Question about 1993 Jeep Grand Cherokee

1 Answer

I own a 1993 Jeep Grand Cherokee Laredo, i took the battery out, put it back in about 2 weeks later. and now it won't start...just clicks repeatitly. replaced the Crankshaft position sensor, throttle position sensor, has new fuel pump, new lines, new computer, distributor, plugs, wires previously when it wouldn't start..now it "clicks"

Posted by on

  • GasparMacari
    GasparMacari May 11, 2010

    is the bettery chaged? have u tested it?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Check that the battery has full voltage (must have 12 volts or better and able to withstand a 200amp load for fifteen seconds and be able to snap back to full voltage immediately after test) and that connections are clean and tight. If you have replacement ends on the cables, make sure that there is no corrosion where the wire attaches to the end under the straps.

Posted on Nov 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok my 2001 Grand Cherokee Laredo wont stay in park


Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!

Oct 22, 2015 | Cars & Trucks

1 Answer

Are a 1993 4.0 liter high output 2 wheel drive Jeep Grand Cherokee countries have the same block as a 1990 Jeep Grand Cherokee Laredo 4 wheel drive it also has the 4.0 liter engine but it is not the high...


the first grand cherokee laredo was in 1992 . it was all jeep sports back then, the blocks are all the same .you will need to use some of the sensors from the old motor, the distributor and oil sending unit and temp sensor. will be no problem. if I can put a ford ranger motor in a mercury sable your swap is easier

Dec 05, 2012 | Cars & Trucks

1 Answer

2000 Jeep Grand Cherokee Laredo electrical issues


i suspect maybe the battery is low. get it load tested. jeeps can be funny like that

Jun 15, 2017 | 2000 Jeep Grand Cherokee Laredo

1 Answer

What will cause a Clacking/Clicking noise coming


It maybe a loose heatsheild on the manifold, converter, or underbody heatsheild.

Jun 03, 2010 | 2000 Jeep Grand Cherokee

1 Answer

1993 Jeep Grand Cherokee Laredo wont drive when put into gear


No, not with out a lot of work. Electronics are most likely different on the 2 also.

Mar 11, 2009 | 1993 Jeep Grand Cherokee

1 Answer

1991 jeep cherokee laredo won't start


you can test your signal wire to the starter by having someone turn the key to start while you put a test light on the signal wire at the stater.If there is no signal on the light then there is a problem with the sending wire from the ignition.

Mar 07, 2009 | 1991 Jeep Cherokee Limited

2 Answers

1993 JEEP GRAND CHEROKEE LAREDO IM TOTALLY BAFFLED


Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)

Mar 05, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...