Question about 1998 Isuzu Trooper

Open Question

How to replace cv boot on isuzu 4x4 - 1998 Isuzu Trooper

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 131 Answers

SOURCE: replace a outer cv boot

There are aftermarket boot kits you can purchase. If the tear isn’t bad. You can clean the boot with rubbing alcohol. Then cover with a small amount of RTV. Allow the RTV to cure for at least 12 hours.

Posted on Jul 26, 2008

motor1258
  • 6674 Answers

SOURCE: cv joint replacement 1998 isuzu trooper 4x4

Link below may be of some help? When you get there, pick one closest to yours.

http://www.autozone.com/N,315475/initialAction,repairGuide/shopping/repairGuideVehicleSelect3.htm

Posted on Nov 27, 2008

  • 10 Answers

SOURCE: cv joint replacement 1998 isuzu trooper 4x4

This is a simple job that is why it is not very detailed in your book. Nothing special. Do one side at a time so you have a reference to how to reassemble it. Remove your tire , brake calipers be sure not to stress the rubber brake lines or open the brake lines to air. Remove both upper and lower ball joints. When taking out the ball joints remove the cotter pin and bolt and beat the **** out of the joint for it to release. Then the C/V axles will come right out with a bit out encouragement. You will need a few tools wrenches pry bar hammer. I would buy a Chilton's or a Haynes repair manual for torque specs for reassembly. Good luck and take your time. And unless the axles are making noise you can just replace the rubber boots. Which is alot cheaper.

Posted on Jun 01, 2009

germcelchar
  • 389 Answers

SOURCE: change a cv boot on a 1996 isuzu trooper

First their are two different front axles in 1996 troopers. Isuzu changed the 4wd system from auto lock hubs to drive control axle.auto lock hube are on the older trooper's with the light and wiper switches on the dash. The same way to change both. Auto hub remove the six hex. screws slide off the hub remove the sirclip from the driveshaft. Newer hub has 6 alan-head screw's again remove them then the hubcap then the sirclip on the shaft and slide off the round spacer. Next 4 bolts from the lower balljoint and the brake's. Pull out the hub until it clear's the shaft remove the inner boot clips slide the inner boot out the shaft. Clean the grease from the end of the axle then with your fingernail feel along any of the 3 tracks in the axle and near the outer end of the track you will find a wirelike split ring slide a screwdriver under the ring and lever it off . Pull out the drive clean off the grease. You will see a sirclip on the end of the joint remove it and slide off the joint. You can replace either boot from that end. The outer joint is held on with a snap ring on the shaft inside the joint and is not easily removed need a hammer and drift to drive off the end and when removed its hard to get the snap ring on the shaft back into its place.You can change both boots from this end as well. Cheers

Posted on Sep 28, 2009

  • 25 Answers

SOURCE: '93 Isuzu Rodeo, CV Joint replacement.

unbolt the tie rod end and the lower a arm and it should slide out of there

Posted on Feb 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace rubber cv boot on 1999 Isuzu rodeo


how to , who can, what are all steps. are there special tools?
sure. if the boot is bad, so be the joint, Yah think?
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:
    • Halfshaft from the vehicle
    • Snapring and bearing
    • Snapring and oil seal
    • Mounting bracket
    • CV-joint boot
    • Circlip and inner joint housing
    • Snapring and spacer
    • Inner joint balls
    • Snapring and inner CV-joint
    • To install:
    • Install or connect the following:
      • Inner CV-joint and snapring
      • Inner joint balls
      • Spacer and snapring
      • Inner joint housing and circlip. Add 150 grams CV-joint grease.
      • CV-joint boot
      • Mounting bracket
      • Oil seal and snapring
      • Bearing and snapring
    • Install the halfshaft and mounting bracket to the vehicle.
    • Check the wheel alignment and adjust as necessary.

Jun 30, 2014 | 1999 Isuzu Rodeo

1 Answer

Clicking sound when in 4WD


Of coarse

Anytime a CV Boot tears the dirt & water off the
road ruins the joint & you have to replace the axle,
thus the clicking.

6 months you knew that an didn't care

As they say pay me now or pay more later

Sep 04, 2012 | 1999 Isuzu Rodeo

1 Answer

'93 Isuzu Rodeo, CV Joint replacement.


unbolt the tie rod end and the lower a arm and it should slide out of there

Jan 26, 2010 | 1999 Isuzu Rodeo

1 Answer

Front drive shaft removal for 2001 izuzu trooper 4x4


Under the rubber boot inside the CV joint is a big spring clip round the edge , take this out and then the shaft pulls away from the axle with the CV on it .If you are fitting a new boot cut the old off if not just get the clips off and pull the boot back.

Did you take the shaft out from the wheel hub end too ?

Oct 04, 2009 | 1988 Isuzu Trooper 2 Door

1 Answer

I have a 1999 isuzu 4wd rodeo 6 cylinder and was wondering if Need to install a new boot kit or if I need to replace the entire front left cv axle shaft. I had a tear in my rubber boot and noted some...


Do not try to get the cv axle out ot the axle housing. It is a major operation. Remove boot and disconnect the inner cv joint and save about five hours of time. The choice is yours ,boot or reman cv axle. You will need to take the reman. axle apart to install it though and some new clamps. Not a simple operation.

Sep 28, 2009 | 1997 Isuzu Rodeo

2 Answers

How do i remove cv axle for a 98 isuzu trooper


Go to my profile I have just explained how to change a cv boot on a Trooper. The axle needs to be taken out to change the boot so the same solution. What you call an axle I have refered to as a drive (short for driveshaft) It takes a lot of explaining so save me a lot of writing if you read the solution I gave for changing the CV boot. Cheer's

Sep 27, 2009 | 1998 Isuzu Trooper

1 Answer

Cv joint replacement 1998 isuzu trooper 4x4


This is a simple job that is why it is not very detailed in your book. Nothing special. Do one side at a time so you have a reference to how to reassemble it. Remove your tire , brake calipers be sure not to stress the rubber brake lines or open the brake lines to air. Remove both upper and lower ball joints. When taking out the ball joints remove the cotter pin and bolt and beat the **** out of the joint for it to release. Then the C/V axles will come right out with a bit out encouragement. You will need a few tools wrenches pry bar hammer. I would buy a Chilton's or a Haynes repair manual for torque specs for reassembly. Good luck and take your time. And unless the axles are making noise you can just replace the rubber boots. Which is alot cheaper.

Jun 01, 2009 | 1998 Isuzu Trooper

2 Answers

Cv joints wont come out of diff housing (95 Rodeo 4x4 diesel)WHY


You might have to remove the diff cover and remove the lock rings from inside the diff.

Feb 15, 2009 | 1995 Isuzu Rodeo

1 Answer

Replacing front cv boot


I have been told that you need to take the upper/lower ball joints off to remove the whole spindle assy. Good Luck, I have the same problem.

Oct 17, 2008 | 1994 Isuzu Trooper

Not finding what you are looking for?
1998 Isuzu Trooper Logo

Related Topics:

595 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...