Question about Ford Thunderbird

1 Answer

Battery keeps sparking when you put power leed on and all wiring plugs r disconected

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Ford Master
  • 2,030 Answers

Thats will allways get a small spark when you connect a battery.

If you are getting a spark then is something connected, and not all connectors are disconnected.

Btw, I’m available to help over the phone in case u need at

Posted on Nov 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What caused my 1998 Mazda Capella, one of the Leeds to melt to the top of one spark plug. Do I replace both coils

A loose electrical connection is a major cause of heat, so maybe it wasn't pushed onto the plug securely. And no, you do not need to replace both coils. It will be fine, just replace the plug wire and spark plug.

Jan 07, 2018 | Mazda Cars & Trucks

1 Answer

No spark yet

as said before, there is a ground leed that has a spade which is to be reinstalled in new dist cap. if this ground strap is not reinstalled you will not have spark.

Apr 21, 2013 | Cars & Trucks

1 Answer

86 gmc 2wd 305 slight cam. At initial start, engined fired and ran great for about 30 min or so at operating temp, then started stumbling and will no longer start. Spark was present at only 5kw though, not...

This works with the 5 prong module on an HEI ignition system with the coil that is mounted on the top of dist. The wires that come out of the back of the dist go to a spark controll module under the dash and they are junk. There is a conector on the wiring harness about 5" from the dist unplug that conector and run a jumper wire from the green wire to the black wire on the dist side and make sure you tape up all wires on dist side to keep them from grounding out. On the other side of the dist where your 12V goes in (batt conection) there are to wires piggybacked on top of each other disconect them from dis and plug only the pink 1 into dist at the batt conection. Where the wires on the back of dist run into firewall there should be a vacume line disconect and plug on engine compartment side. Thats how you do the bypass and the spark control module can be removed from under the dash if you want to but its not hurting anything to leave it there. BEFORE YOU DO ANYTHING MAKE SURE YOU DISCONECT THE BATTERY. When all this is done you mite have to advance your timing 8-15 degrees. I had to advance mine 12 degrees. let me no if you have any problems. kyle yeo

Oct 18, 2010 | 1986 GMC C1500

1 Answer

Battery is OK, engine turns over- but no spark? Are there safety lockouts that I need to find? ( I am not familar with the Honda ignition system- does it have a coil and points?)

check your alternator see if it has enough power and also disconect plug number one and if you see spark then check your fuses be care full when youcheck the sparkplug do it in a dark place so you can see the spark dont hold the wire dont hold the spark plug wire

Dec 30, 2009 | 1991 Honda Accord

1 Answer

I have a Dodge 97 4x4 with no spark. Replaced the

Run a wire from the +on the battery to the + on the coil.Then try and start.If it starts the only way you can turn off is to disconect the wire from the battery to the coil.This will tell you have a wireing problem

Dec 27, 2009 | 1997 Dodge Ram

1 Answer

2005 Ford Explorer cylinder 5 misfire, I changed coil pack and spark plug, problem still exist.

Keep in mind the spark plug wires is what transfers the electricty from the coil to the spark plugs #5 is bad then it is not going to receve proper curent.So usaly it is ideal to change all at the same time!don't forget to disconect battery to reset computer takes a couple of minutes to reboot the computer.Merry Christmas

Dec 26, 2009 | 2005 Ford Explorer

1 Answer

Changed spark plugs on 2006 mustang with 4.0 v6 sohc and car runs rough like its missing. changed spark plug wires and still bogs down. cheaked cylender order and conections and every thing is right....

check to see if you put the right spark plugs in the engine (heat range ect) and make sure the spark plug wire boots are seated all the way

Nov 18, 2009 | 2006 Ford Mustang

1 Answer

With spark goes up and down on mazda rx8

your plugs are marked with a L and T this means leeding and trailing. the leeding plug goes in the bottom hole and the trailing plug goes in the top. It will run very poorly if you install them the other way around. Also when you replace the plugs look at the ends of the plugs if there is any rust or corrosion on them you will need to replace the wire because they are worn out and will cause a miss fire and posibly damage a coil

Aug 18, 2009 | 2004 Mazda RX-8

1 Answer

92 buick park ave security light on car wont start

Someone put the wrong key (resistor value) in the ignition lock, you will have to disconect the battery for 3 min. Make sure you have the right key. Very important! Make sure the climate control is off before disconecting/conecting the battery.

Apr 18, 2009 | 1992 Buick Park Avenue

1 Answer

Replace the ignition coils on my 2003 Volvo S40

its easy do thiers 4 of them thy push on to ur spark plugs 2 scews hold them in place disconect the leeds going on to the coil one by one then pull out and put in ur new one's

Mar 02, 2009 | 2003 Volvo S40

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides