Question about 1991 Dodge Daytona

1 Answer

While motor running it skipps or hipcups sometimes even stalls engine cuts out

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 957 Answers

Usually this is a fuel system issue. But you will want to take a look at the truck's repair and maintenance history. (when was the last tune-up and/or any recent repairs or issues) Also how many miles are on her? Could be a clogged CAT. Run a back pressure test to confirm.

Posted on Nov 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Jeep 96 dies sometime going down the road and wont start sometimes. will start after 10 miles at times and 24 hrs sometimes. the dash says check gauges. help woman alone need advice


Fuel pump intermittent, check for fuel pressure before dropping the tank to renew pump.
Otherwise check electrical connection at battery, and make sure you do not have an open circuit.
Loss of connectivity could cause this issue, failed fuel pump sometimes work, but are not reliable.
You should see 30-45 psi at fuel rail, and the regulator should bump pressure 5 psi when reving the motor. Higher pressure indicates failed regulator.

Jun 23, 2014 | 1996 Jeep Grand Cherokee

1 Answer

No power won't hold idle


stalls. (hot engine, cold engine, both?)_what engine of the many.?
lost engine power. sure that will stall any motor.
ever tune it up r, or do the 60k mile service points, EVER?
if car was serviced, we can then say
Stalls.
1: lost 12vdc to EFI and spark , did dash lamps all go dead at stall.
can you save the stall with a fast right foot. (big clue there !!!)
2: lost compression hot. (guage it)
3: lost spark. (tests)
4: lost fueling, or floods more simple tests, ask if not known.
5: EGR main valve stuck wide open.
6: ISC stuck closed but will not stop power, or fast right foot.

lost fueling can be just the skippped, 60k fuel fuilter swap.

Dec 05, 2013 | 1991 Honda Civic

1 Answer

Starts and stalls, abs, odometer & speedometer out


Check for coolant temp sensor fault, It will affect cold start and idle. It controls open loop mode in the ECU (cold, high idle, open loop) Perform an OBDII scan of the stored fault history. Also make sure coolant level is correct.

Jun 04, 2017 | 2003 Ford F250

1 Answer

Car runs but sometimes dies as your going along wait a few minutes and it starts and runs again


Seen this many times on Grand Cherokees. The crank sensor is going bad. Replace it with a dealer crank sensor, not an aftermarket one.

Mar 01, 2013 | 1995 Jeep Grand Cherokee

1 Answer

My 1996 monte carlo has started cutting out, stalling and i did not run out of gas


what size engine? any repairs lately to the engine? when does it stall? freeway speeds, around town or at lights?

Jan 24, 2013 | 2003 Chevrolet Monte Carlo

1 Answer

Stalls sometimes when stopped at lights engine misses at stop


Engine stalling and rough run issue at low speeds

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 04, 2012 | Cars & Trucks

1 Answer

Check engine light is on, motor runs rough, sometimes stalls


Go to Advance or Auto Zone and have them run an obd scan on it and it will pin point why your light is on and could solve your problem. This is often done for free.

Apr 12, 2009 | 1998 Chevrolet Tahoe

1 Answer

Engine stalls.


Fuel system or motor is slitly out of time

Oct 14, 2008 | 1994 GMC Safari

2 Answers

Stalling & hunting idle


does throttle sensor check out correctly???

Jun 10, 2008 | 1995 Volkswagen GTI

Not finding what you are looking for?
1991 Dodge Daytona Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...