Question about 2001 Volkswagen Passat

1 Answer

I have an icon that is a picture of a car with a screw next to it.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.


    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 138 Answers

That is your Anti Theft Immobilizer warning light.

Posted on Nov 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of ac heater resistor on 1995 Cadillac. DeVille

It's right next to the blower motor,2 screws hold it on,here's a picture of it,easy to replace. GET 25 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS

Nov 05, 2014 | 1995 Cadillac DeVille

1 Answer

Stabilitrack icon comes on frequently whilte drivin, turn ignition off and itdoes not appear again. Driving the next day it likely will. Is there any harm while driving with the icon on?

Probably going to be the steering wheel position sensor. Keep track of how you park, keep wheel straight when you park will keep the light off. Most of us just live with it and park with wheels straight.

Aug 02, 2017 | 2008 Chevrolet TrailBlazer LT

2 Answers

Blower motor relay

You have a blower motor resister which is next to the blower motor,easy to remove,just 2 screws,here's a picture of it.Here's where you blower motor is.

Sep 24, 2013 | 1990 Nissan Pathfinder

1 Answer


Here's a picture of the blower motor resistor,easy to remove,disconnect electrical connector and remove two screws,it's located next to blower motor which is under glove box.

Jan 19, 2013 | 2003 Kia Spectra

1 Answer

Dropped ipod into kia sportage 2005 console. How do i take it apart to get it out.

This is a pretty easy fix, you will need to disassemble the council. here's what you you'll need;

A multi tip screw driver (or a philips head and a flat head.
A set of small 1/4" socket set and a ratchet (accordingly)

Now the meat of the situation. open the glove box and there are a few screws there. remove those screws. next there are on the driver side, a few caps remove them with the flat head (being careful not ot mark them up or break them) there you will expose some more screws or bolts. you will need to remove them as well. next there are a few covers that you will need to remove that will expose more screws or bolts. remove those as well. and once all those bolts are removed you should be able to lift the center council up. and expose the.
this is a picture of the passenger side. I couldn't find an image of the center council but if you hunt around you should be able to find the 4-6 screws that hold it down.

Apr 20, 2011 | 2005 Kia Sportage

1 Answer

How to remove inside door panel

It is not so easy to remove as it costs too much if the interiors been damaged..
I send you some pictures on how to remove your interior panel.. Please notice to proceed with caution..
First of all you need two screws with one flat and another as sharp type..
Now see the first picture:
The places marked with red are going to be removed first..
To avoid damage you can use glass tape sticker as it prevents minor scratches..
Can you see a small circle straight to the screw..
Remove it as shown in the following picture..
You can pull it with hand after screwing..
Then proceed to all the red spots and remove it..
Its little tough to remove the handle of the interior so follow the steps shown to remove the handle..
Do it exactly as shown on both sides up and down of that part an you can see its removed on next picture..software_gur_4.jpg
Now go for the green parts and remove the screws and you can also remove the rubber part in the wind shield as shown in picture..
Then proceed removing all the green and yellow parts and check it once that if you have removed all the parts marked in red and green..
If its done correctly your interior will be removed and you can see wires if you have made a speaker attached to the interiors..
Please i request you to rate on fixya if i am helpful..
Also i upload the full photos on my next comment..

Dec 28, 2010 | 1997 Toyota RAV4

2 Answers

Need a sepentine belt routing diagram for a 1995 bmw 740I...

Any good auto parts store has a serp belt routing picture chart for each car

Aug 12, 2009 | 2007 BMW 750Li Sedan

1 Answer

Rebuilding 1987 wrangler engine, however past owner removed most of the pollution hardware, many open hoses blocked off with screws, need to know diagram of hoses

chiltons book has some of that info, next choice would be finding one similiar and take some pictures and dealer has them ask for photo copies

Jul 06, 2009 | 1987 Jeep Wrangler

2 Answers

2001 toyota camry dashboard light

that is indicating one or more of your rear lites is out. ck carefully including brake lites.

Dec 04, 2008 | 2001 Toyota Camry

Not finding what you are looking for?
2001 Volkswagen Passat Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

79847 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides