Question about 1995 Volkswagen Golf

1 Answer

My ez go cart (elec)stops and i move rev and forward selector a few times back and forth and it goes again . a newer cart

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Sounds like a contact in the selector is dirty or the selector it self is bad

Posted on Nov 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No 5th or reverse after a mechanic did transmission service


I am guessing that the selector fork has not been tightened up on the selector rail and you are moving the rail back and forth but not moving any gears . Otherwise there would be crunching noises going on.. Take it back to the mechanic and tell him to fix it properly.

Nov 30, 2013 | 1998 Ford Mustang

1 Answer

Renault trafic stuck in second gear


There is one of 2 problems that will give this indication. The first is the gear lever end in the shift rail has moved out of the slot and is behind the slot and not moving it . This can be checked by removing the lever mount from the top of the box and physically moving the shift rail back into the neutral position then replacing the gear lever back into the selector gate and moving the rail again.. The second possible fault is that the selector fork has come loose on the rail and is not moving the gear (just sliding on the rail) If that is the case the box will have to come out unless you can see the selector fork and the lock screws from the top of the box when the lever mount is removed.. If you can move the selector rod forward and tightening up the lock screw then pulling it back to neutral. Repeat until the fork is back in neutral position and lock it up. Most lock screws have a hole and there is wire tied around the shaft to prevent the screw coming loose. If the box has been reconditioned at some time then it is possible that the person doing the job neglected the wire bit.

Nov 28, 2013 | 1993 Mazda 323

1 Answer

1997 Sable Driver Seat Only Moves 2 Inches At A Time


Could be the switch, but it sounds like the motor is going bad. However, I dont know if you tried to lubricating the tracs. Some of these seats are on ball bearings and some on nylon bushings, either way they need to be lubricated once in a great while. Have you tried to help the seat to move by pushing in the direction it is going to see if it speeds up. If so, the seat motor is going out or the tracks are binding up. I hope this helps.

Apr 02, 2013 | Ford Taurus Cars & Trucks

2 Answers

EZGO golf cart won't go forward


Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

Apr 09, 2010 | 1993 Acura Vigor

1 Answer

I HAVE A 1999 ez go cart and we smelled burning


Look under the cart and make sure the wires to the motor are good.

Oct 01, 2009 | 1995 Volkswagen Golf

1 Answer

94 tauras AT once warmed up trans will drop out gear at a stop


This is a common problem. You have a cracked forward clutch piston. Ford made this part out of aluminum. The replacements are steel. But you have to disassemble the transmission to install it. ( I know you said Rev too, In the AXODE trans, the forward clutch is on in 1st and reverse)

Apr 08, 2009 | 2000 Ford Taurus

1 Answer

2008 Toyota Highlander Sport AWD when starting off the engine seems to rev fairly high for very small vehicle movement. At idle engine revs around 1000RPM. Gas mileage is poor,17MPG for about 80% city, 20%...


yes it is normal many customers complain about how the newer cars are not as responsive from a stop basically you have to hit the gas then the car goes seems to rev high to people with not a lot of movement becausse of this its because the newer cars are throttle by wire when you hit the gas it sends a electrical signal to the throttle to go instead of a few yyears back they were you hit the gas and the cable attached to gas pedal pulls back throtttle much more responsive hope this helps

Feb 20, 2009 | 2008 Toyota Highlander

1 Answer

Auto trans when hot don't wont to shift RIGHT!!!


did it change gears before you change the motor

Feb 04, 2009 | 1997 Ford Explorer AWD

Not finding what you are looking for?
1995 Volkswagen Golf Logo

503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...