Question about 1998 Toyota Corolla
Code P0441 and P0446. What does it mean on a Toyota Corolla?
Both codes are with the EVAP SYSTEM, there are numerous items it could be. A repair shop that does Toyotas or the delaler would be the best to check it out for you. Its not anything that will leave you walking or disable the car.
Posted on Nov 13, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
These codes are all for the Evaporative Emissions System.
P0440- Evaporative emissions system fault- just saying there's something wrong with the system.
P0441- Evaporative emissions system- Incorrect purge flow- saying that the system isn't purging the raw fuel vapors (hydrocarbons- HC) as well as it should.
P0446- Evaporative emissions system- Control valve circuit low- there is a valve, usually located on the charcoal canister at the rear of the vehicle, that opens to allow fresh air to enter the evaporative emissions system as the engine vacuum purges the fuel vapors from the charcoal canister and closes when purge is not needed to prevent leakage of those fuel vapors to the atmosphere (HC is a greenhouse gas and is regulated as such by the fed gov't).
Given that you have the incorrect purge flow code and the control valve code together, my bet is that the vent control valve has failed (causing the P0446) and is not opening to allow fresh air into the system to displace the air from within the system that is being pulled to the engine. Since you have no fresh air entering the system, the engine will pull a vacuum on the system instead of the vapors "flowing" into the engine (causing the P0441).
I hope that this is helpful to you!!!
ASE Master Technician with L1 and X1 Certifications; Nissan Scope Technician; Chrysler Level 3 Silver Technician- 12+ years experience.
Posted on Nov 17, 2008
Tips for a great answer:
Feb 03, 2014 | Cars & Trucks
Remove and reinstall the gas cap, clear the code, and drive for a day and see if the codes come back.
Inspect the EVAP system for cuts/holes in tubes/hoses.
Inspect for damaged or disconnected hoses around the Evap purge solenoid.
Check and/or replace the sensor.
Check and/or replace the purge valve.
Aug 25, 2011 | 1999 Toyota Corolla
Aug 22, 2010 | 1999 Toyota Corolla
Dec 27, 2008 | 1998 Toyota Camry
Nov 17, 2008 | 2001 Toyota Corolla
1,411 people viewed this question
Usually answered in minutes!