Question about 1997 Jeep Wrangler

1 Answer

What years will fit on 1997 wrangler - 1997 Jeep Wrangler

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 986 Answers

Anything that is for a TJ will fit your year. TJ was from 1997-2006. There were a unlimited model with a streached wheel base.

Posted on Nov 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Jeep wrangler: The tires loosen up and fly.


Make sure that your wheels sit flat against the hub flange and that the center hole fits the protrusion on the hub. Clean all rust and corrosion from both the hub and the wheel mating surface.
When tightening, use a star pattern, tightening one lug part way, semi-tight, then doing the one opposite it and so on, 'till you are back at the first one. Once all are semi tight, torque each to about 75 to 80 foot pounds in the same pattern. Normally you should not need to do this third step, but drive around normally for about an hour, then re check the lug tightness again with the torque wrench.
Never use a wheel that either does not fit exactly or one that has been damaged at the lug holes by running loose. Make sure all wheel studs are in good condition. Any damaged by a loose wheel must be replaced.
One rule for aftermarket wheels. You need to have at least the same amount of threads inside the lug nut as the diameter of the lug. (a 1/2" stud needs to have at least 1/2" of threaded area inside the nut...more is better)

May 05, 2010 | 1997 Jeep Wrangler

1 Answer

1997 Jeep Wrangler 4wd high disengages


you might try checking the linkage on trans case shifter. may need adjusting. might not be getting fully engaged

Feb 06, 2010 | 1997 Jeep Wrangler

1 Answer

Will a rag top from a 1999 jeep fit a 1995 jeep


no it will not fit according to the application guide i have, 1997-2005 use the same top, 1988-1995 use the same top.

Dec 04, 2009 | 1995 Jeep Wrangler

1 Answer

Instructions for replacing 1997 Jeep Wrangler 6cyl


Its an easy job! Disconnect the battery first! That's very importand! Then disconnect the wiring pack from the ECU. Some models are equipt with snap-systems, other with a screw-system to remove the wiring connector from the ECU. If done, there are three or four screws that hold the ECU in place with the body. Remove the screws and you hold the ECU in your hands. To buy a new or rebuilt ECU, reffer to the numbers shown on the label at your Wranglers ECU in combination with the V.I.N. To connect the new ECU with the wiring pack, be careful with the connector! You need to put him in the right position to connect with the ECU. Do it slow and make sure the connector fits to all points. Otherwise you'll bake some contacts inside the connector.

Oct 23, 2009 | 1997 Jeep Wrangler

1 Answer

I need a factory part Number.


4713193 list price $475.00

Oct 03, 2009 | 1997 Jeep Wrangler

2 Answers

Jeep wrangler bucking


how long has this been happing..one tank of fuel or more, could have been bad gas, replace filter,, put gas dryier in fuel tank..if it continues could possibly be transmission related..the reving down doesn't sound like transmission though if tansmission was slipping it would rev up..good luck

Jun 02, 2009 | 1997 Jeep Wrangler

2 Answers

Location of fuel filter


go to the auto stor efor a speciial fuel filter wrench to slide the fittings off, trust me its the only way to get these things off. just tell them your car type so they can make sure it will fit.

Mar 18, 2009 | 1997 Jeep Wrangler

Not finding what you are looking for?
1997 Jeep Wrangler Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...