Question about 1991 Toyota Land Cruiser

1 Answer

Ignition key came out whilst in ACC position and

Toyota landcruiser Ignition key came out whilst in ACC position and will not go in again - so car is efectively stuck in the driveway

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

Us a screwdriver to turn to off position and put key back in should be fine

Posted on Nov 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Automatic door lock 1999 toyota prerunner


hi jerome
I have the procedure for Toyota auto lock, is worth to try it
AUTOMATIC LOCK SETTING
1) Step in the vehicle and make sure that all doors are closed completely
2) Insert the key into the ignition key cylinder.
3) Wait for more than 5 seconds.
4) After turning the key to the ACC position, turn the key from the ACC to the
ON position 5 times within 10 seconds (Last position : ON).
? Status Monitor LED will illuminate for 30 seconds.
Note : In case you implement 6 times or more by mistake,
action steps 6)-8) you made will be canceled.
Please retry from step 2).
5) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key to the ACC position.
? LED will continue illuminating.
? Indicator lights will flash 2 times.
Ignition controlled door lock ON :
6) While the LED is illuminated:
• Open and close the driver's door 1 time.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 1 time.
? LED will extinguish.
Ignition controlled door lock OFF :
6) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 2 times.
? LED will extinguish.

Jan 28, 2014 | Toyota Camry Cars & Trucks

1 Answer

Remove ignition tumbler 1989 toyota celica


to remove ign switch you must remove lower dash panel turn key to acc position and push ign lock at bottom of ign assem located about 1 inch down from front of key cylinder you will see a hole using a pick tool push up and pull out on key to reinsert key must be in acc position please rate this info

Mar 07, 2011 | 1989 Toyota Celica Liftback

3 Answers

Key locks in the ignition in the ACC position. can't take key out


when you turn key to acc pos that is telling the ignition to go into a accessory mode which runs the radio,wipers etc... but it doesnt allow the ignition circuit to run, and the key in most vehicles will not be able to come out,this is a security protection so that you do not leave accessories on that will drain the battery. The ignition key should only be able to be removed in the OFF position.

Jan 21, 2011 | 2001 Saturn L-Series

1 Answer

Ignition key goes to acc position only on my 98


probably bad key switch make sure not wrong key

Mar 14, 2010 | 1998 Toyota Sienna

2 Answers

Key stuck in ignition


make sure you are pushing in on the key while turning it to the off position

Jun 06, 2009 | 1994 Lexus GS 300

2 Answers

Key stuck in ignition halfway to ACC position and will not turn


try wd40 and shaking the key, what happens is one of the tumblers get stuck and wont let the key turn if that dosnt work let me know worst case you will have to replace the ignition its about $35 to $40 and a few hours.

May 31, 2009 | 2003 Saturn VUE

4 Answers

Timing belt light of Toyota LandCruiser 2006


the reset procedure of the timing belt light is all done by pressing the trip meter button and holding it in whilst the ignition is turned to on then select from the trip button then continue pressing until you come to 15 on trip metre, turn off and then restart. The light should then go off.

Dec 27, 2008 | 2006 Toyota Land Cruiser

1 Answer

Automatic engine immobilizer wo'nt reset


The immobilizer does not "lock" the ignition, it does not energize the fuel injection relay. What you have is a "locked" steering column. Put the key in the ignition, and pull/turn the steering wheel HARD left or right, whilst turning the key to on or start. Do BOTH at the same time.The action of you pulling on the steering wheel will unlock the steering column.

Dec 21, 2008 | 2008 Toyota Yaris Sedan

1 Answer

1998 Toyota 4Runner ignition switch trouble, 140k miles


Your tumblers are probably worn to the point were your only soluation is to replace the ignition switch

Nov 22, 2008 | 1998 Toyota 4Runner

Not finding what you are looking for?
1991 Toyota Land Cruiser Logo

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...