Question about 1989 Ford F 250

1 Answer

I need a wiring schematic for a 1989 ford f-250 in particular the wire color chart for the ignition switch...and it's location under the dash.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 44 Answers

MY Autozone carries the Chilton or Clymers for this year. The book has the wiring diagram.

Posted on Nov 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ignition switch diagram


Are you referring to the wiring schematic diagram? If so, the link below should help.
1994 1995FordThunderbirdVehicle Wiring Chart and Diagram
If you need to know how to change the actual lock cylinder, see the video linked below.
How do you remove the ignition lock on 1995 Ford Thunderbird

Apr 16, 2014 | 1994 Ford Thunderbird

Tip

ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1996 Honda Civic This...


ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1996 Honda Civic

This FixYa Tip is for the purpose of installing an Alarm, Remote Starter, Cruise Control, and / or Car Stereo into the vehicle listed in the subject line.

The wires listed are the ones you will need to successfully complete the task.

Some vehicles require additional relays and / or modules to bypass factory security. If they are required - it will be in the NOTES section below the wiring colors.

The following FixYa TIP is good for all Honda Civics for the following production years:

1996


STEREO WIRING COLOR CHART:
Constant 12V+: Blue/White
Switched 12V+: Yellow/Red
Ground: Black
Illumination: Red/Black
Dimmer: n/a
Antenna: Driver's Pillar

Front Speakers:
Left Front (+) Blue
Left Front (-) Gray/Black
Right Front (+) Red/Green
Right Front (-) Brown/Black

Rear Speakers:
Left Rear (+) Blue/Yellow
Left Rear (-) Gray/White
Right Rear (+) Red/Yellow
Right Rear (-) Brown/White

NOTES: Retain Keyless entry with secondary Harness Listed Below
Additional Accessories:
Metra Brand Dash Kit: 89-30-7891 - 99-7891 - 99-7898
Metra Brand Wiring Harness: 70-1720 W/Keyless Entry # 70-1720T
Metra Brand Antenna Adapter: n/a




ALARM / REMOTE START WIRING CHART:
Constant 12V+: White - Ignition Switch Harness
Starter: Black/White - Ignition Switch Harness
Ignition: Black/Yellow - Ignition Switch Harness
Ignition 2: Yellow - Ignition Switch Harness
Accessory: White/Black - Ignition Switch Harness
Tach: Blue - Coil
Brake Switch: Green/White - Brake Switch
Trunk Pin: Blue/Black - (-) Driver's Kick Panel
Parking Lights: Red/Black - (+) Driver's Kick Panel
Head Lamp: Red/White (L) Red/Blue (R) - Steering Column
Hood Pin: n/a
Door Trigger: Light Green/Red - (-) Above Fuse Panel
Door Lock: Green/White - (-) 2 pin connector taped to blue connector behind fuse box
Door Unlock: Green/Orange - (-) Module Behind Radio
Horn: Grey - Steering Column or GREEN connector behind radio

NOTES: - none -



CRUISE CONTROL:
Constant 12V+: White - Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+: Black/Yellow - Ignition Switch Harness
Ground: Use Chassis Near Cruise Control Module
Hot Side of Brake: n/a - Brake Switch
Cold Side of Brake: Green/White - Brake Switch
Tach: Blue - Coil
VSS Wire : Blue/White - Driver's Side Dash Footwell, Grey connector.


NOTES: PPM - 4000PPM
ROSTRA Control Arm # 250-3421/250-1483
ROSTRA Throttle Adapter #250-4249

Vehicles with Manual Transmission require Clutch Switch.
Some vehicles may require a speed signal generator and/or other parts/adapters not listed above.
Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

Thanks for using FixYa!! Please see my other tips on GPS, Car Audio, Large Appliances, and more.

on Apr 03, 2010 | Honda Civic Cars & Trucks

Tip

ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1988 - 1991 Honda Civic...


ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1988 - 1991 Honda Civic

This FixYa Tip is for the purpose of installing an Alarm, Remote Starter, Cruise Control, and / or Car Stereo into the vehicle listed in the subject line.

The wires listed are the ones you will need to successfully complete the task.

Some vehicles require additional relays and / or modules to bypass factory security. If they are required - it will be in the NOTES section below the wiring colors.

The following FixYa TIP is good for all Honda Civics for the following production years:
1988
1989
1990
1991


STEREO WIRING COLOR CHART:
Constant 12V+: White/Blue
Switched 12V+: Yellow/Red
Ground: Black
Illumination: Red/Black
Dimmer: n/a
Antenna: Driver's Pillar

Front Speakers:
Left Front (+) Blue/Green
Left Front (-) Gray/Black
Right Front (+) Red/Green
Right Front (-) Brown/Black

Rear Speakers:
Left Rear (+) Blue/Yellow
Left Rear (-) Gray/White
Right Rear (+) Red/Yellow
Right Rear (-) Brown/White

NOTES: - none -
Additional Accessories:
Metra Brand Dash Kit: n/a
Metra Brand Wiring Harness: 70-1720
Metra Brand Antenna Adapter: n/a




ALARM / REMOTE START WIRING CHART:
Constant 12V+: White - Ignition Switch Harness
Starter: Black/White - Ignition Switch Harness
Ignition: Black/Yellow - Ignition Switch Harness
Accessory: Blue/White - Ignition Switch Harness
Tach: Blue - Distributor
Brake Switch: Green/White - Brake Switch
Trunk Pin: Green/Black - (-) Harness from Dash Indicator
Parking Lights: Red/Black - (+) Fuse Panel
Hood Pin: n/a
Factory Disarm: n/a
Door Trigger: Green/Red - (-) Driver's Kick Panel
Door Lock: Green/White - (-) Driver's Door at Door Lock Module
Door Unlock: Green/Red - (-) Driver's Door at Door Lock Module
Horn: Blue/Red - Steering Column (Relay Required)

NOTES: - none -



CRUISE CONTROL:
Constant 12V+: White - Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+: Black/Yellow - Ignition Switch Harness
Ground: Use Chassis Near Cruise Control Module
Hot Side of Brake: n/a - Brake Switch
Cold Side of Brake: Green/White - Brake Switch
Tach: Blue - Distributor
VSS Wire : Yellow/Red - Driver's Side Dash Footwell, 13-pin connector.


NOTES: 4000PPM
Vehicles with Manual Transmission require Clutch Switch.
Some vehicles may require a speed signal generator and/or other parts/adapters not listed above.
Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

Thanks for using FixYa!! Please see my other tips on GPS, Car Audio, Large Appliances, and more.

on Apr 01, 2010 | Honda Civic Cars & Trucks

1 Answer

Need a color code chart to replace ignition harness for my 21997 pontiac firebird.


Gloria, I am sending you a schematic of the ignition switch wiring. If you need something else shoot me an email to lewisk45@aol.com.. Best of Luck to you..


lewisk45_16.png

Aug 28, 2011 | 1997 Pontiac Firebird

1 Answer

My 1989 Ford F-250 keeps trying to start without the key on. I replaced the starter, the solenoid, the ignition switch in the column, found 1 wire that was cracked and taped it, when the battery is hooked...


You still have a bare wire somewhere ... You probably did this already ... I would remove the wire from the ignition switch to the start solenoid and see what happens ...

Good luck on your search ...

Thanks for visiting FixYa.com

Aug 25, 2010 | 1989 Ford F 250

1 Answer

I disconnected and replaced the solenoid on my 1989 Ford F-250 and made the mistake on not labling the wires and now I dont know which one go where can u help?


You'll need a volt tester or a test light. The large wire from the battery should go to the first large lug, the other larger wire goes to the starter goes to the other large lug. There should be one or two smaller wires that fit the large lugs. If there is only one small wire with a large connector it should go on the starter lug. If there are two small wires with large connectors, you'll have to check to see which one powers the car and ingition. Turn the key and have someone watch the dash lights then touch one wire to the wire from the battery, the one that light up the dash lights goes there, the other will most likely go on the other side but not always. There should also be one or two wire with small connectors these are the ignition switch and ignition wires. Once you have the other wires hooked up, have someone try to start the truck the wire that is hot only when they are trying to start the truck goes to the small lug by the battery side of the solenoid, if there is another wire it will go to the other lug.
I know this is a lot. If you need more help respond to this question and I'll be notified by email and I'll try to help you further.

Jun 25, 2010 | 1989 Ford F 250

1 Answer

I need to know how many wires go to a 1989 ford econoline fuel pump with a 460 efi engine


I suggest check this wiring diagrams for code color wires...


1989 5.0L & 5.8L & 7.5L ENGINE SCHEMATICS

2fa9322.gif




1989-91 CHASSIS (GASOLINE)SCHEMATICS

6dd87e2.gif



1989-91 CHASSIS (DIESEL) SCHEMATICS

1887a7c.jpg


Hope this help.

Mar 23, 2010 | 1989 Ford Econoline

1 Answer

My 1989 ecoline 150 starter fires when u connect the batteryreplaced starter solinoid and ignition switch and keyswitch still starts no key and will still run after van starts


look for shorted wires leading from your starter solenoid to your ignition switch.
the wires are shorted "on" before they get to your ignition switch.
separate the burned/shorted wires: (most likely under the dash) then tape them so they don't touch.

Jan 16, 2010 | 1989 Ford Econoline

2 Answers

I have a 1979 ford f-250 My turn signals wont come on


Try replacing the flasher unit (under the dash). Blown fuse?

Jul 12, 2009 | 1982 Ford F 250

1 Answer

89' carolla


Here is the color code chart for your 1989 Corolla: Radio Constant 12V+ Wire: Blue/Yellow
Radio Switched 12V+ Wire: Gray
Radio Ground Wire: Brown
Radio Illumination Wire: Green
Radio Dimmer Wire: N/A
Radio Antenna Trigger Wire: N/A
Radio Amp Trigger Wire: N/A
Front Speakers Size: 4′
Front Speakers Location: Dash
Left Front Speaker Wire (+): Pink
Left Front Speaker Wire (-): Purple
Right Front Speaker Wire (+): Purple
Right Front Speaker Wire (-): Light Green
Rear Speakers Size: 4′
Rear Speakers Location: Rear Deck
Left Rear Speaker Wire (+): Black
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Red
Right Rear Speaker Wire (-): White I hope this is what you need. Please take a few seconds to rate how helpful this post was to you. Thank you and good luck! billyho1977@FixYa

Sep 02, 2008 | 1998 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

731 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...