Question about 1988 Nissan Pulsar

1 Answer

1988 Nissan Pulsar will not engage clutch. Engine

1988 Nissan Pulsar will not engage clutch. Engine runs but nothing when clutch is in any gear.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 171 Answers

You need to replace the clutch and pressure plate --your clutch is worn out. Plus other parts like throw-out bearing ,pilot bearing and may even need the flywheel machined flat.
You need to take it to a shop or if you are mechanicaly minded could do it your yourself,

Posted on Nov 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you adjust the clutch on a 1999 Nissan pulsar ?


if its a hydraulic clutch no, so if you have a problem with engaging the trans you will need a clutch. first check clutch fluid level and for leaks in system.. if its cable you can adjust.

Jun 30, 2015 | Nissan Cars & Trucks

1 Answer

1988 nissan pulsar n13 keeps getting stuck in first gear


YOUR CLUTCH CABLE MAY NEED ADJUSTING,HERE'S A LINK ON IT,

Feb 12, 2014 | 1988 Nissan Pulsar

1 Answer

1988 nissan pulsar nx idles rough


The Pulsar starter is located centrally, underneath the engine close to the passenger compartment."According to my car, the E16i engine, it is on the drivers side of the engine below/behind the distributor.


Performance chips of BMW.

May 31, 2012 | 1988 Nissan Pulsar

1 Answer

Clutch/5th gear only problem


sounds like its time for a new pressure plate

Nov 06, 2011 | 1990 Nissan Pulsar

1 Answer

Nissan pulsar '88. replaced starter motor, then


Is it a manual, or an automatic? Earlier Nissans sometimes have a problem with the neutral safety switch (a device that keeps the engine from rolling over in gear or without the clutch depressed.) Generally, if their bad, they need to be a little warm before they'll start, like setting in the sunlight for a few hours.

Good Luck!

May 22, 2010 | 1988 Nissan Pulsar

1 Answer

Nissan pulsar 1988 wont go into gear I can put the gear stick in the right gear but does nothing wont reverse or drive, its automatic and has a reconditioned engine in it


try checking your transmission oil (i had the same problem but after $30 it was fixed) it might had drained out. if your transmission oil is fine then consult a mechanic preferebly an automatic transmission specialist. may be your transmission needs a rebuild.

May 20, 2009 | 1988 Nissan Pulsar

1 Answer

Transmission stuck in neutral (automatic) won't engage drive or reverse


first i would check the transmission oil, do this by starting the engine and leave it running, select all the gears (park, Reverse, neutral etc) then put it back to neutral, leave engine running then locate the transmission dipstick in the engine bay, remove and wipe the dipstick, replace then pull out again, if the oil is showing between the cold and hot marks then level is ok. I shoing lower or none, top up the oil level with automatic tansmission oil, keep rechecking the oil level as adding oil as to ensure it is not over full. will need to select all gears again before checking oil level again.
If the oil level is correct than quite likley a Transmission failure will require mechanic.

May 02, 2009 | 1988 Nissan Pulsar

1 Answer

5th gear doesn't lock


5th gear is gone, it'll be cheaper to find a good second hand one with a waranty than to get your one fixed sorry to say. The inside of gearboxes are only a place for gearbox specialists and they arent cheap unless you know someone.

Nov 24, 2008 | 1988 Nissan Pulsar

1 Answer

Nissan Exa gear problem


Dear Customer,

As you said above your engine oil is goin lickage so find out any crack or pinhole on pipeline for collent oil rails.

replace oil pipies weld any crack found on transmision case thna your gear will work batter.

THNX

May 16, 2008 | 1988 Nissan Pulsar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

346 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...