Question about 2003 Toyota Tundra

Open Question

Radio Removal - 2003 Toyota Tundra

I am looking for instructions and photos showing how to remove the radio from a 2003 Toyota Tundra .

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Quans
  • 1 Answer

SOURCE: 2005 town and country factory stereo removal

It's actually not too hard when you figure everything out. I just installed an aftermarket stereo and couldn't get any sound until I stumbled across a solution on this site. First you need to get the correct wire harness which I bought on ebay for $1.99. Then you need to get the install kit. I got mine at Radio Shack for $10.00 cause they're going out of business. You can get it at Best Buy too or any other car stereo place. To get the old stereo out. Take out the cup holder. There is a button on the top rear of it that releases it. Then remove the 2 screws at the bottom. Gently pull the entire trim that surrounds the stereo, cd changer and ac controls. You will now have access to removing the stereo. It's very easy after that. After you connect the wire harness and install the new stereo you need to run a wire from the red ACC wire on the stereo to the NBS relay in the fuse box under the hood. That's it! Good luck. Sorry I have no pictures.

Posted on Feb 22, 2009

Ad
  • 1 Answer

SOURCE: car radio removal

This isn't hard, you just need to breath deeply and take courage.

Be aware that the centre moulding where the radio is extends ove the steering wheel and the whole thing needs to come out. There are screws under the switches that release this panel and the panel under the wheel. Remove them all. Note the cables for the instrument lights and speaker.

Note the grommet around the ignition switch. You have to work this with a screwdriver so the top panel can come forward. This grommet will pull off but I bet you can't do it before the panel comes off. Do it before you put it back.

The panel is click-fit into the centre console. You can lever it off with a paint scraper. Note the lighter wiring.

Once the panel is off the radio is held in by 4xcrosshead screws, just looking at you.

Needless to say, the brackets are exclusively Toyota and fitting a new third party radio is not so easy. Your best bet for a replacement is a good one out of a wreck of the same vintage. It will go straight in and plug up. I got a Camry one. It has security coding but fortunately it was never activated. If the radio is coded make sure you get the full details and provenance. You may need to get it reset by the dealer.

Good luck

Posted on Mar 02, 2009

  • 6 Answers

SOURCE: radio, cigarette lighter, clock display went out

Under the hood there is some. Not sure about your application, but it might control interior stuff too. It will be a bigger amperage than normally inside the car though

Posted on May 20, 2009

  • 12 Answers

SOURCE: need instructions on how to remove my 2005 toyota corolla radio

Tools required: Phillips screwdriver, small flatblade screwdriver, rachet with 6 inch extension & 10mm socket.
1. Remove negative battery terminal (for stray voltage & airbags.)
2. Remove gear shift trim
3. Remove cable attached to lighter socket.
4. Remove center climate control knob and screw beneath it.
5. Gently pry both bottom corners of climate control face (up then towards the rear) until clear of lock.
6. Pull entire climate control console rearward until clips release. Leave all wiring attached.
7. Remove 4 bolts under radio (10mm.)
8. Gently pry between dash and AC ducting panel (both sides) and pull out.
9. 4 clip hold radio to ducting panel, gently pry while pulling radio out the back.
The rest should be easy...
9. 4 clips hols radio to

Posted on Aug 15, 2009

  • 1861 Answers

SOURCE: toyota tundra 2008 removal radio

There is a hidden screw under the center knob on the heater control. Remove this, and the other 2 srews hidden in the corners of the air registers.

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My mom has a 2003 Toyota Tundra the radio clocks and the charger outlets all went out at the same time can it be a fuse


YES,CHECK THE FUSE BOX AT DRIVER SIDE,DID YOU PUT A RADAR DETECTOR IN THE LIGHTER,IF SO,THEN THE FUSE BLEW,HAPPENED TO MY 2004 TUNDRA.THE LIGHTER OUTLET IS FOR LIGHTER ONLY.

Mar 09, 2015 | 2003 Toyota Tundra

1 Answer

2003 Toyota Tundra upper ball joint replacement


Hi Jason,here's a link on replacing your ball joint,join their site,it's free,then you can use their repair guides like me. GET 25 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS Here's a video that may help too. Ball Joint Removal Separator Toyota Tundra Tie Rods

Feb 10, 2015 | 2003 Toyota Tundra

1 Answer

Starter relay location


hi... on toyota cars the radio and charger socket are on the same fuse . try that one. god luck

Mar 02, 2014 | Toyota Tundra Cars & Trucks

1 Answer

My radio is loosing preset after turning off ignition. 2002 tundra


If you just installed the radio its possible the power wire for the radio memory and clock is not hooked up to a constant hot 12v source. Also if all wiring is correct its possible there a bad connection or contact check connecters.
I had the first problem with a JVC radio I installed once it did not have clear instructions on the always 12v hot wires.

Dec 24, 2010 | 2002 Toyota Tundra

1 Answer

I'm looking for the indash clock wire connection for my 2000 Toyota 4Runner. I would prefer a photo. I was working on my aftermarket radio CD player and reinstalled it. The clock was working before that.


There is 1 fuse for the clock: If your audio system is working then that fuse is OK (instrument panel 18 15 amp fuse). Check it out just to be safe, you never know. If the fuse is OK then the clock itself has gone bad. I've heard of this happening after radio installs, no idea why. Anyway, I have clock removal instructions at www.autoclockrepair.com. I also offer a very affordable repair service with a lifetime guarantee.

Jun 05, 2010 | 2000 Toyota 4Runner

1 Answer

Toyota tundra 2008 removal radio help


There is a hidden screw under the center knob on the heater control. Remove this, and the other 2 srews hidden in the corners of the air registers.

Oct 08, 2009 | 2008 Toyota Tundra

1 Answer

Radio, cigarette lighter, clock display went out on my '03 Toyota tundra. 20 amp radio fuse looks ok. Are there any other fuses I should check out? Thanks. TD


Under the hood there is some. Not sure about your application, but it might control interior stuff too. It will be a bigger amperage than normally inside the car though

May 20, 2009 | 2003 Toyota Tundra

1 Answer

Take out dash(tundra) for antenna installation


You could do an antenna installation without removing the dash. Take out the center assembly with the radio and hvac controls and the glove box. You'll have enough access to run the antenna wire from its stock location to the radio.

Mar 31, 2009 | 2004 Toyota Tundra

2 Answers

Radio will not iluminate at night


U will need to pull the radio out of the dash and remove the top cover of the radio chassis, under that cover there is a tiny light bulb in a little socket that twists into the back of the dial display, the bulb looks like a miniature peanut, this is the back light for the radio display, u can buy the bulb at any full service parts store or at the dealer, about $1

Jan 05, 2009 | 2003 Toyota Tundra

Not finding what you are looking for?
2003 Toyota Tundra Logo

Related Topics:

570 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...