Question about 1998 Plymouth Grand Voyager

1 Answer

Fuel pump died, replaced it, and changed out fuel relay fuse, vehicle still will not start

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 133 Answers

REPLACE FUEL FILTER AND TRY SWAPING THE FUEL PUMP RELAY WITH AN OTHER IN THE FUSE BOX

Posted on Nov 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 Buick rendezvous it just stalled on me the other day so I got a fuel pump changed it now it still won't start I checked the fuses and bought a new fuel pump relay fuse still won't start.


are you getting fuel or just changed pump because it died ---try starter fluid if starts --recheck fuel pump--relay for power --connections to pump -new doesnt mean free from defects or improper installation no start test for spark -

Sep 18, 2016 | Buick Cars & Trucks

2 Answers

Changed out fuel pump will not start unless you pour gas in the intake runs but dies as no fuel delivery


Sounds as if the injectors are not operating. Check all fuses. Does check engine light come on for a bulb check prior to vehicle being started? If not, suspect ECM fuse/s or bad ECM

Feb 14, 2016 | 1999 Chevrolet Blazer

1 Answer

I have replaced the priming pump and re-service the fuel injectors and it does the same, start and go es off, what could be the problem?


Could be almost anything. A clogged fuel filter. A dying ignition module or coil. A vacuum leak. A dying crank sensor. All these will keep a vehicle from running. But first make sure it is getting fuel and voltage. And check the fuel pump relay and fuses, The relay may be getting hot and shutting vehicle down. God-Bless!

Sep 12, 2015 | Cars & Trucks

2 Answers

2010 f150 wont start will turnover but no start cant hear the fuel pump start either


sounds like either the fuel pump relay or the fuel pump itself has gone out. check fuse panel first then check fuel pump relay. if those are good then check power leads to pump at tank and if you have power there then the pump has probably failed. hope this helps. Chris

Mar 20, 2014 | 2010 Ford F-150 Regular

2 Answers

Engine will crank but not turn over. Suspect fuel pump relay or fuse.


Testing the fuel pump electrical circuit would be the way to see if the fuel is the problem ! Learning how to test automotive electrical systems would also be helpful .
Fuel Pump Electrical Circuits Description and Operation
Also looking at a wiring diagram for your vehicle would be helpful as well . You would do that to see what all is involved in the fuel pump electrical circuit on your vehicle. Also pulling a spark plug wire while cranking the engine over to check for spark .
Free wiring diagrams herehttp://www.bbbind.com/free_tsb.html
Enter the vehicle info. year , make , model and engine size . Under system click on engine ,then under subsystem click on fuel controls . Click the search button ,then the blue links.
But first ,hook up a fuel pressure gauge instead of guessing if it's the fuel pump . You don't know any of this , suggest you take it to a qualified repair shop .

Aug 01, 2017 | 1995 Ford Escort

1 Answer

1998 ford explorer sport,V6 SOHC cranks but no start.. Took vehicle to get Emissions Tested (Illinois), turned off vehicle, they hooked up there diagnostics, went to start, no start, pushed me outside to...


It sounds like your fuel pump or pump relay died. Have a listen below the driver side passenger door in front of the rear wheel while someone turns the key to the "ON" position. You should hear a muffled whirring noise. If not, then the relay or pump has died.

The relay is located in the engine compartment in a black box in front of the power brake booster. The exact location is posted in your owners manual. Autozone or checker sells them for about $7, That should be your first step before dropping $150 on a pump that you might not need. Besides, replacing the pump requires removing the fuel tank to access the pump , and if the shop says the pump is not getting power, then most likely, it is the relay OR the mini fuse for the relay (Not the fuse on the dash panel)

LOCATION OF RELAY AND MINI FUSE

Good luck.


Jun 11, 2010 | 1998 Ford Explorer

2 Answers

It will not start. We changed the fuel pump three times. Each time the new fuel pump will not hum or buzz when you turn the igntion.


Did you check the fuel pump wiring harness, fuel pump ground , power to the fuel pump, fuel pump fuse , fuel pump relay

Oct 18, 2009 | 1999 Chevrolet Venture

2 Answers

My car starts but after a while dies waht can be


Hello! You're symptoms sound very much like a common problem associated with the fuel pump resistor. The GTP engine has a two speed fuel pump. There are two relays that control the fuel pump via the PCM module. The fuel pump relay and fuel pump hi-speed relay. Tied into the hi-speed relay is a fuel pump resistor that may go bad.

Symptoms vary but primarily the engine will start but die in a matter of seconds due to insufficient fuel pressure.

Here is a picture of the relay - which is located in the fuse box in the engine compartment:

e3ccead.jpg
What you can do to both diagnose this and either narrow it down to this or disqualify it as the culprit is remove relay #15, and bend out the tab labeled "85", and then reinstall the relay. If this does solve your problem, then you need to replace the Fuel Pump Resistor. Doing this will bypass the resistor, and place the fuel pump in "high" speed mode at all times. Once you have replaced the resistor, you need to bend the tab back to its normal position and replace the relay.
NOTE: while this may be a helpful diagnosis tool, and provide a temporary fix - doing this procedure for a prolonged period of time can lead to fuel pump failure. Use this at your own risk.


Hope this helps and good luck!

Sep 24, 2009 | 1997 Pontiac Grand Prix

1 Answer

Where is the fuse & relay switch for the fuel pump located.


Locate the fuse box. Facing the engine, the box is located on the the right fender. The fuel pump fuse should be labeled, The fuel pump relay is Incorporated in the FI relay located under right center of dash. It is a metal relay usually bolted to the floor near the ecm. Good luck and hope this helps but first replace the the fuel filter since it's the easiest thing to do.

Jul 11, 2009 | 1994 Mitsubishi Mirage

Not finding what you are looking for?
1998 Plymouth Grand Voyager Logo

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...