Question about 1991 Acura Integra Hatchback

1 Answer

I need some help my 91 integra the engine to chassis ground wire fried without a warning i dont know why i was trying to started and it just fried it . . earlier today i had installed a new starter and i put everything back how it was . . my question is will this cause any problems on my electrical system? i havent tried starting it again since it fried i have to buy another one . . any guesses??

Posted by on

  • jman415 Nov 14, 2009

    ok but nothing else could of happened since it was just that engine to chassis ground wire that fried up? replacing it should do it with no major problem right?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 373 Answers

Wires can short out from oil or water leaking onto them. replace the wire. one from autozone or from the acura dealership is best.

Posted on Nov 14, 2009

  • Rick Jones
    Rick Jones Nov 15, 2009

    replace the wire, yes. but now i suspect you may have a voltage regulator malfunction. i'd recommend having the alternator tested, you might have too many volts/amps.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you test the PCM module on a 1996 ford ranger 3


Test it for what ? Check engine light on ? Vehicle won't start ? There are videos on youtube ! You would need to know basic electrical testing procedures . You would need wiring diagrams that show what all the wires are for . And realize that beside the main B+ voltage supply's and chassis grounds there are sensor power and grounds which only have a 5 volt reference voltage. You wouldn't won't to short a wrong circuit frying the computer . ECM Inputs and Outputs Diagnosis

Jan 22, 2017 | Ford Ranger Cars & Trucks

1 Answer

I need to know how many wires go to a 1989 ford econoline fuel pump with a 460 efi engine


I suggest check this wiring diagrams for code color wires...


1989 5.0L & 5.8L & 7.5L ENGINE SCHEMATICS

2fa9322.gif




1989-91 CHASSIS (GASOLINE)SCHEMATICS

6dd87e2.gif



1989-91 CHASSIS (DIESEL) SCHEMATICS

1887a7c.jpg


Hope this help.

Mar 23, 2010 | 1989 Ford Econoline

1 Answer

My heater control module keeps going out!


Most electrical problems are caused by bad grounds. Since your battery is grounded to your engine, make sure your engine is grounded to your chassis. I have seen battery terminals replaced and the small ground wire to the chassis was not connected back.

Jan 23, 2010 | 1991 Chevrolet Silverado 2500

1 Answer

Ok so this is my problem my 91 integra GS , i had replaced my starter because it didnt work anymore there was no other problem i changed it and it was working fine nothin happend right away and with no...


the main fuse under the hood is probly blown, pop the hood you should see a fuse box near the fender, open it up and look for the fuse that says main on it chances are it's blown.

Nov 18, 2009 | 1991 Acura Integra Hatchback

1 Answer

I have a 91 integra gs 5spd yesterday when i was driving it after i stopped at a light all of a sudden without any warning it just shut off like if i shiftd wrong but i tried starting it back and it did...


check your timing. i know it's kind of out there but it's a shot. also, check the plug wires and see if you have spark, if not check the 12 volts to the coil, if there is no power to the coil, there must be a blown fuse. check them as well. Use process of elimination. 12volts on coil-no start...maybe fuel related...and so forth and so on. like i said eliminate all varaibles.

Sep 19, 2009 | 2004 Buick LeSabre

3 Answers

I have a 91 integra gs 5spd yesterday when i was driving it after i stopped at a light all of a sudden without any warning it just shut off like if i shiftd wrong but i tried starting it back and it did...


Reading the other comments you will need to confirm power into the coil.Might also be worth checking your timing mark on bottom pulley against TDC on No1 piston and checking against rotor position that it points to No1 lead.Check your wiring for loose or broken wires into coil-module-distributer.

Sep 19, 2009 | 1991 Acura Integra Hatchback

1 Answer

I have a 91 integra Gs 5spd suddenly shut off while driving


cranking over is a good thing

does the 1991 have a crank angle sensor
chase back to coil if no spark at the plugs

if EFI could be fuel pump or fuel delivery at the injectors

check if the efi has a designated fuse in the engine bay cluster



index-rszi4tsbjqhqsbv3rcpjo1i5-4-0.jpg

Apr 06, 2017 | 1991 Acura Integra Hatchback

3 Answers

95 Acura Integra starting problem


This happened to me on a 95 Integra GSR and the entire starter did not need to be replaced, just the solenoid pieces. They get old and worn down and the plunger no longer makes a good connection with them, hence the "click". Replace the solenoid panels and sand the plunger and your good as new. You can find instructions for this on the net, just do a search for it.

May 11, 2009 | 1995 Acura Integra Coupe

3 Answers

91 integra need help


Take it back. They have messed that car up bad. I can't really think of much else to do.

Oct 02, 2008 | 1991 Acura Integra Hatchback

Not finding what you are looking for?
1991 Acura Integra Hatchback Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...