Question about 1995 Honda Civic

4 Answers

I think i need to replace the ignition coil in my 1995 honda civic, only problem is i dont know how to

Posted by on

  • 1 more comment 
  • jdatnip21 Nov 13, 2009

    its got the 1.6 in it

  • yadayada
    yadayada May 11, 2010

    thanks for that, will try to look that up, get back to u later. If u can't wait use the Premium question option.

  • yadayada
    yadayada May 11, 2010

    what engine do u have?

×

Ad

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Honda Master
  • 426 Answers

This is for PGM-IG ignition coil type, there is also electronic ignition igniter on the distributor type.

  1. Disconnect the negative battery cable.
  2. Remove the distributor cap retaining screws and remove the distributor cap and seal. Slide off the leak cover.
  3. Remove the two screws that retain the BLK/YEL and WHT/BLU wires from the terminals in the distributor.
  4. Remove the screws that retain the coil and remove the coil from the distributor body. To install:
  5. Install the coil in position and tighten the screws securely.
  6. Reconnect the two leads and install the leak cover.
  7. Install the distributor cap and seal.
  8. i think i need to replace the ignition coil in my - 212d9d4.gifd22041b.gif

Posted on Nov 13, 2009

Testimonial: "thanks man!!! "

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

1995 honda esi automati transmission hard to start when cold, what should i do?

Posted on Jun 20, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Honda esi hard starting when engine is hot only

Posted on Apr 29, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Posted on Nov 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

93 Honda Civic DX not getting any spark


its most likely the distribuator igniter

Jan 15, 2013 | 1995 Honda Civic

2 Answers

Where is the ignition module located on 2004 honda civic lx


I searched under 'ignition module' on autozone.com and 'no parts for ignition module' turned up.
I looked under DIS or Distributorless Ignition System and found the coils are inserted in the top of the engine and this tells me that it's likely that the ECM or PCM controls the spark on these cars.

Civic
1.7L Engine

  1. Disconnect the negative battery cable.
  2. Remove the ignition coil cover (A), disconnect the ignition coil connectors (B), then remove the ignition coils (C).
  3. Installation of the ignition coils is the reverse of the removal procedure.

    0996b43f8020624a.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Remove the ignition coil cover (A), disconnect the ignition coil connectors (B), then remove the ignition coils (C)

Jan 24, 2011 | Honda Civic Cars & Trucks

2 Answers

1995 honda civic constantly needs spark plugs replaced (every other month) or car will not start.


Are they fouling out? Too much fuel making them load up? Or is a weak coil causing them to fail when the car sucks in more fuel under load?

Have your coil tested at a parts store or take it to a mechanic and have it given the once over.

Leaky injectors could be fouling them out too. If you coil checks out you may want to pull the injectors and have them leakdown tested.
This involves taking the injectors off the engine so you will probably want a mechanic to do this for you as well.

1995 Civics are great cars. My friends gets over 40 mpg and still has lots of spunk!

Good luck and be careful.

Mar 03, 2010 | 1995 Honda Civic

1 Answer

Honda civic(98) no start


there are two blue wires at the module one is out put to the tach the other is coming in from the coil if this wire does not have 12v coming in with the key on check for 12v on both sides of the coil with the key on you should have 12v on both side if you dont swap outt the coil ( but normally in this case when you dont have spark your crank sensor is bad )

May 29, 2009 | 1998 Honda Civic

1 Answer

1988 honda civic 1.5 l engine turns over but will not spark or run,new spark plugs,roter,and cap still no spark


well if this is the model i think it is you have pgm ignition. you have an ignition coil , ignitor unit, ground wires all(corrosion) left to check.
coil testing
  1. With ignition switch OFF, remove the distributor cap.
  2. Remove the two screws to disconnect the BLK/YEL front terminal A and WHT/BLU from terminal B of the coil.
  3. Using an ohmmeter, check resistance between terminals. Replace coil if resistance is not within specification.
  4. Check that the primary winding resistance between terminals A and B is 0.3-0.5 ohms.
  5. Check that the secondary winding resistance between terminals A and the coil tower is 9,440-14,160 ohms.
  6. If not within specifications, replace the coil.

unit testing
    1. Check and service any Honda engine codes before proceeding.
    2. Check the No. 32 50A fuse on 1985-91 models, or the No. 39 50A fuse on 1992-95 models in the dash fuse box before testing.
    3. Remove the distributor cap, rotor and the leak cover.
    4. Disconnect the wires from the igniter.
    5. Turn the ignition switch ON.
    6. Check for voltage between the BLK/YEL wire and ground. If there is no voltage check the BLK/YEL wire and ignition switch.
    7. Check for voltage between the WHT/BLU wire and ground. If there is no voltage check the WHT/BLU wire and the ignition coil.
    8. Check the continuity between the WHT wire and body ground. Service the wire or connectors as needed.
    9. Check for continuity between the BLU wire and body ground. If no continuity check the wire and connectors between the igniter unit and the
tachometer or the A/Trans control unit.

after these things let me know if problem persists
    1. If any tests were not passed, replace the igniter unit.

Mar 07, 2009 | 1988 Honda Civic 2 Door

2 Answers

95 civic with turbo 94 delsol v-tech motor. no spark!!


check if the distributor is good or it could be your msd try installing stock coil and distributor.



good luck.

Nov 02, 2008 | 1994 Honda Civic Del Sol

3 Answers

95 honda accord V6 tachometer jumping and cutting out.


I had the same problem with my 1995 Honda Accord V6 2.7L a year ago. It was a pain to have Honda diagnose the problem because it was intermittent and every time I took my car in to the dealership they said they couldn't reproduce the problem, but the longer you wait the more frequently your tachometer will fluctuate. I finally stopped by the dealership when the tachometer was jumping and they were able to diagnose the problem. In my case there was a faulty resistor in the ignition coil, but the entire ignition coil needs to be replaced. I don't know anything about cars but I know this fixed my problem. I went directly though Honda's service center so I know they charged me more than an independent repair shop but I'm looking at my invoice now and I paid $150 for the ignition coil and $200 for labor. After Honda diagnosed the problem I searched for "1995 honda accord ignition coil tachometer" and found that other people had the same problem and replacing the ignition coil was the fix. Hope this helps.

Oct 04, 2008 | 1995 Honda Accord

3 Answers

I have a 1994


hi all i have is it won,t turn over if you can give me more details i will help yates210456

Sep 27, 2008 | 1994 Honda Civic Del Sol

1 Answer

Ignition coil for 1993 civic


best way to test is connect to car and see if it gives spark with engine turning, because it gets ground pulse from the distributer,if pulse id not coming to ignition coil, then you need to change distributor.

Aug 18, 2008 | 1993 Honda Civic 4 Door

Not finding what you are looking for?
1995 Honda Civic Logo

955 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...