Question about 2006 Chevrolet Tahoe

1 Answer

I cannot get my liftgate to lock on my 2006 Chevy Tahoe. It previously was locked and wouldn't unlock and one time I got it to unlock and from there on it would lock...Any suggestions what it could be?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

You have to replace the liftgate fuse, it is marked "ECC" fuse in the fuse panel. The row closest to the engine at the bottom.
Should be a 10mamp

Posted on Dec 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the rear liftgate fuse for a 2005 chevy tahoe


the liftgate relay it is located on the "B" pillar passenger side This is the door post between front and rear seats. if the fuse is good listen/feel this area for the relay clicking.


Jan 03, 2012 | 2005 Chevrolet Tahoe

1 Answer

I have a 2006 Chevy Tahoe and discovered the back hatch and glass is not locking or unlocking.


fist check the fuses.Then if still problem take the tahoe to an autherized chevy service center it should still be under warrany.

Jun 30, 2011 | 2006 Chevrolet Tahoe

1 Answer

My 2006 Yukon liftgate does not lock with the other doors. Can someone help me? Thanks!!


It is probably the actuator inside the tailgate. I found this URL on internet http://www.chefseattle.com/blog/site-news/suburban-rear-liftgate-wont-unlock-how-to-fix/ Although not your problem, it will assist you in panel removal and actuator repair or replacement.

Feb 24, 2010 | 2006 Chevrolet Tahoe

1 Answer

2006 Tahoe Z71 Lift Gate Will Not Unlock With Remote


Take the liftgate inside panel off an check the wiring , connections etc....
rear door hatch lock repair GMC Chevrolet
chevy tahoe lift gate not opening
The liftgate will lock any time the vehicle is shifted out of park on vehicles equipped with an automatic transmission and at vehicle speeds exceeding 5 kph with manual transmission. This happens in conjunction with auto door locks if enabled or independently of auto door locks if the feature is disabled. This ensures that the liftgate is locked anytime the vehicle is shifted out of park or when the vehicle is in motion.
The liftgate lock relay supply and coil sides receive a constant voltage through the battery voltage supply circuit and the ECC fuse. The normally closed contact is connected to ground and the control side is connected to the body control module (BCM). A lock function will occur when a door lock switch activation, keyless entry lock transmission, auto door lock function or a liftgate lock function has been received by the BCM. The BCM will then ground the control side of the liftgate lock relay. This energizes the relay and allows voltage to be applied to the liftgate lock actuator lock control circuit. Since the other side of the liftgate lock actuator is connected to the normally closed contacts of the door unlock relay to ground, the liftgate will lock. When an unlock function occurs the BCM will ground the control side of the unlock relay and the rear doors and liftgate will unlock.
The BCM also runs diagnostics on the liftgate lock relay control circuit and will set DTC B3825 as current and also send a Class 2 message to the DIC. The DIC will display REPLACE LIFTGATE FUSE to inform the driver that a fault has been detected in the liftgate lock circuit and that the liftgate is not locked. Faults that will set the DTC and cause the DIC to display the message could be any of the following

Power Door Locks Inoperative - Endgate/Liftgate

Schematic Reference: Door Lock/Indicator Schematics
Connector End View Reference: Power Door Systems Connector End Views
1
Did you perform the Diagnostic System Check - Vehicle?
YES - Go to Step 2
NO - Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
Activate the door lock switches to the lock and unlock positions.
Do both rear passenger doors lock and unlock?
YES - Go to Step 3
NO - Go to Power Door Locks Inoperative
3
Did the liftgate lock actuator lock and unlock?
YES - Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
NO - Go to Step 4
4
Disconnect liftgate door lock actuator.
With a test lamp connected to a good ground, probe the door lock actuator lock circuit at the door lock actuator harness connector.
Activate a door lock switch to lock position.
Does the test lamp illuminate?
YES - Go to Step 5
NO - Go to Step 7
5
With a test lamp connected to a good ground, probe the door lock actuator unlock circuit at the door lock actuator harness connector.
Activate a door lock switch to unlock position.
Does the test lamp illuminate?
YES - Go to Step 6
NO - Go to Step 8
6
Inspect for poor connections at the harness connector of the door lock actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
YES - Go to Step 10
NO .. Go to Step 9
7
Repair the open door lock actuator lock circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
YES - Go to Step 10
--
8
Repair the open in the door lock actuator unlock circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 10
--
9
Replace the liftgate door lock actuator. Refer to Door Lock Actuator Replacement in Body Rear End.
Did you complete the repair?
Go to Step 10
--
10
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 2

Apr 27, 2017 | 2006 Chevrolet Tahoe

1 Answer

2006 chevy tahoe liftgate won't open when keyless remote unlocks


check fuse first always, then check connections fron rear gate to body.

Dec 14, 2008 | 2006 Chevrolet Tahoe

1 Answer

2006 Tahoe


you will need to remove the liftgate panel inside and manually unlock it the unlock acuator is made of plastic and has probably broke off very common

Oct 05, 2008 | 2006 Chevrolet Tahoe

Not finding what you are looking for?
2006 Chevrolet Tahoe Logo

731 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...