Question about Ford F-450

1 Answer

I am working on 95 ford truck f 700 no spark from coil so changed the coil still nothing and 11 volts going in have any ideas?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,168 Answers

Hello.
The most common no spark problem on these trucks is the ignition module.
These are mounted on the distributor with 2 small bolts. You may need to turn the distributor to access the bolts if yours is a V8. So you may need to reset your timing afterwards.If you do not have a timing light very carefully mark the position of the distributor first.
You only need to loosen the bolt at the base of the distributor to allow it to turn.
If the module doesn't cure the problem you may need to replace the pickup coil inside the distributor itself. This will entail distributor disassembly to replace.

Posted on Nov 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 47 n8 ford tractor that cranks but won't start. Its getting compression and fuel but no spark. Spark plugs are new. Any suggestions before i go replacing parts?


First check points for corrosion and replace condenser if it has been sitting a while. Test for voltage at the coil small lead coming from the ignition switch. If you have done this all, the coil may be bad, and while you can test it with an ohm meter, this test is not perfect so you may want to either replace it or substitute a known good unit. CAUTION! six volt coils are different from 12 volt coils AND there are two different types of 12 volt coils--internal and external resistor coils. Most folks convert these old tractors to 12 volts, but to do so requires several changes besides the coils. More details on request.

Jul 03, 2016 | Ford Cars & Trucks

1 Answer

Wont start


Is it not getting spark, or not getting fuel thru the injectors ?
If its no spark, its usually the ignition module or the pickup in the distributor. You might also check for power at the coil from the EEC relay.

Aug 09, 2013 | 1995 Ford F350

1 Answer

2.7 l engine installed, no spark, there is 2.2 volts at the coil is that enough? Will a bad map sensor create a no spark condition? 3 different codes showed on the code scanner - P0700, P0562 and P0113


The coil needs battery voltage ( 12+ ) to function.
A faulty map sensor would not affect the ignition system unless it shorted out the computer.
Code 700 is for a problem with the transmission module.
Code 562 is for the charging system being below 11 volts.
Code 113 is for a problem with the intake air temp sensor circuit.

Dec 11, 2012 | 2004 Chrysler Sebring

1 Answer

97 pontiac firebird 5.7L HAS NO spark from optispark but has spark from coil


This engine uses a special flat cap and a standard rotor, right ? The spark comes into the cap and thru the rotor, then to the spark plugs.
Have you replaced the rotor ?
The spark can jump thru the rotor and ground thru the dist. shaft.
Depending on where you are testing for spark, the coil could also be weak and not pushing the spark to the plugs.

Jun 23, 2012 | Cars & Trucks

1 Answer

2001 Expedition - check engine light came on. Oil change on 1/27/11 not due for another 1000 miles. It just started to tremble and is running rough.


your oil change has nothing to do with your check engine light. probably needs spark plugs and a coil or 2

Mar 29, 2011 | 2001 Ford Expedition

2 Answers

1993 ford tarus 3.0 engine had weak spark after changed coil fired a couple of times know no spark? any ideas


Using a volt meter disconnect the electrical plug to coil and check with key on to be sure there is at least 12 volt to coils. if not or voltage is low the ignition switch may be bad, have an assistant jiggle the key in ignition while you are looking at the meter to note voltage fluctuations if any are noted ign. switch is bad also check all fuses under dash as wellas in engine compartment.

Oct 29, 2010 | 1993 Ford Taurus

1 Answer

Replaced coil, wires and spark plugs, and after 700 miles the number 3 cylinder is misfiring, according to the code. I replaced the coil, wires and spark plugs (warranty on parts) again and nothing...


I would first look at removing the injector on three and taking a look at it and give a thorough back flush. How does the spark plug on three look compared to any of the others, does it look hot (glazed) or sooty black. The former is too lean (perhaps a partially blocked injector) or the latter too rich (perhaps a leaky or split injector)

Jun 01, 2010 | 2003 Ford Focus

2 Answers

Just finished 12 volt conversion on 49 V8 flathead. Starter engages but engine won't start. Appears to be getting fuel.


You might not have spark as the 12 volts needs a ballast resistor or the points burn out preytty quick. 8 volts at the coil in run with the points open and 0 with the points clsed and battery voltage at the coil when cranking. coil wire near the intake manifold while cranking should jump at least 2 inches. Closed points should be 0 volts at the neg on the coil. pos and neg should be the same 12 volts with the points open. if not either the coil or the points are bad. The condenser can fail and no spark with all the rest right

Oct 12, 2009 | 1991 Plymouth Colt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...