Question about 1998 Buick Park Avenue

Open Question

Power steering fluid capacity

What is the power steering fluid capacity for a 1998 Park Avenue?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: where is the fuse panel on a 1998 park avenue ultra?

I just accessed mine. It is under the rear seat. You just lift up on the seat, and it pops right out. If you are having problems with the rear defroster, it could very likely be the control module. This is a combination module which the rear antenna, and the defroster grid plugs in to.
When mine went out I smelled a "burnt wire" smell, then it went out.
To access the module, sit in the back seat, drivers side. There is a trim panel that will be by your left ear as you are looking forward. It is the panel that flares down from the ceiling to the rear deck. Gently pull at the edge of this panel, working around the edges, and the small strip which continues over the top of the door.
The seatbelt goes through this panel, so it will be hanging from the seatbelt at this point. There is a ~3" square, black module with the defroster input and output wires, and the antenna wire plugged into it.
You just unplug the wires, pull the one mounting screw, and voila!
On mine the module was obviously melted, as was the wire going into it. I got the replacement from a salvage yard, as the new one was over $50, and the replacement wire was $18. The salvage yard was unable to look it up, so I had to go out to the yard with them and pull it myself. The final cost was $17 (they tried to charge me $40, and I told them I could get it online for that, and they dropped the price).
You can use a crimp on **** connector to put in the replacement wire, but because of the heat in that area I chose to solder the wires together.
BTW, this module fits a wide range of Buicks, and full size Olds.
Hope this helps.

Posted on Jan 20, 2009

Ad
daves944
  • 1050 Answers

SOURCE: removing water pump 98 buick park avenue

You need to poke a small extension with a 13mm socket through the holes in the power steering pulley, undo it, and slide it back.

Posted on Mar 17, 2009

  • 9 Answers

SOURCE: I Lost all Power Window, Power door lock and Power

Check your fuses

Posted on Jun 16, 2009

  • 1608 Answers

SOURCE: repair seat belt latch - stuck- 1998 buick park-

Seat belts are usually not repairable.The only thing that can be done is to check and make sure nothing is stuck in it or that it is not twisted.You have the kind that is in the seat back itself.These are a little more difficult to remove from the seat because it is so easy to break the plastic trim covers.Best thing to do if not familiar with auto repair to go to the dealer or auto repair shop that you trust and have them repair it.Good luck.

Posted on Dec 07, 2009

  • 1 Answer

SOURCE: park avenue driver side mirror leaks oily fluid

The is most likely the chemical that is injected between mirror layers that keeps the mirror from icing on a heated mirror. The seal has deteriorated due to age, most likely. It needs to be replaced with another of the same mirror or a non heated single layer mirror.

Posted on Mar 06, 2010

Testimonial: "Thanks for the help... I figure it is probably too costly to replace the mirror however."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 BUICK PARK AVENUE PWER STEERING PUMP FLUID CONTAINER LOCATION V6 3800


The tank should be right on the pump, on top of the engine.
The cap says "power steering do not overfill'.

Feb 18, 2014 | 2000 Buick LeSabre

1 Answer

WHERE TO PUT IN POWER STEERING FLUID


should be a cap that says power steering on it or has pic of steering wheel should be on drivers side of engine

Feb 13, 2013 | 1997 Buick Park Avenue

1 Answer

Humming in 1998 park avenue buick


The humming could be one of two things. It could be the alternator,
or it could be power steering pump. Hope this helps.

Jul 26, 2012 | 1998 Buick Park Avenue

1 Answer

Steering is not smooth on my 1999 buick park avenue


Check the fluid level in the power steering reservoir.

May 28, 2010 | 1999 Buick Park Avenue

1 Answer

I cant locate where to put power steering fluid in my 1998 park ave ultra


The power steering pump cap is on the passanger side of the engine and between the engine and back fire wall. It is a very tight fit to get the cap off and back on.

Apr 15, 2010 | 1998 Buick Park Avenue

1 Answer

Removing water pump 98 buick park avenue


You need to poke a small extension with a 13mm socket through the holes in the power steering pulley, undo it, and slide it back.

Mar 17, 2009 | 1998 Buick Park Avenue

Not finding what you are looking for?
1998 Buick Park Avenue Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...