Question about 1992 Toyota Camry V6

1 Answer

When I start my car, it idles or accelerates up in down. When I press on the gas, it stalls back and forth. What's the problem and what can I do?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

It sounds very strongly like a mass air flow sensor issue. one way you can tell is unplug the unit and start the car. if it idles ok(it wont accellerate very well) plug it back in. chances are it will probably kill it. if so replace the unit.

Posted on Nov 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a chevy s10 2.2 2003 truck and one day it ran about five miles. then stalled. it started back up idled fine but put it in gear. stalled again. had to get towed home replaced the fuel filter,truck...


When you press on the gas when the truck is running, does it rev up?

Did it die while driving down the road (foot on the accelerator) or when idle? - If so, try cranking it and get your RPMs up to 1500-2000 RPMs and put it in drive (with your other foot on the brake). See if it will continue running if you never take your foot off the gas.

Apr 06, 2013 | Cars & Trucks

1 Answer

Car won't run without foot on accelerator.


its very important that the throttle body especially around the throttle blade be spotless clean or they will stall every now and then. then progress to refuse to idle at all. take off the rubber air intake pipe from the top of throttle body [has 3 torqes screws] open throtle by hand and look for carbon/grease/soot etc were the throttle sits when closed. clean with toothbrush and some caeb cleaner get all black off and dont forget the blade, both sides and the edges. scrub then rinse with carb cleaner untill shiny.spray some cleaner in the hole that is on top off the body to. that is your idle air controll motor port.put back together.it will be hard to start at first so hold gas pedal half way down untill it starts then slowly [real slow] let foot off untill you are no longer pressing it. put in reverse and let it idle there a few seconds then do the same in drive. that should do it. sometimes it may stall a couple of times when driving dont hold foot on gas just let it die then restart this allows the computer to readjust its idle stratagee

May 06, 2010 | 1996 Jeep Grand Cherokee

2 Answers

1994 honda civic 1.5 16v stalling after pressing accelerator from idle


Another place to look is your IAC, or Idle air control valve. It is bolted to the back of the intake manifold, and can be removed and cleaned. It is usually the cause of most Honda Idle problems.

Apr 18, 2010 | 1994 Honda Civic

1 Answer

1999 isuzu rodeo LS: Revs high sometimes then revs low to the point it stalls. goes back and forth , won't maintain a level idle. I have to press the gas pedal so it won't stall, so either im stalling at a...


Do you have a check engine light? Which engine? My 1996 Trooper with a 3.2 D.O.H.C. is awful for plugging up the E.G.R. I have cleaned it several times! Good Luck!

Mar 21, 2010 | 1999 Isuzu Rodeo

1 Answer

Car stalls on acceleration over 2800 RPMs


fuel filter partly clogged. Remove and replace.

Sep 13, 2009 | 1998 Lexus Gs 400

3 Answers

I have a 1994 buick lesabre, it idles fine however when you drive it and come to a stop sign it either tries to cut off or dose cut off, pressing the gas pedal dose nothing at all, some times it will try...


If t dies hard - feeling like the trani is not disigaging when you stop - it could be a electronic part inside the trani.. This part tells the stall converter to kick in at a stop.. Not super expensive to fix.. But best done by a trani shop....

Jul 08, 2009 | 1994 Buick LeSabre

2 Answers

4 cyl Engine starts and idles ok...give it throttle and it dies


I need to get a clear mental picture of what exactly is happening.

With this said, you stated that the car "runs fine" until warmed up.

Q: When you start the car when cold it idles fine?
Q: If you allow the car to idle until "fully" warmed does the car stall?
Q: As the car begins to warm up, Does the RPM fluctuate abnormally?
Q: Does the car Only stall when you press on the gas pedal or does it stall just sitting and idling in addition to pressing the gas pedal?
Q: If you can drive it while cold does the car stall during acceleration when warm or only at Stop Signs / Lights?
Q: If you wait 20min or so, can you start the car again?
Q: How many miles are on the car?

Mar 27, 2009 | 1995 Toyota Camry

Not finding what you are looking for?
1992 Toyota Camry V6 Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...