Question about 1990 Jaguar XJ6

1 Answer

Try to start , but dont turn on - 1990 Jaguar XJ6

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Car is reading code 16 can u help with this

Posted on Feb 18, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car started ran for a bit turned back on. now it turns over and tries to start but dont stay on came out 2 hrs later it started ran start back up n now it dont start again??


run the fault codes and check for electronic failure ---ignition control module , coil/s, ECM crank / cam position sensor
failing when hot

May 01, 2016 | Cars & Trucks

1 Answer

Renault problems megane


try ignition on , dont start engine, press the button on the end of wiper stalk and hold until the speedo and rev needles start sweeping ,wait until they've completed the self test , about 90-120 secs then turn ign off and then start engine and lower roof down then back up

May 03, 2014 | 1999 Renault Megane

1 Answer

Security light flashing on 04 grand am, car want start


okay try this ,put key in ignition turn to on position for ten minutes ,roll window down so you dont lock keys in car before you do this. turn to on for ten minutes dont touch anything or turn anything on make sure all accesories are offthen turn key to off position for 10 seconds then try to start.
its important that you dont have radio or any accessory on during this process.

tw0seven0-fivefivesix-seventhreefiveseven

Dec 24, 2010 | 2004 Pontiac Grand Am

1 Answer

I changed fuel pump and fuel filter. My battery went dead. I took battery out and recharged. Now I'm locked out by my security, Engine won't turn/start. I think I'm locked out by security system.


Turn the car on, dont try to start it, let it set ten minutes, turn it off dont take the key out. do this three times. on the third time turn it off then try to start. this will reset the security. Make sure you have everything turned off when you do this. as the battery will drain. It is a good idea to put the charger on the battery as you do this.

Nov 21, 2010 | 2000 Oldsmobile Bravada

1 Answer

Put a new key switch in a 02 impala the vin starts with a 3 and will not let me program it by turning the key on for 10 min. 3 times.?


PUT KEY IN SWITCH IN ON POSITION FOR 10 MINUTES WITH LED ILLUMINATE.WHEN LED LIGHT TURN OFF YOU TURN OFF IGNITION SWITCH FOR 5 SECS THEN TRY CRANKING IF DONT START TRY THE SAME PROCEDURE TWICE MORE.IF STILL DONT WORK.DEALERSHIP HAS TO DIAGNOSTIC SCANNER TO REPROGRAM IT.

Jul 06, 2010 | 2003 Chevrolet Impala

1 Answer

Securyty ligth car dont star


ANY TIME SECURITY LIGHT COME ON YOU HAVE FAULT IN THE IGNITION KEY OR KEYS THEY COULD BE WORN OUT WHERE TO A POINT WHERE THE BCM AND PCM DONT RECOGNIZE THE CAR KEYS CAUSING NO START CONDITIONS.ALSO WORN KEY SWITCH AND BCM WILL CAUSE NO START CONDITIONS.TRY THESE TWO THINGS TRY ANOTHER CAR KEY IF STILL DONT CRANK.PUT KEY IN IGNITION TURN KEY TO ON POSITION WITH ENGINE OFF LEAVE KEY ON POSITION IN IGNITION FOR 10 MINUTES WATCH DASH SECURITY LIGHT WHEN IT TURNS OFF IN 10 MINUTES.TURN OFF IGNITION FOR 5 SECONDS THEN TRY STARTING CAR IF CRANKS OR DONT STILL THE PROBLEM IS IN THE THEFT SECURITY SYSTEM NEED TO GET DEALERSHIP TO FIX THEY HAVE DIAGNOSTIC EQUIPMENT TO FIX AND REPROGRAM THEFT SECURITY. SYSTEM.

May 25, 2010 | 1999 Oldsmobile Alero

1 Answer

Change starter on 2002 tahoe now motor wont start


If you had battery unhooked and assuming that it is turning over try this Put your key in turn it on dont start wait 10 mins remove key wait 10 seconds repeat this a total of 3 times. If that dont work try a different key do the same thing. This relearns your key to the ignition it started with Gm cars and trucks from 1999 to to 2006. It is a big problem but there is no recall that I know of. If that dont work a dealer needs to probably replace and reprogram your ignition switch and keys

Dec 27, 2009 | 2002 Chevrolet Tahoe

1 Answer

Dont start


Any damage to the key lock cylinder? If not nobody has tried to start it that way and no other way can be done unless its a trained qualified person

May 26, 2009 | 1989 Cadillac Eldorado

1 Answer

Car wont start


Try this Put your key in turn it on dont start wait 10 mins remove key wait 10 seconds repeat this a total of 3 times. If that dont work try a different key do the same thing. If that dont work a dealer needs to probably replace and reprogram your ignition switch and keys

Apr 06, 2009 | 2005 Chevrolet TrailBlazer

1 Answer

2001 chevy starts when it wants to


The theft passlock might be shutting your fuel off try this Put your key in turn it on dont start wait 10mins take key out wait 10seconds repeat 3 times total 30mins. If that dont work try another key

Apr 04, 2009 | 2001 Chevrolet Silverado 1500

Not finding what you are looking for?
1990 Jaguar XJ6 Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...