Question about 1997 Chevrolet Venture

1 Answer

Wipers will not work on low spped or intermittant

I have a 1997 chevy venture
and the wipers will not work on low speed or intermittant they only work on High where can I find a free repair manual

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

Check out autozone.com. You have to register for a membership (free) but then you will be able to use any of their vehicle repair guides. I had a similar problem with a 1996 Jimmy that ended up being the wiper control module (~$30). The module is housed with the wiper motor, under a plastic cover. The motor should be located, under the hood, on the firewall, very near to one of the wiper arms. Simply, unplug the wiring harness to the motor and remove the 3 or 4 screws that hold the cover on and pull the circuit board straight out and replace it.

Posted on Nov 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 chevy venture, windsheild wipers only work on high , and does not go into park position unless you are close to park position


I would be looking at replacing the wiper motor....the wiper switch is just that, a switch to tell the wiper motor what to do.....most of the wiring is housed internal of the wiper motor such as the park circuit and the speeds........osunds like an internal fault.....replacement would be advised

Feb 21, 2011 | 1999 Chevrolet Venture

1 Answer

1985 gmc k1500 wipers only move at 1 slow spped, interminttent doesnt work at all. How fast is fast and why is fast not working?


Slow is the same speed as 'mist'. Mist is when you twist the control arm backwards to induce a single swipe. If you hold it, you will run the wipers in low speed. Fast is faster than that. Probably by 30% or more.

Turn the wipers on high speed. Wiggle the connector at the wiper motor. If the wipers run sporadically as you wiggle the connector, you either have a bad connector or a bad circuit board on the wiper motor.


Jan 15, 2010 | 1985 GMC K1500

1 Answer

1997 Chevy Venture wipers


Does the wiper arms "park" properly when you turn them off or are they different from left to right? In other words, is one sitting higher than the other?
One other thing, I have had a few come in to the shop where the wiper arm was loose where it attached to the spindle. You can check those with a 13mm wrench or socket and make sure they are tight too.

Sep 02, 2009 | 1997 Chevrolet Venture

1 Answer

Intermittent wipers quit this morning


It is most likely the circuit board on motor module.

Jul 26, 2009 | 2000 Chevrolet Venture

3 Answers

Wipers only work on high.


It sounds like the switch went out. I have seen a lot of GM products have this same problem.

Jun 10, 2009 | 1998 Chevrolet Venture Cargo

1 Answer

2002 chevy tracker the intermittant wipers will not work?


You could have a bad wiper motor circut board problem. You can pick on up at a parts store for less then at the dealer but check to make sure it's the board and not the switch it self.
Good luck and hope this helps. 

Apr 23, 2009 | 2002 Chevrolet Tracker

2 Answers

Wipers do not work in intermittent position. They do work in low and high speeds but do not automatically return to the park position. They stop wherever you turn the switch off.


i belive that your wiper switch has gone out on the intermittent side. this is a very common problem.
I hope this helps you
Thanks
Please leave rating

Apr 21, 2009 | 2000 Isuzu Amigo

1 Answer

Problems with tun signal/wiper arm on 2004 chevy venture mini-van


I had the same thing - it also affects the 4 way flashers.  you'll end up replacing the entire control arm (turn signal lever)
Good luck!

Feb 13, 2009 | 2004 Chevrolet Venture Passanger

Not finding what you are looking for?
1997 Chevrolet Venture Logo

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...