Question about 1994 GMC Sierra

1 Answer

Have a 94 gmc 1500 4.3 automatic when i put it in drive it doesn't shift if i manuely shift from first to drive it will shift it doesn't have any slipping it also has overdrive that doesnt seem to work any suggestions?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • GMC Master
  • 3,854 Answers

Transmission does not shift automatically, only manually. Swap in a known-good PCM, check wiring, check other sensors such as VSS and TPS.

Trans shifts into gear harshly, car feels sluggish off the line
, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmision is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the underhood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Good luck and get back to me, hope this helps.

Posted on Nov 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission will only shift in 4 low,no codes showing


1994 GMC 4l60e transmission shifting problems - CarGurus

www.cargurus.com > Questions > GMC > Sierra 1500
CarGurusJan 17, 2011 - 1994 GMC 4l60e transmission shifting problems - I've got a 1994 GMC Sierra 4X4 5.7 I ... If you put it in low and lift the handle, it will go into second .... Justchange 1-2 - 3-4 solenoids first and if that doesn't work change the ...

Troubleshoot automatic transmission problems

www.2carpros.com/articles/automatic-transmission-problems
Jul 15, 2015 - Rescan the PCM for trouble codes, if none appear the problem could ...Excessively low transmission fluid (Note: If transmission is operated for an .... it waslow, and now my car will only shift from 1st to 2nd manually and will ...

Nov 03, 2015 | Cars & Trucks

1 Answer

Will a transfer case from a 94 GMC Sierra 1500 interchange with a 97 Chevy silverado 1500?


As long as it's a manual floor shift transfer case and both transmissions are the same then yes it will fit directly with no problems.

Feb 20, 2015 | GMC Cars & Trucks

1 Answer

My 94' gmc yukon will not shift into over drive


Problem is most likely internal of the transmision. To diagnos this problem correctly, you need a scan tool. Most likely scenario is that the solenoids in the transmision are defective. Take to tranny shop for proper diagnosis.

Aug 20, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

1993 gmc 1500 4x4 only shift into 4wheel when stopped


automatic hubs?? if so chances are they put grease into automatic hubs, which will cause sticking. hard apply, hard release..

Jan 27, 2013 | 1993 GMC Sierra K1500

1 Answer

My 2004 gmc envoy (automatic) seems to slip in low and second when in drive but not if I put it in L1 Or L2. If I let off gas it does shift then. what could be problem?


Could be as simple as a fluid and filter change and a linkage adjustment. Doesn`t sound serious. I woud try those two things. One at a time starting with the fluid and filter.

Jan 30, 2011 | 2004 GMC Envoy

1 Answer

GMC 1500 Auto, will not shift back into park?


Climb under your pickup and look where the cable connects to the side of the transmission and make sure there is not any mud around the cable or around the shift linkage hookup. If so clean it off and see if it will shift. We have found many of these with mud caked around the shift linkage or a lot of ice buildup and wont allow it to shift into park.

Dec 10, 2009 | 2000 GMC New Sierra 1500

1 Answer

Shifting problems on an 85 gmc auto trans


transmission is shot clutches are worn out

Oct 14, 2009 | 2000 GMC New Sierra 1500

Not finding what you are looking for?
1994 GMC Sierra Logo

451 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...