Question about 1997 Mercury Tracer
I have a 1997 Mercury Tracer; radio and climate cotrols were stolen (ripped out). Got climate switch (Heat and A/C selector), fan switch, and temperature control for the device. there was one plug which connects to the upper portion of climate switch. There are four spade connectors on the bottom of that switch and four like spade connectors on the fan speed switch. Is there supposed to be a cable/connector which goes between these two switches which would allow the fan to work?
If the blower motor has a problem, check voltage and ground circuit. In the diagram, top wire for blower motor is voltage, the bottom wire is ground. If good voltage and ground, then suspect the blower motor has a problem. You can see the fuse and circuit breaker, not only check them, use a test light and voltage on the circuits. Your blower resistor and control assembly are on the ground circuit, you can bypass those to see if problem on ground circuit? I know I didn't answer your question, but, I don't know what testing you have done?
Posted on Jun 03, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: ignition switch
To install, reverse the removal procedure. Check for proper operation of the ignition switch.
Posted on Nov 04, 2008
Hey there MSM,
Posted on Dec 14, 2008
SOURCE: 1993 mercury tracer
To replace the headlight on a 1993 Tracer you must turn the black plastic retainer ring counter clockwise and then pull back gently. The ring and bulb should then slide out toward the engine.
Carefully grab the sides of the plug and pull the bulb out.
When replacing the bulb make sure not to touch the glass part or it will cause the bulb to burn out sooner. Place the black ring back over the bulb with the open end towards the glass part of the bulb. Fit the wiring onto the back of the bulb and insert the bulb back into the reflector. The black plastic ring has notches that fit over protrusions. Turn the black ring clockwise and your done. Test the headlight. Happy Driving
Posted on Jan 28, 2009
The blower speed controller is located under the hood on the right or passenger side on the heater housing just to the side of the heater hoses near the very back of the right cylinder head.
Yes that would cause the concern you are having.
Posted on Feb 05, 2009
Tips for a great answer:
Oct 11, 2015 | Mercury Cars & Trucks
Feb 16, 2012 | 1997 Mercury Tracer
Jan 09, 2012 | 1997 Mercury Tracer
Jul 21, 2010 | 1997 Mercury Tracer
May 23, 2010 | 1997 Mercury Tracer
Aug 05, 2017 | 1997 Mercury Tracer
Jan 13, 2010 | 1997 Mercury Tracer
Jul 18, 2009 | 1997 Mercury Tracer
Aug 10, 2008 | 1989 Mercury Tracer
68 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: