Question about 2005 Chrysler Pacifica

1 Answer

If the ABS like came on while driving but has now gone off is there still a fault

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,056 Answers

No unless it stays on all the time.

Posted on Nov 14, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Jaguar xj8 4.0 SE

sounds like a abs sensor has gone down or a common problem is the link leads on the front going open circuit it would be helpfull if you get someone to get the fault codes from the abs module, you can check the link leads and the sensors using a ohmmeter i think the sensor resistance should be about 1100 ohms.

May 06, 2013 | Jaguar XJ8 Cars & Trucks

1 Answer

Does abs shutt off four wheel drive

I suggest scanned the ABS module in order to know fault codes stored there; sometimes just need speed wheel sensor adjustemtn, but need the real fault code in there.

Jun 25, 2012 | Ford Cars & Trucks

1 Answer

Runs great but abs lights come on and car stalls

sounds strange cant see abs stalling ur car out abs light coming on normally means ur pump has gone in it and thats 1 espensive repair sounds more like an electrical fault to me good luck tho

Mar 24, 2012 | 2002 Ford Taurus

2 Answers

Pontiac montana - brake, abs and traction control dash lights on

its either sensor gone or the toothed gear on the drive shaft that the sensor picks up off of ,what wheel is causing the problem i have no idea but a test with automotive multi meter will soon locate the fault

May 02, 2011 | 2007 Pontiac Montana

1 Answer

Re;- 2.5 Ford Cougar (2000) ABS and Traction Control warning lights stay on when driving normally.Presume its a fuse gone .Have checked aux fuse board in engine compartment and 60 amp fuse is ok . Can't...

Assuming you have right hand drive cougar, you can access the fuse box right under the glove box under dash. Use a torch and you will find a small pull down clip and when you pul it down it drops the whole fuse box. This is a common problem with Cougars. To my knowledge fuse is not the culprit, however its good to check. Most of the issues are related to ABS module. It is placed in the engine bay where it exposed to heavy vibrations (poor design) and some times the module will crack and sometimes it just electronic issue. Get the car scanned for fault codes and that will tell you what is the exact issue. If it turns out to be the ABS module you can get the module repaired if its not cracked or broken or buy a second hand one from wreckers if you can find one under $100 or $150. New one will cost a fortune. Let me know how you go, I can further assist in getting the module repaired, etc. FYI there is no need to remove or replace ABS unit if the ABS module is faulty. You dont need to touch it at all, just take out the ABS module (ECU).

Jan 19, 2011 | 1999 Mercury Cougar

1 Answer

Abs light on and the computer found steering angle sensor

its on the steeringrack . not a unusally fault. had a skoda here yesterday with that fault ,some times the abs box gone bad , but check with new sensor first .

Dec 05, 2010 | 2003 Volkswagen Passat

1 Answer

Trac off, VSC trac and ABS signal went on while I was driving and won't turn off

Chances are, you have a traction control system that is ABS-controlled, like most vehicles. (The other is transmission-controlled.) For this to occur, an ABS sensor may have gone bad. This will cause those lights to come on and for the ABS/trac system to basically shut down.

You also may want to check the ABS fuse to be sure it isn't something easy (and cheap) like that, which might be at fault.

I hope this helps! :)

Dec 07, 2009 | 2003 Toyota Sequoia

1 Answer

ABS, Traction Control and Park brake light on

If you have abs sensors at the wheels, have them checked. Usually abs & trac control work off these sensors

Sep 17, 2009 | Land Rover Discovery Cars & Trucks

1 Answer

ABS Light is still on, even after I replaced the sensor

it can store one code or all codes at a time.disconnect the battery for 5 min.this will clear the memory.after reconnecting the battery if the abs light comes back on when driving then there is another problem.most times it is either the sensor or the wiring.

Nov 18, 2008 | 1997 Honda Accord

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides