Question about 2001 Dodge Ram 2500 Truck

2 Answers

I have a 2001 1500 dodge ram it has no heat replaced heater core water pump thermostat radiator. I just blows warm air. what do I do now?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Are heater inlet outlet mix valves standard for all dodge heater cores. I have 2001 dodge cummings blows warm air not hot when gauge is 195 degrees would there be a mix valve under the dash because it is not inline outside the wall

Posted on Nov 19, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

Chk your mix valve.this controls the water flow to your heater core. follow your heater hoses. should be inline and have a cable or vacuum hose hooked to it

Posted on Nov 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 Dodge ram 1500 5.7. Luke warm heat


are you talking about your heater core for heat in the truck ? is there a valve in the heater hose that you have to open to get the hoses hot to the core this is under the hood , follow the hoses , could be clogged core , does it over heat , or get up to temp should be about 190 normal temp for most motors why did you change these parts anyhow , did you use the radiator fix bars leak stuff that you put in , bars leak , if so you may have clogged your core , take the hoses off the core and blow it out ,pain in the but you went this far , ck for that valve to open

Mar 07, 2015 | 2004 Dodge Ram 1500

1 Answer

After replacing the thermostat, radiator, and


The most probable cause would be a plugged heater core. Flush the core out with fresh water, and blow it out with air, first one way, then the other way.

Jun 17, 2011 | 1998 Dodge Stratus

3 Answers

No heat , replaced radiator , water pump, rad. cap , hoses and flushed system twice.blows cool air.whats left?


Thermostat.? if you haven't? Do it first then try it. While the car is running for a while touch the heater hoses that lead to the firewall. if one is cold and one is hot? You have a blocked Heater core. Follow the hoses back to the engine. Unconnect them both. By using a garden hose flush out the heater core do one side and then reverse by doing the other hose Lots of junk will come out so be care ful. Mistake people make is "Flushing the system" That doesn't mean your flushing the heater core.
Seeing that you have done everything else it could be the thermostat which you didn't list or the heater core being clogged. When you finished installing the thermostat and flushing the heater core out. Replenish the coolant system . If you have a bleeder on the thermostat housing? use it . loosen it and top off the fluid until you see fluid comeout of the bleeder. The system being air bound would cause no heat..

Jan 10, 2011 | 2000 Buick LeSabre

1 Answer

The heater will not blow warm air until you start driving. The fan blows but its cold air. Once you start driving the air turns warm. Why?


There may not be enough coolant in the system. What happends is the heating core is nothing more than a small radiator inside the car. If the fluid is low the heating core is empty. But once you start driving the water pump works harder and fills it up. Another possible cause is a sticking thermostat. If its stuck open the engine cant retain water to heat it up. Thus blowing cold air. Whith the engine cold remove the radiator cap and check your coolant level. If it is full a replacement thermostat may be needed. HTH and dont forget to rate.

Dec 06, 2010 | 2003 Dodge Stratus

2 Answers

I have a 1996 Dodge Ram 1500 with very little heat. The lines get hot going to the heater core, but I do not get enough heat out to keep the cab warm. I contacted heatertreater, but my hot cold control...


I have the same truck, I have flushed the radiator both ways, flushed the heater core both ways flushed the engine four times, I have owned this truck for eight years and still cannot get it to heat up the cab. It will keep the windshield defrosted but that is all. If you find any tricks to fix this let me know PLEASE

Nov 15, 2010 | 2000 Dodge Ram 1500 Truck

1 Answer

My 1998 dodge ram 1500 heater wont blow hot air I replaced water pump ,thermostat and radiator blower works fine just no heat.


check to see if both heater hoses are same temp when engine is at normal running temp if not heater core not flowing coolant may need to flush also make sure it does reach normal temp around 200

Jan 31, 2010 | 1998 Dodge Ram 1500 4WD

4 Answers

Dodge Ram 1500 - I have no heat. Will replacing the thermostat slove this? If so how do I replace the thermostat?


Hello, No! I'm assuming that the temp gauge is working in truck & you are not over heating. On the passenger side firewall check both hoses going to/from heater core. If both are not warm then it is probably a heating core plug. You will have to replace the heater core.

Jan 06, 2010 | 1996 Dodge Ram 1500 Club Cab

1 Answer

2002 dodge 1500 Changed radiator, thermostat, and hoses. No heat


Why was radiator replaced?Did it have heat before ? If it was plugged, the heater core may also be plugged. Try flushing it with a water hose in both directions. I dont know why the botton radiator hose would be cold, the radiator should be a uniform temp and the air coming through the radiator should be HOT, when the engine is at operating temp. What condition was the old coolant? if it was rusty, the water pump may have lower flow than normal.

Nov 19, 2009 | 2004 Dodge Ram 1500

1 Answer

No heat just warm air


I think you are on top of your problem,,you dont need any one elses advice.
Complete rebuild of the cooling and heating system,, simple.

Jan 19, 2009 | 2001 Oldsmobile Alero

1 Answer

Heater not working correctly


you might have a blocked heater core,the core looks like a mini radiater

Dec 17, 2008 | 1999 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

2,964 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...