Question about 2002 Mazda MPV

Open Question

My 2002 mazda has a open loop fault - 2002 Mazda MPV

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does it keep cutting out and trying to stall?


fuel systems in "open loop" mode should produce a few more fault codes when checking them , but I can tell you the most common reasons for open loop fuel mode , O2 sensors , throttle position sensor , Manifold pressure sensor , an also sometimes somebody locks it in with a programming wand tool (ive seen that once)

Feb 09, 2016 | 1999 Honda Civic LX

1 Answer

2002 Mazda Tribute Gear shifter in neutral, not able to shift it to park or drive, car starts fine.


run the fault codes and look for a faulty servo/solenoid for the torque converter clutch

Aug 23, 2015 | 2002 Mazda Tribute

1 Answer

How do I fix this code P0123 for a Mazda Protege 2002?


Probable Cause:-
Possible Causes Setting Conditions
  • TP sensor connector is damaged (check pins for damage, and for moisture)
  • TP sensor signal circuit is open or shorted to voltage
  • TP sensor ground circuit is open
  • TP sensor has failed
  • TP sensor not mounted properly to the throttle body
  • PCM has failed
Engine running; and the PCM detected the TP sensor indicated more than 4.60v (i.e., a throttle opening of 92.27%). Note: This trouble code may set due to an intermittent fault.

Mar 23, 2015 | 2002 Mazda Protege

1 Answer

2005 LeSabre closed loop temperature?


Most cars go into closed loop around 160.. Maybe a little higher.. You could go online to a racing site to buy a lower temp thermostat.. Good luck.

Dec 11, 2013 | 2002 Buick LeSabre

1 Answer

I ran fault coded on my 2002 Mazda protege. It comes back fuel too lean bank 1. Already had fuel pump checked, and that was not the problem. Any ideas?


YOU COULD HAVE AIR LEAKS IN THE INTAKE MANIFOLD OR EXHAUST MANIFOLD.RESTRICTED FUEL FILTER AND FUEL INJECTORS.CHECK FOR BROKEN OR LOOSE VACUUM HOSES.FUEL PRESSURE REGULATOR FAILED.

Jan 24, 2011 | 2002 Mazda Protege

1 Answer

How do you reset the ABS and TCS lights on a 2002 Mazda 626?


these reset each time the key is turned on to start the car, if they remain on there is a problem in the system, the ABS and TCS are run by the same system control module, have it tested to see what fault code shows up to indicate what part has failed.

Aug 23, 2010 | 2002 Mazda 626

1 Answer

My sunroof wont open on my 2002 mazda tribute lx


it is probably bad switch replaced on mine fixed problem

Apr 08, 2009 | 2002 Mazda Tribute

1 Answer

Can't open my trunk in 2002 mazda 626


open the glove box there is a switch lock and open the truck your car must been lock you need to click it to open , good luck.

Feb 27, 2009 | 2002 Mazda Millenia

Not finding what you are looking for?
2002 Mazda MPV Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...