Question about 2003 Suzuki Aerio

1 Answer

The car was drove through water and now will not start it clicks to turn over but nothing happens the car is a suzuki aero 2003 2.0 2wd

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 560 Answers

Do not try starting this car, it could be hydro-siezed, you need a technician to look at it for you.

Posted on Nov 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Motor turning over will not start


check fuel pressure and flow , if pressure is low check pressure relief valve, if ok pump faulty, if flow low replace fuel filter, if fuel pressure goes to zero when switched off , check fuel pump return valve.

Mar 03, 2016 | Cars & Trucks

1 Answer

Changed ignition barrel on suzuki ignis 01 now.it will only start by bumping it once started there is no warning lights on and it drive fine you try start with key it clicks or does nothing


Why did you change the ignition cylinder? Sounds as if the ignition switch is not working properly. This switch is usually attached to the back side of the ignition cylinder and the barrel portion of the cylinder turns the switch. You can remove the switch from the cylinder and insert a screwdriver into the switch and turn it manually. If nothing happens when the switch is turned, it could be defective

Dec 18, 2015 | Suzuki Cars & Trucks

2 Answers

Changed transmission fluid on crv now car wont start


might be that you accidentally disconnected the crank sensor close to the transmission, this gives a no start condition without a check engine light on most cars...

Apr 19, 2014 | 2005 Honda CR-V

1 Answer

I drove my kia optima in a deep puddle and now it won't start it makes one clicking sound and nothing happens the starter is good but water did get into the intake and water did get past the butter fly...


Did you crank the engine with the spark plugs out in order to discharge any water that may be trapped in the combustion chambers? Water cannot be compressed. Hope you didn't hydrolock it.

Nov 02, 2013 | Cars & Trucks

1 Answer

2003 Suzuki Aerio won't start. New battery. Turn key, nothing happens (no clicking or turnover at all). All other electrical seem fine.


Sounds like a starter to me. Pull it and take it to parts house for bench test. Do not replace unless they say it is bad.

May 11, 2011 | Suzuki Aerio SX Cars & Trucks

1 Answer

2000 Olds intrigue: When i turn the key nothing happened. All the lights came on (like they would if it normally started). There was no clicking noise - nothing. I tried shifting the car from park...


if an ignition switch fails, sometimes you can jiggle the key and it will start right up. its very hard to tell. but if you can start it by bypassing the ignition switch, then its the switch itself. go to this site for more detailed info--- aa1car.com/library/1999/cm119948.htm---this page should help. click on top link.

Dec 22, 2010 | 2000 Oldsmobile Intrigue

1 Answer

9-3 Aero 2002 won't start


How bad was the damage and where? Do you ahve any power at all?

Aug 03, 2009 | Saab 900 Cars & Trucks

1 Answer

WON'T START


my 2006 pt cruiser won"t start. the light do come on but it will not turn over just a clicking sound. i drove it for about an hour then went back to it 30 mins later and it didn"t start. just clicking sound.

Sep 21, 2008 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2003 Suzuki Aerio Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...