Question about 1994 Saturn Sl

1 Answer

If you have to replace the ignition, does it disrupt the airbag?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

As long as you pull the SRS (air bag) fuse beforehand, then you will have to worries or problems.
You can go to autozone.com and register for free for full free online repair manual.

Posted on Nov 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Disable passenger airbag suzuki alto


Unless the vehicle is fitted with a manual 'OFF' switch, then presumably there is no other simple way of disabling the passenger airbag without disconnecting the air-bag module. This is not recommended however and may disrupt the operation of the SRS system.

Jun 20, 2014 | 2010 Suzuki Alto 1.0

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe


Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

1 Answer

The problem with my car pajero Io is that everytime I put the key in the ignition it starts hooting through out, it was discovered that liguid in the swicth is finished after removing aire bag


How liquid got into the ignition switch is beyond me but,when an airbag is removed,you're going to keep getting that sound or noise you are hearing until you replace your airbag.
Also,have your ignition switch replaced unless you can do it yourself,which is a lot cheaper.
Remember,when you go to get your vehicle inspected,you better have the airbag working and in good order.
Hope this helps.

Jun 17, 2013 | 1997 Mitsubishi Montero

1 Answer

Recently changed lock cylinder on a 97 jeep wrangler and airbag light came on. Why?


DID YOU REMOVE AIRBAG FUSE OR DISCONNECT NEGATIVE BATTERY CABLE TO DISCHARGE AIRBAG CAPACITOR DISCHARGE BEFORE YOU REPLACE IGNITION SWITCH KEYLOCK CYLINDER. CHECK MAKE SURE YOU INSTALLED AIRBAG FUSE OR IF YOU DID DISCONNECT NEGATIVE BATTERY CABLE.WHEN YOU RECONNECT NEGATIVE BATTERY CABLE.WITH IGNITION SWITCH ON POSITION FOR MINUTE THE AIRBAG LIGHT SHOULD TURN OFF.IF NOT HAVE GARAGE OR DEALERSHIP CODE SCAN AIRBAGS SYSTEM SEE WHAT CAUSE SRS AIRBAG LIGHT TO FLASH ON COULD HAVE FAULT IN SYSTEM..

Nov 08, 2011 | 1997 Jeep Wrangler

2 Answers

Airbag light stays on in a 2003 audi a6 i've replaced airbag module & drivers seatbelt


You need to access the Airbag ECU (Electronic Control Module) using suitable diagnostic equipment connected to the data link connector of the car in order to erase all faults - DTC (Diagnostic Trouble Codes) memored, unlock and reset the Airbag ECU. Then the Airbag light will turn OFF after approx. 4 seconds, ignition ON.
Good Luck!

May 15, 2011 | Audi A6 Cars & Trucks

1 Answer

Airbag light is on


Check to see if the horn works. If not then the clock spring for the airbag needs to be replaced. This part is also known as the airbag igniter.

Dec 20, 2010 | 2001 Chrysler Town & Country

1 Answer

Which screwa to remove from bottom of sterring column when changing out an ignition switch


YOU HAVE TO REMOVE THE STEERING WHEEL TO REMOVE IGNITION SWITCH YOU HAVE TO REMOVE IGNITION SWITCH INSIDE THE STEERING COLUMN.YOU NEED A STEERING WHEEL PULLER AND A LOCK PLATE TOOL TO COMPRESS LOCK PLATE TO REMOVE THE LOCK PLATE RETAINING RING.DONT KNOW WHAT YEAR VECHICLE YOU HAVE.BUT DUE TO AIRBAGS MAKE SURE YOUR VECHICLE FRONT WHEELS POINTING STRAIGHT AHEAD.TURN OFF RADIO TO KEEP FROM LOCKING IT OUT.REMOVE NEGATIVE BATTERY CABLE WAIT 20 MINUTES BEFORE REMOVING STEERING WHEEL AIRBAG.DISCONNECT AIRBAG ELECTRICAL CONNECTOR.WHEN REMOVING AIRBAG CARRY AWAY FROM BODY CAREFULLY LAY AIRBAG FACING UP PUT SOMEWHERE SAFE FROM CHILDRENS AND PETS. YOU NEED A HAYNES REPAIR MANUAL TO LOOK AT AIRBAG CLOCKSPRING MAKE SURE IT CENTER.BEFORE REMOVING OR CLOCKSPRING WILL BE DAMAGED.IF YOUR TRUCK OR CAR DONT HAVE AIRBAGS NO NEED TO WORRY ABOUT THE AIRBAG REMOVING PROCEDURES. YOU JUST NEED TO REMOVE THE STEERING WHEEL.

Oct 24, 2010 | Chevrolet C3500 Cars & Trucks

1 Answer

Airbag lamp stays on a 98 VW Jetta,


you need diagnostic equipment.
marko

Sep 21, 2009 | 1998 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...