Question about 2004 Pontiac Grand Prix

1 Answer

Tested starter roll over but won't with switch 2004 pontiac grand am there juice to the starte testd little wire no juice

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 120 Answers

Well then it sounds as if you need a starter...there's power going to the solenoid, but nothing coming out...replace starter

Posted on Nov 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 Pontiac grand am replaced starter


if your getting a clicking noise at the starter double check for good connections at the starter and grounds as well as the ground wire from the battery to engine. if this is good check the battery condition and load tested. if the battery checks good then you may have just gotten a bad starter.

Oct 10, 2014 | 1998 Pontiac Grand Am

1 Answer

My 2002 gram am will not crank


It the engine does not crank, its not the crank sensor.
If it cranks but won't start, it could be a long list of things including the crank sensor.
No crank could be the starter, neutral safety switch, key switch, or connection in the wiring.

Jul 15, 2012 | 2004 Pontiac Grand Am

1 Answer

1990 HONDA ACCORD WON'T TURN OVER TO START BUT IT WILL ROLL START. I HAVE CHANGED THE ALTERNATOR AND TESTED THE IGNITION SWITCH STARTER RELAY SEEMS FINE CLUTCH SWITCH SEEMS FINE MAIN RELAY IS FINE


About the only thing you didn't mention was the starter itself. You could have it tested. But before that, try to see if you have power on the small wire to starter solenoid on the starter, when key is held in cranking position. Pull the small wire off and check for power with a multimeter or a testlight while someone holds the key in crank. This is the signal wire from ignition switch that closes the elec. contacts inside solenoid so the starter gets full power from the battery to spin. (This wire also is in the circuit with the clutch switch and the starter relay.) If you have power on this wire in crank, it is very likely the starter is bad. If there is no power, check that circuit out. It is losing power somewhere from switch to starter solenoid. Good luck.

Jul 06, 2012 | 1990 Honda Accord

1 Answer

I have a 2002 grand prix gr 4 door and the front driver side window won't roll up. I'm trying to use a jumper wire but do not know which one is the power wire and don't have access to a test...


Pink wire is ignition in to switch / module. Check the door hinge area and the rubber boot where all the wiring runs. Most likly a broken wire or two in that flex joint. Not uncommon.
If none of the above works, most likly the switch may be bad.

Nov 16, 2011 | 2002 Pontiac Grand Prix

2 Answers

2004 Pontiac grand prix gtp won't start- fully


You need a new starter solenoid. It is essentially a heavy duty remote switch that is activated by your ignition key switch. The solenoids get stuck or don't conduct well after 6 to10 years.

May 27, 2011 | 2004 Pontiac Grand Prix

1 Answer

When I Try to start the Car, I have power but the car will not even crank..it just sits silent...i have the radio...dash lights come on...but the engine just does nothing. i had no warning lights...nothing...


The most common problem here would be a bad starter, you can test it with a test light,have someone hold the key in the crank postion while you test foor power at the starter, there are two wires to starter one is a battery cable which should have power going to it at all times then a small wire that has power when key is in the crank postion to spin starter, if it has power then starter is bad, if theres no power then you may have a bad ignition switch or bad neutral safty switch, also try starting in neutral. hope this helps. another trick is while holding key in crank postion tap starter with hammer if it starts then starter is bad,

Sep 13, 2010 | 2004 Pontiac Grand Am

1 Answer

Pontiac starting problem


Need a little clarification to help. When you say the starter would not engage, do you mean it made no noise and didn't spin? I assume this is what you are talking about. Can be a few items. It may be the neutral safety switch (or clutch switch if manual transmission), wiring or the starter. Probably the starter has a dead spot and needs to be replaced. You can try and tap the side of the starter with a hammer and see if that works (if it does replace the starter) Modern starters come with the solenoid attached. Hope that helps. Can help more with a lttile more info.

Jul 15, 2010 | 2004 Pontiac Grand Am

2 Answers

Grand Am wont start or roll over


Is the security light blinking? If not, check the starter.

Mar 12, 2009 | 2003 Pontiac Grand Am

Not finding what you are looking for?
2004 Pontiac Grand Prix Logo

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...