Question about 1995 Jaguar XJ6

Open Question

How do I remove the broken side mirror glass and replace the mirror glass on a jaguar xj6 (xj40)

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 34 Answers

SOURCE: how do i remove and replace the driver's side mirror?

you will have to remove the entire door panel to be able to get to the mirror bracket.

Posted on Oct 26, 2008


SOURCE: Broken Driver Side Mirror (glass and motor only)

you must brake the mirror glass on your old one and pull it out in order to put the new one in!! 

good luck

Posted on Nov 04, 2008

  • 1 Answer

SOURCE: How do you remove just glass from drivers side mirror?

I posted earlier that I was facing this same problem and found a sight that said you needed to heat the mirror before you start digging. Got a blow driver and a flat head screwdriver and started prying and the pieces started coming out. Took a bit of effort, but the blow dryer was the key.

One thing, my mirror has the turn signal dots and I believe is also heated. When you start prying out the glass, the glass sits on a black rubber-like backing and that is glued to a thin mettalic looking sheet which has metallic leaders running through it. This is then glued to the backing plate. My guess is these metallic "runners" are the heating elements. You don't want to scrape that up. You want the mirror with the black backing and don't scrape the thin metallic sheet. The blow dryer is again key in getting that to detach.

My vehicle is a late model Yukon and everyone probably won't have this problem.

Posted on Dec 19, 2008

  • 23 Answers

SOURCE: Changing Door Mirror Glass XJ6(X300)

just clips into place use wd40 and be very carefull

Posted on Feb 25, 2009

  • 1986 Answers

SOURCE: remove passenger side mirror

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the blower located on 1994 jaguar xj6 vdp

is your car a xj40 model? and you mean heater/climate motors. if so it has 2 blower motors 1 each side behind the dash, what is the actual problem?

Jul 28, 2016 | Jaguar Cars & Trucks

1 Answer

How do i remove rear seats on 1995 jaguar xj6 vanden plas

remove the rear heel board covers, locate one scew on either side holding seat cushion remove cushion disconnect wiring connectors if it has heated seats, locate 2 screws holding seat back at lower end, the seat back then lifts upwards,,note depending on vin, number there may be 2 upper fixings for seat back located in the trunk behind trim panel. hope this helps. i presume this is a XJ40 model and not a X300, however the removal procedure is similar.

Dec 16, 2014 | 1995 Jaguar XJ6

1 Answer

Is it difficult to replace a heater core on a 1995 Jaguar xj6?...or does it need to be taken to a mechanic?

if its a rhd. xj40, its easy. remove lh lower dash liner 4 screws, remove glovebox more screws. drain out some coolant if you want to avoid a wet footwell ! you will see 2 pipes held in by allen screws i think, remove pipes, remove plastic cover remove heater core make sure to renew o ring seals. if its a x300 its dash out,

Aug 20, 2013 | 1995 Jaguar XJ6

2 Answers

I have a 91 vanden plas. what body style is this car .is it a xj6

the only vandeb plas i can find listed is indeed an xj6.

Dec 22, 2010 | 1991 Jaguar XJ6

1 Answer

How do i open the fuel filler lid on trunk for XJ40 1989

Its in the trunk under the fuel filler. a small plastic handle. pull it towards you.

Jun 30, 2009 | 1994 Jaguar XJ6

2 Answers

1990 Jaguar XJ40 3.6, where is the fuel filter located?

The fuel filter is located under the car, in front and in a little, from the L/H rear wheel.

Undo the 2 nut connections, and fixing clamp, and its off.

Remember no smoking !

Good luck !

A FixYa rating would be nice... Thanks !


Feb 10, 2009 | 1990 Jaguar XJ6

1 Answer

Changing Door Mirror Glass XJ6(X300)


You need to put on a pair of gloves, and safety glasses. (Safety First !)
Prise off the broken mirror from the plastic base that it is stuck too.
Give the plastic a clean with nail polish remover or similar.
Peel off the backing on new mirror glass, and carefully stick it on.

Good Luck !

Don´t forget to FixYa Rate Me Please !


Feb 05, 2009 | 1998 Jaguar XK8

1 Answer

1997 Jaguar mirrors

Steve if it just the glass, pull the outer edge of the glass towards you and then remove D 

Dec 24, 2008 | 1997 Jaguar XJ6

1 Answer

Door mirror glass

glue it in with some araldite

Oct 12, 2008 | 1995 Jaguar XJ6

1 Answer

Changing Door Mirror Glass XJ6(X300)

just clips into place use wd40 and be very carefull

Oct 07, 2008 | 1995 Jaguar XJ6

Not finding what you are looking for?
1995 Jaguar XJ6 Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

80637 Answers


Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides