Question about 1993 Plymouth Voyager

1 Answer

Will not roll over . seems like no power to starter

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 770 Answers

Check connections, clean any corrosion. From your battery, the cable goes to the starter selenoid. The selenoid could be bad, the starter could be bad, the wiring could have a problem. You will find your solution withing these 3 components.

Posted on Nov 14, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why won't my 1988 eldorado starter roll when I turn the ignition to start?

If the lights go dim, that means that your battery does not have enough power or you alternator is bad.

Feb 20, 2015 | Cars & Trucks

1 Answer

I have a fs481v 16hp vtwin on a mower and have a starting issue. battery is good

That clicking you hear when try to crank is the starter solenoid. Replace it and roll on.

Sep 24, 2014 | Cars & Trucks

1 Answer

My 2004 Mercury Mountaineer will not roll over, what can it be? I've checked the battery, starter, fuses, wires, and silonoid

You need to check power to starter when turning key you will need 2 people for this if there is none check the ignition switch

Mar 09, 2014 | Cars & Trucks

1 Answer


About the only thing you didn't mention was the starter itself. You could have it tested. But before that, try to see if you have power on the small wire to starter solenoid on the starter, when key is held in cranking position. Pull the small wire off and check for power with a multimeter or a testlight while someone holds the key in crank. This is the signal wire from ignition switch that closes the elec. contacts inside solenoid so the starter gets full power from the battery to spin. (This wire also is in the circuit with the clutch switch and the starter relay.) If you have power on this wire in crank, it is very likely the starter is bad. If there is no power, check that circuit out. It is losing power somewhere from switch to starter solenoid. Good luck.

Jul 06, 2012 | 1990 Honda Accord

1 Answer

Have a 1979 rolls royce that wont start no power to starter???

Verify that there is no power going to the starter solenoid with a multimeter. If no power is found, look at your neutral safety/inhibitor switch. This is a switch on the left side of the transmission that will interupt the starter signal to ensure that the gear selector is in fact in park.

Jul 25, 2011 | Rolls Royce Silver Spur Cars & Trucks

1 Answer

1998 A6 Quattro w/V6. Starter rolls over really slowly initially and if key is held, it rolls over faster and eventually starts. Starter checked out OK

i would have said the bendix is getting stuck in the fly wheelcausing it to runslow if not must be power losesome where

Apr 06, 2010 | 1998 Audi A6

1 Answer

When starting the engine the dashboard lights are flickering and there is a fast clicking noisefrom the starter motor. Could this be the solonoid as there was no problem starting it up yesterday and has...

that is a sign the the starter is not getting enough power to turn the starter over so the solenoid is struggling,have the battery check and possibly replaced or just a good charge may bring it back to life.

Jan 04, 2010 | 1991 Rolls Royce Rolls Royce Silver Spur

2 Answers

2000 dodge durango driver side window problem

I have had to replace three of the four window power regulators in my 2000 Durango. They just seem to stop working within a year or two of each other.

Aug 02, 2009 | 1999 Dodge Durango

1 Answer

Help my 1995 Dodge ram 2500 will not start.

Hi cotboh7 If this truck rolled off the ramp I would check the neutral safety switch. You could also check that the shift linkage is set properly, also back to that starter, sometimes they give no indication at all, this happened to myself recently, parked the truck came out nothing, it was the starter in my case.But that has nothing to do with the truck rolling in park, and the neutral safety switch is for just that purpose, which is why it must be in park or sometimes neutral to start.I hope this helps,good luck to you.

Nov 10, 2008 | 1995 Dodge Ram 2500

Not finding what you are looking for?
1993 Plymouth Voyager Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides