Question about 1992 Pontiac Trans Sport

1 Answer

Van will not start right away i have to turn it over for at least 1 min before it will start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 580 Answers

You may need to change the fuel & air filters first to see if this helps. Also if you havn't changed the plugs & wires recently do so. The fuel pump could be loosing pressure also. Good luck, try filters first. If this helps, please recommend this advice. Thanks

Posted on Nov 17, 2009

  • eric r barnes Nov 17, 2009

    You may need to change the fuel & air filters first to see if this helps. Also if you havn't changed the plugs & wires recently do so. The fuel pump could be loosing pressure also. Good luck, try filters first. If this helps, please recommend this advice. Thanks

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My van won't start after driving a short distance, it will start again after 3 to 5 minutes but then will act like it's going to stall while I'm driving. What's wrong?


Hi Greg, I'm AL the owner of Big As Auto Repair in St Charles Mo

Greg, I read your complete message, but nowhere did I see that you replaced the Cam Sensor. The EGR will cause it to stall at stops but usually will not prevent it from restarting. I would try replacing the Cam Sensor before anything else. If you should need further assistance go to my website by clicking here: Auto Repair

Mar 19, 2015 | 1997 Dodge Caravan

1 Answer

Starts and cuts off


serial number/keygen for registry reviver

Jan 28, 2014 | Cars & Trucks

1 Answer

Van dies after 10 min drive when pulling into


Try removing the idle speed motor on side of throttle body, and spray it clean, as well as the port it came out of, with throttle body spray cleaner. Don't pull and extend shaft of idle motor, just leave it in position it's in, and make sure you don't lose small "O" ring on idle motor. Re-install and try it. If it cures it for a while, then starts to do it again, replace the idle speed motor.

Apr 03, 2010 | 1995 Plymouth Voyager

1 Answer

Van took a few tries to start. Then once off nothing worked.


Might be time for a tune up?

Does your car have a anti-theft system that uses a resistor in the key? I have had several instances when I tried to start the my '95 GM auto, runs perfect normally, but nothing. I traced it back to the key. Probably not always put in correctly.

Thanks for your question at FixYa.com

Jan 18, 2010 | 1996 Chevrolet Astro

2 Answers

Renault master van will not start with the key it turns over ok but will not start but it will start with a tow i leave it running for 5 mins it cuts out again


Renault master van will not start with the key it turns over but will not start it will start if i take earth lead off for 5 mins runs for 5 mins and cuts out again.

Jan 08, 2010 | 2002 Renault Sportwagon

1 Answer

Tail light fuse keeps blowing , doesnt seem to blow it right away when van is cold but blows after it is drivin a few mins and blows right away when changed there after....


chk taillamps for any water intrusion. chk lamp sockets for any corrosion or melting. last chk bulbs and make sure they are right for application. i suspect u have problem with a lamp socket

Nov 15, 2009 | 2004 Nissan Quest

2 Answers

My van squeeks in a turn. Mechanic says bushings


This is usually the control arm bushings it's a fairly expensive repair.

Jul 08, 2009 | 2004 Ford Econoline

2 Answers

Noise in front end when steering wheel is turned


is your van 4WD, AWD, or rear wheel drive? if it is 4WD or AWD, the front axle seals might be going bad. PLEASE RATE MY ANSWER.

Feb 26, 2009 | 1997 Ford Econoline

Not finding what you are looking for?
1992 Pontiac Trans Sport Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...