Question about 2002 Dodge Caravan

1 Answer

My blower only worked on high and would turn off sometimes and not come back on. So, I checked the fuse and the relay that is located with the other fuses and relays. They were fine, so I replaced the resistor. Now, I can change the speeds. BUT.....the motor still cuts out and won't come back on. Wait a while, and then it will work again. I heard about a module that might be causing the problem, but I don't know where it is located.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 74,896 Answers

U are going to have to replace the blower motor, the brushes in the motor are worn out.

Posted on Nov 13, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: 2003 Chevy Malibou RU872 resistor location blower switch relay

resistor is under dash passager side 7/32 socket thanks pierre

Posted on Oct 19, 2008

johnny5846
  • 379 Answers

SOURCE: 1992 cadillac deville - hvac blower motor does not shut off.

replace the relay , when a relay sticks like that , a good test is to slap it with something like the handle of a screw driver , see if it un-sticks , its not a fix , just a test . cheers'

Posted on Jan 13, 2009

  • 7 Answers

SOURCE: Blower motor stopped working.

ok to the left of the steering wheel by brake pedal remove fuse panel and look for no. 3 location blower relay after that your going to look for no. 8 blower fuse 40amps after that look for no. 28 its a 10amp fuse this is blower coil relay but if you have puddle lights that fuse is good also runs them !! Hope this helps you out !! Rick from nwi auto acdelco & ford parts dealer !

Posted on Mar 04, 2009

  • 24 Answers

SOURCE: 2001 Saturn L200 Sedan blower motor relay location

it's by the firewall pass side in the plastic blower box. Multi wire plug and two screws are showing.

Posted on Jul 22, 2009

  • 333 Answers

SOURCE: 95 volvo 850 blower problem

It is the resistor that is causing that.

It requires replacement, attempting to repair it is not advisable.

The resistor is bottom connector (h2) in the picture:
f1eb76a.gif

Posted on Sep 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Intermittent air conditioner


It's difficult to pinpoint intermittent problems...especially without seeing the van. What year is it? Does it have rear A/C? What were your pressure readings?

Aug 27, 2014 | Chrysler Town & Country Cars & Trucks

1 Answer

NO AIR


I doubt its a relay.
The high blower relay only comes into play on the high setting. You have a 40amp fuse for the blower relay, then a 30amp fuse for the other speeds. The 30amp fuse powers the fan switch, when you turn it to high it activates the high speed relay.
I would check for power at the blower motor on all speeds.

Jul 11, 2013 | 2005 Chevrolet Silverado

1 Answer

My fan blower works only on high


This may help. 10A fuse 6 and 10A fuse 12 in the passenger compartment junction block protect the blower. While you're at it, check 10a fuse 25 which protects memory power in the A/C control module. The 10A BLOWER fuse in the engine compartment junction block applies 12V power to the blower relay, not the high blower relay which, from your description, is working. If the fuses are OK, the blower relay is suspect. Also, the A/C control module may be defective.

Sep 12, 2012 | Hyundai Motor 2005 XG350

2 Answers

2005 jeep AC and heater blower only high speed works


check fuses, then wiggle speed control while moving, may need new dash control for lower speed, usually high speed works through relay may be the reason high speed works

Nov 03, 2010 | 2005 Jeep Grand Cherokee

1 Answer

2005 Trailblazer EXT. Blower speed control not working...


Problem with blower motor is the blower motor resistor. They are usually located next to the blower motor, a couple of screws and a couple of plugs and your done. Autozone sells them for around $30 each. Wipers you may want to check for relays under the hood in the fuse block. There may be 2 relays 1 for low and 1 for high. I have switched relays from other working accesories and got wipers to work. Sometimes bad connection.

Mar 19, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

What is the location number on a a/c fuse on the


If you don't have your owners manuel to find the fuse/relay location, you can go to flmowner.com and at no cost look at your owners manuel online.
If the fuse/relay is good the possibilities are the switch or the blower motor, with the blower motor being more likely.
If your blower works on high only (maybe not your case, just fyi), the problem is likely the blower motor resistor.
I hope this is helpful.

Mar 17, 2010 | 1997 Ford Econoline

1 Answer

Front blower dont work but back blower works


First Check the Front Blower Relay located in the IPM Fuses and Relay box in the Engine Compartment. There should be individual Front and Rear Blower Relays. The Identification and Location should be on the rear of the IPM Cover. If not check your Owner's Manual.
Switch these two Relays and recheck operation of the Front and Rear Blowers again. If the Front now works and the Rear does not, then the Relay was bad and needs to be replaced.
However the most common problems I have found is that the Front Blower only works on High. Is that the Case? Check it to be sure. If it only works on High then it is 100% the Resistor that is bad and needs to be replaced. The Front Blower Motor Resistor fail in these more often that the Blower Motor itself.
Remove the Dash Glove Box out of the Dash to gain access to the Resistor.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.Com!

Feb 16, 2010 | 2004 Dodge Grand Caravan

1 Answer

Have lost fan to heatr and ac...where is the fuse box or diagram?


1. Does the Blower work on High (or #4) only? If so then it is not the Front Blower Motor or the Relay that is bad, but it is the Resistor which is located behind the Glove box. Follow step #a. below and take out the Glove Box to access. It has 3 to 4 wires going into it. The wiring path is: Switches to the Resistor and then to the Motor.
2. The Front Blower Motor Relay is located in the IPM - Fuse and Relay Center. It is located in a box within the engine compartment. However: (restated) IF the Blower does only work on High then this Relay is good and you should only replace the Resistor Only. The Identification and Location of the Relays and Fuses is located on the back side (inside) of the IPM cover. Remove the cover. The Front Blower Motor Relay is the same Type (size and shape) as several other Relays in the panel. Switch out the Front Blower Motor Relay with a non-engine operation Relay for a function that you know works. Recheck the operations of both functions. If the Front Blower Relay now works and the other function now does not work, it was the Relay was bad and needs to be replaced.
a. Disconnect the Negative Cable from the Battery and wait at least two (2) minutes to deactivate the Airbag Sensors.
b. Remove the Glove Box.
c. Disconnect the Electrical Connection.
d. Unbolt/Unscrew the bolts/metal screws and remove the Resistor.
Installation is reverse of above.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Jan 19, 2010 | 2004 Dodge Caravan

1 Answer

Fan only works on 4 and 5 settings? Is this a


Hello,

I have a 2003 Chevy Cavalier. The HVAC airflow dial only works on high setting. We checked the fuse and it's o.k.

What now?  Any estimate as to repair cost? 

Thank you

Sep 07, 2009 | Chevrolet Malibu Cars & Trucks

Not finding what you are looking for?
2002 Dodge Caravan Logo

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...