Question about 2001 Nissan Sentra

1 Answer

I need to know where the crank position sensor is on a 2001 nissan sentra GXE 1.8L . and which oxygen sensors are which numbers

Posted by on

  • oneoneone84 Nov 14, 2009

    Well My 2001 Nissan sentra 1.8L GXE has 2 banks and 4 oxygen sensors it has 2 catalytic converters on exhaust manifold

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

It is wher the engine meets the transmission..on the flywheel...and the oxygen sensors bank 1 is the one before the catalyst....and bank 2 is the one after the catalyst....

Posted on Nov 14, 2009

Testimonial: "Well my 01 sentra 1.8L GXE has 2 banks, 4 oxygen sensors, it has the 2 catalitic converters on the exhaust manifold"

  • bmontandon65 Nov 14, 2009

    yes...once you check the codes with an OBDII scanrer it will tel you wich banks, either left or right....so right side bank one will be the o2sensor on the rigt side of the vehicle before the catalyst...

    and right side bank 2 will be on the right side aft of the catalyst....got it....so check for codes with an OBDII scanner....in autozone or advance autoparts...you can borrow one and get the codes....

    hope this clarification helps...

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 Nissan sentra GXE has a code p0350


call nissan give them the vin number thers a recall on the cam and crank sensors do that first
if the recall has been done and ther are no sensor codes find the missing cyl.move the coils around to see if the mis follows if not check batt volts green/white wire good ground at the black/yellow wire after that you need a lab scope to look at the wave pattern of each coil.ther should be 2-4 volt sawtooth pattern all the coils should look abought the same.

Feb 12, 2012 | 2002 Nissan Sentra

2 Answers

Troubleshooting the cam and crank sensors


These are a well known failure point for this vehicle and engine. They are currently on there third redesign to help solve the frequent failures.

the first thing to do is see if there are any trouble codes in the computer. If you see P0340

Jan 18, 2012 | Nissan Sentra Cars & Trucks

1 Answer

2002 nissan sentra gxe 1.8 bank2 sensor1 federal emission.Which sensor do I replace?Top/bottom,driver/pass side?


The 1.8 is a 4 cyl. engine . it has only 2 oxygen sensors . Nissan engine controll systems devides its EGO sensors into banks . Bank 1 is the upstream (top before the catylyctic converter) . Bank 2 is the downstream (after the cat. conv.) I recomend you change both for emissions reasons

Jan 15, 2010 | 1996 Chevrolet K1500

2 Answers

2001 nissan sentra xe p1320, p1140 codes car intermittenly looses power, when started in the morning while cold car runs fine until operating temp.


Distributer Signal Output is code p1320........Intake Valve Timing Control Position Sensor Bank1 is code p1140...

Oct 19, 2009 | 2000 Nissan Maxima

1 Answer

Crank sensor position location


Follow your plug wires to coil pack and module. Once you found the module, follow the wires from there to crank sensor on engine block.

Aug 06, 2009 | 2001 Nissan Sentra

1 Answer

PO300 and PO430 codes for a 2001 nissan sentra GXE


Check fuel pressure it should be 34psi and with vaccum removed from regulator it should be 43psi. Low fuel pressure can contribute to misfires.

Jul 25, 2009 | 1996 Nissan Sentra

1 Answer

2002 Nissan Sentra Loses Power


SERVICE IT .....OIL PLUGS, AIR ,FUEL AND OIL FILTERS GET TROTTLE SENCOR AND THE MASS AIR FLOW SENCOR CHECKED

Jun 29, 2009 | 2003 Nissan Sentra

1 Answer

Can't find the location for the crankshaft position sensor


you need a haynes manual . because crank sensor can be behind crank pulley or on bottom side of engine that why you need a manual save you time.

May 13, 2009 | 2002 Nissan Sentra

Not finding what you are looking for?
2001 Nissan Sentra Logo

Related Topics:

379 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...