Question about 1998 Volvo S70

Open Question

Ck engine code PO116. where is the sensor and how easy is it to replace?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Thermastat replacment


PO116 has nothing to do with the thermostat, but rather indicates the engine coolant temp sensor is out of range, which usually means the sensor has failed. Very common problem, and as this part tells the ECU how to adjust fuel ratio to current engine temp it acts sort of like the choke on an older carburetor type engine. This part is usually very easy to change, and relatively inexpensive. Your parts store should have a component location chart to show where it is one your engine. NOTE: there are often two coolant temp unit--one called the Sender is for the dash gauge, while the Sensor is for the ECU.

Oct 14, 2016 | Cars & Trucks

1 Answer

2011 ford transit Code PO116 & P1299


P0116: Engine Coolant Temperature Sensor 1 Circuit Range/Performance
http://www.autocodes.com/p0116_ford.html

P1229: Supercharger Intercooler Pump Not Operating Condition
http://www.autocodes.com/p1229_ford.html

Oct 14, 2016 | 2011 Ford Transit Connect

1 Answer

Reset check engine light


Code 116 is for a problem with the temp sensor circuit.
How do you know the problem is fixed ?

Jan 20, 2014 | Kia Cars & Trucks

1 Answer

Obdii cods gmc po116


This code refers to the engine coolant temperature sensor circuit. The computer is not getting a proper reading from that circuit. Often the problem is a faulty sensor, but it could be a wiring problem in the circuit, a poor connection at the sensor, or a missing or stuck open thermostat.
The ECT sensor is a two-wire sensor located in a coolant passage area, usually around the thermostat housing.

Nov 23, 2011 | 2006 GMC Sierra

1 Answer

2006 Chevy Impala V6. Occasionally one or both check engine or over heat dash lamps illuminate. When this happens temp gauge fails and AC doesn't work. Can have trouble starting when this condition...


PO116 Engine coolant range tempreature circuit.
I would change the temp sensor and first make sure the coolant is full in the rad with no air in the system.

Aug 15, 2011 | Chevrolet Impala Cars & Trucks

1 Answer

1997 buick lesabre reads no codes . Engine turns ove,r car wont start. why? could it be a crankshaft sensor or a camshaft sensor


1st you need to see if its spark or gas related.spraying carb cleaner into throttle body
is a easy way to ck for gas.pull plug wire & ground to ck for spark
good luck

Jun 10, 2011 | Buick LeSabre Cars & Trucks

1 Answer

Hi codes came up coolant temp sensor g62 implauseable signal [po116] where is the sensor?


front of engine right hand side coming from head is a outlet with a hose pipe to rad coming from it ,on top is the sensor ,now some models have two sensors here and later ones use one sensor ,if two sensors then its the back one and their held in by a horse shoe clip with a rubber seal under neath

Mar 12, 2011 | 1999 Volkswagen GTI

1 Answer

Code po116 , tempture guage stays on cold, both fans are runing put 2 thermostes new. possible codes po520 po340


it peobably needs a new coolant temp. sensor thats what the po116 stands for. or it could be loose connector or wire short, but a bad sensor would be a good guess

Mar 20, 2010 | Chevrolet Malibu Cars & Trucks

1 Answer

My chevy cavalier 2005, the speedometer and temperature gauge stopped working. I'm not sure whats wrong and don't want to get ripped off at the dealers. Please help if there is something I can check...


Is the ck engine light on If so take to a auto parts store that will ck the car for codes and that will tell you if the speed sensor is working or not> If the speed sensor is not working the ck engine light will be on and the car will have stored that code.If there are no codes that it is most likely the cluster for the speedometer not working . Now the temperature guage not working is the needle spunaround backwards past the stop If so that replace the cluster .If not than it needs to be ckd for a bad tempature sensor.This should also set a code and turn the ck engine light.

Mar 08, 2010 | 2005 Chevrolet Cavalier

Not finding what you are looking for?
1998 Volvo S70 Logo

Related Topics:

540 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...