Question about 2005 Ford Five Hundred

1 Answer

2005 FORD FIVE HUNDRED SEL\r\nCHECK TRANSMISSION

2005 FORD FIVE HUNDRED SEL CHECK TRANSMISSION AND CHECK ENGINE LIGHT
CODE P1576
What/where is the pedal sensor. The TP Sensor is working i can see it on my OBD II device.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,619 Answers

Hi


Thanks for using FixYa. The check engine light is on because ECM (Control Module) detected a fault with your car's system. ECM has self-testing capability. When the computer senses that there is a problem with some of the components it stores the correspondent trouble code(s) in its memory and lights up the "Check Engine" or "Service Engine Soon" light to tell you that there is a problem and your car needs to be looked at.

The simplest way is to visit your local dealer or a repair shop for proper diagnostic. They have all the equipment and information needed to diagnose and correct the problem. The problem might even be covered by the manufacturers warranty and possibly repaired free of charge. Some auto parts stores can also do the "Check Engine" light diagnostic for free. Please also check the EGR valve.

The PCM can be reset using the New Generation Star (NGS) Tester or by disconnecting the battery ground cable for five minutes. If the battery ground cable was disconnected to clear Diagnostic Test Connector (DTC), the vehicle may operate rough for the first few miles until adaptive values are relearned. The DTC is located on LH side of engine compartment, on transaxle behind coolant reservoir. Use suitable jumper wire, jump BL/W and GY/BL wires to resolve the issue.

Error code P1576 means pedal position not available. You’ll have to remove the negative battery terminal for more than 5 minutes. If still the issue persists, then you’ll need to remove the whole pedal assembly and replace it. The TP means the Throttle Position which is connected with the Pedal Sensor.

Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks

Rylee

Posted on Nov 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

005 ford five hundred with code po942


You have a shop with no data base such
as Alldata,Mitchell or Identifix !!

Mar 06, 2013 | 2005 Ford Five Hundred

1 Answer

I have a 2005 ford five hundred,it has 73,000 miles on it.I am having problems with putting it in drive or reverse it shifts hard basically almost jumps when you put in in drive.I was wondering if maybe it...


IF this is a automatic the tranny is bad and your check engine light should be on. Future advice all tranny fluid should be changed at 30 to 40 thounsand miles,,,,,,,,,,thats why we are seeing so many bad trannies

Mar 16, 2011 | 2005 Ford Five Hundred

1 Answer

I have a 2005 Ford Five Hundred and the ''wrench'' warning light came on. It is NOT a AWD. What does it mean and what could the probable cause be?


You need to have the transmission serviced. The wrench indicates that the fluid in your transmission is out of spec or you have an out of spec pressure condition.

Oct 01, 2009 | 2005 Ford Five Hundred

3 Answers

Check engine light and check transmission


try removing the negative battery terminal, after a hour replug. hey... it dosn't cost anything. it might just be a stray signal

Jul 23, 2009 | 2005 Ford Five Hundred

2 Answers

2006 Ford Five Hundred traction control light on all the time.


This is a computerized traction control system that monitors the wheel spin and makes split second adjustments... if the light is on, Ford recommends servicing the system. I'd check with a local non-dealer mechanic that may be able to help you out cheaper than a dealer first.

Jun 16, 2009 | 2006 Ford Five Hundred

Not finding what you are looking for?
2005 Ford Five Hundred Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...