Question about 1991 Chevrolet Lumina

1 Answer

Replacing gas lines my gas line rusted thru under the driver seat is there an easy way to replace gas line

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Chevrolet Master
  • 2,030 Answers

Yes
get some steel line of the same size and 2 compression fittings cut out all the bad section till you have good clean lines on both ends and splice a new piece in.

Posted on Nov 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How easy is it to replace a leaking brake line under the driver's side door on a 1995 oldsmobile cutlass ciera?


In most cases on these older GM vehicles it is much easier to replace the lines from the master cylinder all the way to the rear wheels. You should be able to find brake lines that are preferred and have the correct fitting for what you need to do. Compression fittings are a definite No No!

some things to check ahead of time.
1. Do all the bleeder screws open? If not you may be replacing wheel cylinders and calipers.
2. Are the brake hoses cracked? If they are might as well replace them at the same time.
3. Are the pads and shoes in good shape. If they are getting thin might as week replace them as well.

Just about every GM that I get in the shop with rusted brake lines to the rear end up with a $800 +/- bill. 3 hours labor, 20+ feet of line, proportioning valves (later models), fittings, wheel cylinders. And a bleed and flush.

The lines don't have to look pretty they just have to work!

good luck and let us know how it goes.

Sep 19, 2014 | Cars & Trucks

1 Answer

I have a rover75classic 54 it is leaking water when it rains on near side is it a useual fault


Had same problem. Lift up rear seat on drivers side and you will see a steel tube running from the wheel arch under the seat. Tube is about 2 inches wide. If this is rusted underneath then water is getting via the wheel arch open end of the tube. It runs into the rear foot well and forward into drivers footwell, also runs under rear seats and into the boot! I removed the rear drivers side wheel, pulled away the plastic wheel arch lining then sealed the hole where the wiring leads through this pipe. Covered it with plastic flashing replaced the wheel arch lining. Took 30 mins to repair, took a week to dry the carpet, rear seats and boot carpet.

Jan 20, 2013 | 2000 Rover 75

1 Answer

2004 avalanche z71, gas leaking from under driver seat


replace fuel filter and fuel lines.They look very rusted and may be a danger.

Oct 04, 2012 | Cars & Trucks

1 Answer

Small pin holes i gas line under driver side door How can i seal it without changing line


You can cut out the rusted sections and replace them with rubber fuel injector hose and be sure to use two hose clamps on each end.

Feb 04, 2012 | 1993 Jeep Grand Cherokee

1 Answer

Gas leaks out on passenger side right under the driver side back door


fuel line leak-have to get it on a lift asap, it could be as easy as a split or dryed out rubber line or a rusted through metal fuel line-no matter what, you do not want to let this go long.

Jan 26, 2011 | 1996 Oldsmobile Bravada

1 Answer

1994 explorer limited 1) left rear drivers brake line leaking out of sight up high by wheel well and gas tank any pics or diagrams of what the lines look like there(where they connect,bend etc...2) It has...


If it's a rusty brake line that's leaking you'd best replace the whole brake line system (all 4 wheels) for your safety. Fuel lines have the same problem. These are made out of steel and rust fast due
to calcium chloride used on the roads in winter.
Unless you're familiar with routing and installing connectors on these lines I suggest you let a pro do the job. It ain't as easy as it looks.

Jan 03, 2011 | 1994 Ford Explorer Limited

1 Answer

Gas all over the place


check under car for broken or rusted out gas line or hole in gas tank. if line is leaking replace with brake line of same size can be temporaly clamped togeather with neoprime rubber hose.and small hose clamps.

Nov 20, 2010 | 1995 Chevrolet Cavalier

2 Answers

Gas dripping by driver door from underneath


b0781a0.gif
The fuel filter is located under the vehicle, along the frame rail on the passenger side —1992-98 vehicles

Check your fuel line connections in the engine compartment for leaky connectors

d493b56.gif

Dec 01, 2009 | 1994 Mercury Grand Marquis

1 Answer

Chevy avalance brake line diagram


Left front weel wobling mechanics says it needs new roters $600

Oct 09, 2009 | 2003 Chevrolet Avalanche

Not finding what you are looking for?
1991 Chevrolet Lumina Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...