Question about 1999 Pontiac Grand Am GT

1 Answer

I have a 1999 grand am se. it is shooting oil out off the motor over top the starter and i cant find it. it only shoots oil out when running to. i took the stater off and cant find and holes or loose bolts.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,627 Answers

Check and see if the last filter you replaced had a o ring on it,i think you have a doubled up filter"
o"ring.

Posted on Nov 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 pontiac grand am se 3.1 is dumping oil over the starter.


If the oil is on the nose of the starter that is inside the bell housing, then it could be the rear main seal. You would have to have the engine or transmission removed to replace the seal.

Oct 04, 2012 | Pontiac Grand Am Cars & Trucks

2 Answers

(1999 pontiac grand prix 3100 v6) any tips or very important things that I need to know before changing my oil (mobil 1 full synthetic) and oil filter (ac delco professional)?


Make sure the engine is cool before you try, nothing worse then being under a car with hot oil running down your arm. Make sure you rub the o ring on the new filter with clean oil to make installation easier and provide a better seal. Helps to have the front end lifted, gives you more room and helps drain out more dirty oil. Its not too bad once you've done it once, you'll do fine. Oh one last thing, when you first pull the drain plug off the oil will shoot a good 4-6 inches out so have the pan set with plenty of room.

Jun 08, 2011 | 1999 Pontiac Grand Prix

1 Answer

How do you change the starter in a 1999 dodge status 2.4l


My solution may not be exact so dont shoot the messenger. All starters have to engage the flywheel to kick the motor over. Find where the motor meets the transmission bell housing. Either on the front side of the transmission or the backside is where the starter will be.

After you find the starter location: Disconnect battery, find the easiest way to get to the starter (top or bottom of engine bay), remove anything that may make your job harder on you. Now that you have good access to the starter; remove the two or three wires that are attached to the backside of the starter. When all wires are free from the starter, you can now remove the bolts that hold it into the tranny bell housing. Be careful when you take these out cause the starter may fall to the ground or where ever.

Good luck, I hope this helps, happy wrenching

Mar 08, 2011 | 1999 Dodge Stratus

1 Answer

My oil guage shoots up to 80 and stays there when i start my 1999 jeep grand cherokee


Great oil pressure, wish I had that much. anyway it's probably the sending unit. my son's car shoots up to 110. i figuare as long as it goes up you have pressure. it's when it stops start to worry

Jun 20, 2010 | 1999 Jeep Grand Cherokee

1 Answer

Compressor is shooting out oil on backside and makinf a popping noise


your compressor needs immediate overhauling to change the gasket kits and O rings, the shooting oil is your compressor capella oil.

Apr 14, 2010 | 1999 Dodge Durango

1 Answer

COOLANT LEAK - MID -ENGINE 2.4L 99 GRAND AM SE


check the upper rad hose to engine there is a plastic housing with a seal replace it

Oct 05, 2009 | 1999 Pontiac Grand Am GT

1 Answer

1999 pontiac grand am 4dr. se. change oil light problem


seems like your oil pressure switch gave up, its located on the side of the oil filter, you can take it out and test with a amp meter. it should cost you less than 20 bucks to buy something like that.

Jul 20, 2009 | 1999 Pontiac Grand Am GT

1 Answer

1995 grand prix se


the starter could be shot, try having someone tap on it with a hammer or breaker bar while you turn the ignition. if it starts then you know you need to replace the starter. if not message me back and i'll be more than happy to help you trouble shoot the problem further

Dec 14, 2008 | 1995 Pontiac Grand Prix

1 Answer

Starter problems


starter is done replace it it is located on the front of motor down bt the oil pan

Dec 08, 2008 | 1999 Plymouth Grand Voyager

1 Answer

Starter?


the starter is on the side of the motor toward the front of the car. toward the bottom by the oil pan.

Jul 21, 2008 | 1999 Pontiac Grand Am GT

Not finding what you are looking for?
1999 Pontiac Grand Am GT Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...