Question about Hyundai Motor 1998 Accent

1 Answer

How do i remove the radio from the dash 1998 hyundai accent

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,513 Answers

Hi
You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out.
OR more elaborately try the following:-
1. Remove the panel under the steering wheel. There should be four bolts - the two at the top are covered with plastic caps. When you have removed the panel, take off the two climate control cables that run to the air controls on the dashboard. They should be secured with clips which need to come off, and the wire centre is wound around a small control knob which should have a push in clip so the wire can slip off.
2. Make the glove box drop down by removing the two plastic clips at the back of the inside of the glove box. These clips are the glove-box buffer stops and should spring off and can be pulled through the clip-opening. Behind the glove-box is another wire to un-clip, but this one slips straight off the metal control actuator.
3. Remove the ash-tray by pressing the spring loaded metal part down and take the two screws out at the back of the ash-tray. You should now be able to unclip the central dashboard. Use a screwdriver to lever it away gently, and watch for the small metal clips that drop out as you do so. As you pull it away the cables you unclipped will come away from their place and come out with the dash unit.
4. After pulling the dash-board out a few inches you should be able to see the seating screws for the radio. Take all the screws out and pull the radio forward. By unclipping the cables at the top of the unit you will find you have enough play to pull the driver's side right forward and jigger the head unit out of the gap on one side of the unit.

Thanks for contacting fixya.com

Posted on Nov 13, 2009

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: how do you remove radio from hyundai accent 1998

You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..

Posted on May 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2002 Hyundai Accent needs a radio code and the dealler no longer has it, what can i do


You can get the code - but it will require some work. The dealer should be able to retrieve this info w/o much difficulty - but will charge more for it. You may want to try a different dealer. In any case, below is how to do it for $29 when the dealer won't. You'll need to know the make, model, year of the car and a valid email address in order for the code to be sent back you.

Remove the radio from the dash and copy the serial number (you must remove the radio from the dash to do this).

Locate & copy the Vehicle Identification Number or VIN (on the car itself or registration documents).

Go to http://www.radio-code.com/HyundiaPayPageRadiocode.htm and fill in the info at the bottom of the page.

Oct 16, 2011 | 2002 Hyundai Accent

1 Answer

How do you remove the stock radio from a 2007 accent hatchback


First, you have to remove the bezel that surrounds the radio. You have to find something thin and sturdy to slide in behind the bezel to carefully pry it away from the dash assembly. Something along the lines of a plastic spackling knife will prevent scratching the dash. There are no screws, only clips holding that bezel in place.

Once you remove the bezel, you will see four screws holding the stock radio in place. Remove those, then slide the radio out.

You will need to unplug the wiring and antenna from the rear of the unit for complete removal.

Apr 22, 2010 | 2007 Hyundai Accent GS Hatchback

2 Answers

I have a hyundai accent 2001 2 doors .my dash


you might need to look at the wires on the back of the radio, there might be an inline fuse, also you best have a look at the main fuse panel in the car and see if the one for the radio and clock has blown

Apr 17, 2010 | 2001 Hyundai Accent

1 Answer

Bought a 1995 hyundai accent from someone and a code is needed to unlock radio and i dont have it


do you have any books or documents with the car that it might be on?
if not remove the radio from the dash, and on it will be a serial number, if you let me have that i will supply your code. if your lucky, someone might even have written the code on the radio case

Mar 07, 2010 | Hyundai Motor 1995 Accent

1 Answer

Need to remove cd/eadio 5065 from dash 2003 Getz -


two pìn hoñes either side of the front of the radio ,push a special tool into these holes to remove the radio

Mar 04, 2010 | 2003 Hyundai Accent

1 Answer

How do i remove the factory stereo surround without breaking it - 2006 model accent?



All new cars are alike and use snaps and clips to hold everything together. Most likly you can remove the trim around the in dash radio unit with a thin metal tool. They have special tools at the car dealer for this. I know with the older model hyundai's there are two clips at the bottom of the front panel where the cigarette lighter thing is. Once you do find a way to remove the front panel there most likly are screws holding the radio unit in. I myself am about to remove my radio unit but I am just gonna stop in to my dealer and see what tool to use.

Dec 24, 2009 | 2006 Hyundai Accent

2 Answers

Main beam not working on my hyundai accent coupe


Problem is either wiring or the bulbs... evident.

Oct 19, 2009 | 1999 Hyundai Accent

1 Answer

How to replace a window cable on hyundai accent


I use to have a Hyundai Pony once, there was no cable there.
But still you need to remove the inside cover etc. to get there.
I became an expert blindfolded and a hyunday hater afterwards.

Apr 14, 2009 | Hyundai Motor 1998 Accent

1 Answer

How do you remove radio from hyundai accent 1998


You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..

Apr 13, 2009 | 2008 Hyundai Accent

2 Answers

How to remove dash cover


use a screw driver around the cover that goes around the vent and facia cover pry gently

Aug 27, 2008 | 2008 Hyundai Accent

Not finding what you are looking for?
Hyundai Motor 1998 Accent Logo

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...