Question about 1991 Honda Accord

1 Answer

Where is the ignition module located at on a 1991

Where is the ignition module located at on a 1991 honda accord

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

The ignition module is located inside the distributor below where the rotor is, it is held down with two or three screws to the distributor plate. There are two components in there the coil pick up is the device that picks up a signal from the distributor shaft, the other component is the ign. module.

Posted on Nov 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ignition control module located on a 1992 honda accord-dx?


Ignition control module, is not the same as an ECM, it is termed an "igniter" and is located in the distributor, as part of the reluctor wheel pickup and ignition module.
Generally the entire distributor is replaced as a unit for ease and typical distributor bearing issues.

May 26, 2014 | 1992 Honda Accord

2 Answers

1991 honda accord will not start, it's getting fuel and spark but will not start


Could be a weak coil or bad ignition module located in the distributor. I would replace the coil if you have not ever done so then the ignition module. The coils last about 150k miles and then can go anytime after that. I've owned four 90's Hondas and they have all had this problem. If neither of those things work then you may have a bad distributor.

Mar 07, 2014 | 1991 Honda Accord

1 Answer

Remving ignition control modole on 1991 honda accord


It's located inside the distributor. You'll have to remove the dist. cap and the metal plate below, to gain access to remove the ignition module.

Mar 13, 2011 | Honda Accord Cars & Trucks

1 Answer

Where is the brake or tail light module located on the 1991 honda accord?


It's located inside the piece of taillight that's mounted on the drivers side trunk lid.

Feb 15, 2011 | 1991 Honda Accord

2 Answers

I have no spark in my 1987 honda accord i replaced the coil and distributor all main fuses are good and the fuses are good as well where is my main ignition relay located ? or is that the problem


there is no relay. test the coil circuit by turning the key on and momentarily grounding the negative terminal to see if the coil will release a spark. If yes, suspect your ignition module is bad. If no, suspect your ignition switch or wire is bad.

9a3082e.gif

Oct 09, 2010 | 1991 Honda Accord

1 Answer

I have a 1999 honda accord 3.0 vtec my car dies after it warms up and wont start back up untill it cools down


Ignition control module! It is located inside the distributor. I have a 1991 honda accord and honda had a recall on the control module. get your vin # nand call your local honda dealership and see if '99 had a recall too they will replace it free, if not mine cost $60

Jul 05, 2010 | 1999 Honda Accord

1 Answer

1991 Honda Accord -- was driving it when engine suddenly stopped running -- there is power to the coil but no spark -- replaced distributor cap with new one -- still no spark


Tried replacing the ignition module with two different ones from a salvage yard. (Most of the distributors in the salvage yard were either missing completely or the ignition module had been removed - must be a very common problem.) Neither one worked.

Purchased a used complete distributor assembly w/warrantee and replaced the one that did not work. Car started immediately.

Suggestion: If one cannot wait for delivery of a new distributor as I could not, (I located one on line for $126.00 w/warrantee) purchase one from a salvage yard w/warrantee, then get a new one if you are going to be concerned about the longevity of the replacement distributor.

Nov 01, 2009 | 1991 Honda Accord

1 Answer

Brake Light Control Module


91 Honda Accord has 2 separate tail lights on each side(total of 4 pieces). My problem stemmed from a faulty control module on the right hand side(passenger side). The module in question is located inside the smaller of the 2 tail light sections. In order to change the module you have to remove the tail light. There are 4 nuts holding in the taillight section and 2 phillips head screws holding the module in. The module on this side is 6 pin plug in. The one on the drivers side is a 5 pin plug in. Whole effort takes about 45 minutes. It is strictly plug and play.

Feb 05, 2009 | 1991 Honda Accord

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

432 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...