Question about 1995 Chrysler Sebring

1 Answer

How to replace a fuel pump in a 95 sebring

Is the fuel pump for a 95 Sebring in the gas tank. How to replace a fuel pump in a 95 Sebring

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 120 Answers

Yes it is in the tank.....and in some cases, easy access is through the trunk...just lift up the panels and see what's under by your spare tire.....if not, then you will have to drop the tank....
when replacing your tank, do the filter and strainer at the bottom of the pump at the same time..trust me, this will save you a lot of time and money mucking around...
if you're interested in doing the job yourself, then you must put the car on jack stands...locate the tank....loosen the hold down straps...i think they 2 15mm bolts....don't drop the straps right out at this point...undo the clamps holding in the filler tube. with a jack and a block of wood on it, place it under the tank and remove the straps.....SLOWLY lower the jack until the the top of the tank is expose enough to reach the fuel lines going into the pump. with caution not to break any clips or nipples, or lines, remove the two fuel lines going to the pump...there should be a clip there that you need to squeeze in and remove the lines...both are like that...unplug the electrical connector and vent tubes if any.....with a helper, slowly remove the tank from the filler neck tube and lower the tank...once tank is on floor, allow for lots of ventilation...there should be a locking ring holding the fuel pump into place...undo the locking ring, by either using a hammer and BRASS punch or if its a plastic ring, big pair of channel lock pliers.....remove and the pump will come up slightly...remove pump from tank, careful not to damage the level sender. very carefully remove from tank.....once out drain excessive fuel into the tank and remove strainer....and install new one....its very important you replace the strainer with your new pump....and new fuel filter as well...okay? good luck..

Posted on Nov 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ran out of gas now wont start 2001 sebring?


I assume you put fuel in the tank. This car uses a small high pressure fuel pump to pump gas to the engine, this pump is located inside the fuel tank, the tiny pump depends on the gas it sits in for cooling and for lubrication, if you run out of gas you quickly damage the pump, in fact any time you run below 1/8 tank you cause it to run hot, so you might get away with running out of gas once or twice by you always run the risk of the pump freezing up from lack of lubrication and cooling when you run out of gas, which is what you have likely done.

Jun 07, 2012 | 2001 Chrysler Sebring

1 Answer

Changing fuel filter on 1996 sebring convertable


Hi Mike I'm glad to help!

Mike the only way to change the fuel filter on a 96 Sebring is to drop the gas tank and change the fuel pump. Hope this helps and have an awesome day Mike.

Mar 11, 2012 | 1996 Chrysler Sebring

2 Answers

Were is the fuel pump at on a sebring


FOR SEBRING COUPE YOU CAN REMOVE REAR SEAT CUSHION.YOU WILL SEE ACCESS COVER ON TOP FUEL PUMP.REMOVE ACCESS COVER YOU WILL SEE FUEL PUMP MODULE. SEBRING CONVERTIBLE YOU HAVE TO REMOVE FUEL TANK TO REMOVE FUEL PUMP.

Nov 02, 2010 | 2000 Chrysler Sebring

2 Answers

Fuel pump is bad. need to replace it. do i need an eletcric fuel pump or a regular fuel pump..i hve a 2002 chrysler sebring conv. LX 2.7L


All vehicles with fuel injection use a high-pressure pump mounted inside the gas tank. This is virtually all vehicles built since about 1990. I don't know about this particular vehicle, some have an access panel above the tank that allows you to remove the pump without dropping the tank, others don't. Dropping a nearly full tank of gas is no easy task. Try asking your auto parts store or the Chrysler parts counter if this car has such an access panel.

By the way, the pump is immersed in the fuel, and uses the fuel to cool the pump. Never let your tank get below 1/4 full to reduce overheating of the pump, which shortens its life. Occasionally is OK, but running below 1/4 tank on a regular basis will cut the life of the pump significantly.

Oct 11, 2010 | 2002 Chrysler Sebring

1 Answer

Fuel pump replacement 2004 sebring


it's in the tank and the gas tank has to be removed! car needs to be good and high off the ground!

Sep 18, 2009 | 2004 Chrysler Sebring

1 Answer

1996 Chrysler Sebring fuel pump automatic shut off


It sounds like the vent hose or tube from the fuel tank to the side of the inlet assembly is restricted. It can be twisted or bent. I've seen one case where it was misrouted and smashed against the frame rail. The vent tube allows air to escape while filling with fuel.

Apr 22, 2009 | 1996 Chrysler Sebring

1 Answer

Gas line broken


get a 3/8/or 5/16" pressure collor slide it togather tighen it down it will be as good as new you can get one at any auto parts store hope this is helpful lol and as always thanks for using FixYa

Dec 09, 2008 | 1995 Chrysler Sebring

2 Answers

Fuel filter


fuel filters are usually located under the driver side of the car. it will be a metal cylinder with 2 lines on it. one going to the engine and one coming from the gas tank.

Aug 02, 2008 | 2002 Chrysler Sebring

2 Answers

Replacing the fuel pump on a 2006 Sebring Sedan


look in the trunk there a plate remove the plate the pump is under it remove hose be carefull gaz pressure remove lock and there you go gas pummp is loose good luck pierre

Jun 29, 2008 | 2006 Chrysler Sebring

Not finding what you are looking for?
1995 Chrysler Sebring Logo

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...