuse under the dashboard. Use a multi meter to measure ohms for continuity. If these are fine, bypass the blower motor relay switch to make sure blower motor is running fine. Motor relay switch is right next to radiator fan relay switch under the hood. Pull out the blower motor relay switch to see 4 female pin holes. Test the relay switch using a 12 volts power source and a multi meter to measure continuity. If fan works after jumping the pin holes, then blower motor is fine but relay switch may be faulty. You may also need to replace the blower motor resistor. If still the problem persists, then you need to replace the blower motor.

Please do rate the solution and revert for further assistance.


Aug 09, 2009 | 1997 Honda Civic

1 Answer

Blower motor does not work at any speed

as you said relay is good,try to check 4 connection of relay,pullout relay,check if there a 12 volts supply,, a 12 volt control by ignition sw.,connection to blower motor, the last connection is to the switch mostly connected to ground.

Feb 15, 2009 | 1999 Dodge Ram 2500 4WD

3 Answers

1990 olds 98 blower motor wont shut off stay on when key is turn off

I would start at the fuse. Does the blower motor turn off when the fuse is pulled? A relay is usually used in this circuit and can sometimes "stick" allowing the blower motor to receive constant power. A quick check to see if it is a wiring problem, switch or the relay its self would be to find the blower fan relay and see if there is another one of the value you can swap with it. If the problem goes away, chances are it is the relay but I always like to take a volt/ amp reading to double check my work. 

Sep 04, 2008 | Oldsmobile Regency Cars & Trucks

Not finding what you are looking for?
2002 GMC Envoy Logo

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

76051 Answers


Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides