Question about 2000 Ford Mustang

1 Answer

How do i remove the back seat to my 2000 ford mustang gt convertible?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 435 Answers

On the seat bottom left and right of center there's a release clip. (see photo) Carefully push the release with a flat screw driver and pull up doing one side at a time.
Once the seat bottom is removed there's 2 bolts holding the seat back in place, remove the bolts and lift the seat back straiting up.


how do i remove the back seat to my 2000 ford - a2d03ac.jpg

Posted on Jun 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove hydraulic lift cylinder from 2001 mustang conv V6


need to remove all plastic panels on the rear seat remove seat and remove the convertible top assembly complete

Sep 09, 2014 | 2001 Ford Mustang Convertible

1 Answer

How to remove rear seat on 2003 mustang convertible


There are two latches for a full size seat. One on each side of the car. Grab the seat and push back towards the truck and pull it up at the same time. they can be difficult. Some of the older models have bolts you have to remove. Run your fingers under the seat, they are located in the middle of where you sit.

May 12, 2014 | 2003 Ford Mustang

1 Answer

How to change taillight on 2007 ford mustang gt convertible


Open trunk, pull back any trim & if you don't see
the lamp socket, you will see nuts to remove the
tail light housing from the body

Jul 08, 2012 | 2007 Ford Mustang GT California Special...

1 Answer

Rag top / convertible top motor/pump won't work. Needs fluid or motor?


most soft tops are operated with an electric wiper motor could be just a rust problem, check behind the seat or in the boot of the car, these are normally behind a panel, a little Q20 should sort it out

May 09, 2017 | 2000 Ford Mustang

1 Answer

2001 mustang convertible. How do you remove the rear seat to access the motor or pump ot check oil level? Thanks, Bruce


The seat bottom is held in with 2 release buttons located left and right of the center of the seat. (see photo) push with a screw driver and lift, then pull the seat bottom forward and remove.


gozer.jpg
The rear seat back is help in place by 2 self tapping bolts on the lower left and right of the seat back near the floor, if I remember correctly you'll need a 10mm socket. Remove the 2 bolt and lift up to remove the seat back. When re installing the seat back do not over tighten the bolts they have a tendency to strip.

Aug 15, 2011 | 2001 Ford Mustang

1 Answer

How do i get access to the hydraulic cylinders for


through the trunk or remove back seat.Bottom snaps in at the front and back should have bolts at bottom where seat was.

Jun 14, 2010 | 1966 Ford Mustang

1 Answer

How do you remove 89 convertible mustang rear seat


hit it hard (with the side of your hand or palm) at the bottom of the seat on the right and the left to relase the spring retainers, run a putty kniofe under the seat edge to locate the spring retainers

Apr 02, 2010 | 1989 Ford Mustang

1 Answer

Convertible top goes down and won't come back up.


You are probably low on fluid.
Behind the rear seat is the motor/pump/reservoir.
With the top down, fill the reservoir till it overflows with ATF. Cycle the system a few times. Repeat till the reservoir will accept no more fluid.
Look for leaking lines or cylinders. The fluid must have gone someplace.
Always replace lines and or cylinders in pairs.

Jun 27, 2009 | 2000 Ford Mustang

2 Answers

How can I remove the headrests from a 2000 Mustang GT


If you unzip the seat cover you can fit your hand up into the seat and release the tab holding them on.

May 09, 2009 | 2000 Ford Mustang

Not finding what you are looking for?
2000 Ford Mustang Logo

562 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...