Question about 1996 Honda Accord

1 Answer

1996 honda Accord drivers window stuck down - 1996 Honda Accord

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If you here a click when you push the switch up or down, then it could be your window regulator (motor). To change remove door panel, there should be 3 bolts holding regulator to door frame and 2 bolts connecting regulator arm to window.

Posted on Dec 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1996 honda accord drivers window doesn't roll up all the way up


Try opening the door and put on hand on either side of the window with pressure and pull up

Sep 27, 2016 | 1996 Honda Accord

1 Answer

1996 Honda Accord rear crank up window is stuck open.


mike hi open the door agar pull the window winder towords urself not with force just gently the surroundin panal is just clipped together with plastic clips so put ur hand at the edge and pull gently and u will find it will come off easally then use a vice crips to close the window fully and then put wd40 on all the movin parts ok

Dec 24, 2011 | 1996 Honda Accord

1 Answer

Driver's side power window won't work in '96 honda accord. stuck in the down position.


Its most likely a faulty power window motor. They all have individual circuit breakers inside the motor or switch, they aren't on a fuse. They quite often fail in either full up or full down positions, but can stop anywhere. Remove the door panel and locate the 2 wire connector coming from the motor. If you have a test light jumper across both wires (on the vehicle side of connector), while using the switch. It should light up in both directions (bi-directional motor). If the test light only lights in one direction or neither, it is most likely a bad window switch. To verify, jumper 12Volts to one side of the window motor connection and ground the other. The window should move in one direction, revrse the 2 wires the window moves in opposite direction then the motor is good.

Jan 27, 2011 | 1996 Honda Accord

1 Answer

Windows are difficult to crank up in a Honda 1996 accord


The back of the speaker is bigger than the original and its sticking out too much into the door panel and its pushing on the glass and that make its difficult for motor to push glass,speaker is your problem. good luck and thanks for using fix ya

Apr 05, 2010 | 1996 Honda Accord

1 Answer

Power Window Stuck Down On 97 Honda Accord


try going to a junk yard your motor was fine but your controls are not buy the controls and change them hondas do this when the resistance is burned out Junk Yard is the best place to find something simple as this 2 screws 3 plugs basic plug in play deal

Apr 04, 2010 | 1997 Honda Accord

1 Answer

1996 honda accord drivers window doesn't roll up and down well.


need to remove door panel remove window regulator grease regulator and re-install

Feb 07, 2010 | 1996 Honda Accord

1 Answer

How do i fix my 1996 honda accord driver side window? When i roll down the window it falls off the track! they are manual, not power.How do I fix?


If you take the door panel off which there is only 2 to 4 screws holding in on and some clips in the back. pull the window to the top of the door and tape in place pull the track up and line track up with the window fully up and make sure to tighten track bolts on both the window and door bolts. hope that helps

Dec 10, 2009 | 1996 Honda Accord

1 Answer

Honda accord lx 1996 6 transmission dipstick


For the V-6 model, the dipstick is located down low on the transaxle, on the drivers side of the car, if it is low, usually 1 pint of of fluid is needed to raise from low notch to high notch. also if it appears to be dark or burnt, smells burnt, you should replace the tranaxle fluid. Good Luck!

Aug 10, 2009 | 1996 Honda Accord

2 Answers

1996 honda accord


check the gear inside, that attached to the motor window it got wearoff just replace it with same ratio nd size.

Aug 16, 2008 | 1996 Honda Accord

Not finding what you are looking for?
1996 Honda Accord Logo

697 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...