Question about 1998 Dodge Avenger

1 Answer

Looking for power tranistor mitsubishi m67580

Looking for power tranistor made by mitsubishi for 98 sebring. internal distributor part. need to find out how to test it and where to get a replacement part if needed

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

The transister is an igbt. The leftmost lead is the gate, the middle lead is the collector and the rightmost lead is the emitter. The coil has +12v on the top and the transister drives the coil by sinking the bottom to ground though the emitter. You could test by momentarily bringing the gate positive and see if the coil is firing.

Posted on Jan 23, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im asking where is the cam shaft position sensor on my 2000 chrysler sebring jxi with the 2.5 L engine


The 2.5L engine has a distributor. There is a sensor internal to it that senses camshaft position and it does not have an external camshaft position sensor as do the 2.4 and 2.7L.

Sep 25, 2015 | Chrysler Cars & Trucks

2 Answers

My 1998 chrysler sebring convertable wont start I replaced the fuel filter and fuel pump new battery the car will turn over just wont start


Verify you have spark, those are known to have issues with the camshaft sensor in the distributor. I have put 2 distributors in my daughter's 97 sebring jxi, did the same thing.

Jul 22, 2014 | 1998 Chrysler Sebring

2 Answers

No power to the distributor on a 1998 chyrsler sebring


This car uses a basic distributor. The coil gets power from the shut-down relay brown-red wire and the cam sensor is inside the distributor. The cam sensor gets power from the key switch brown-white wire.
The relay is powered from a fuse with battery power and turned on by the key switch.

Jul 03, 2012 | 1998 Chrysler Sebring

1 Answer

My 98 chrysler sebring convertible will not start. lights, windows and other power works. Worked fine this morning, husband tried using jumper cables and still would not turn over.


my 97 just did the same thing, turns out it needs a new distributor cap and points, $500.00 thru napa, $1000.00 thru the dealer

Aug 03, 2010 | 1998 Chrysler Sebring

1 Answer

No rotation of distributor


while it's possible the gear came off the end of the distributor, the most likely cause of this issue is a broken timing belt, which doesn't always cause engine damage. if you can, unbolt the distributor from the engine and just check to see that the keyway is still attached to it and spins it. if so, take it into the shop because you've got something internal going on, whether it's the timing belt, or a broken camshaft.

Feb 16, 2010 | 1992 Mitsubishi Montero

1 Answer

Can i replace the camshaft sensor on my sebring


the camshaft sensor is not sold separately for a 2.5 engine,it is mounted in the distributor and you would have to replace the whole distributor!

Dec 05, 2009 | 2000 Chrysler Sebring

1 Answer

Why does my 95 sebring cut out after i drive it awhile .It drives ok until i drive about 3 miles then it loses power.


you might have a bad distributor, but inspect E.G.R.and crank signal, is this a 2.5? very common for this eng. size distributor goes bad and if installed non factory one will ended up having same problem

Nov 17, 2009 | 2000 Chrysler Sebring

1 Answer

Need advice/tips on changing spark plugs on a 98 Sebring Convert 2.5. Looking for best way to access etc...


take off the upper plemnum while you in there change the wires cap and rotor for the distributor as well..

Apr 16, 2009 | 1998 Chrysler Sebring

1 Answer

99 sebring convertible...changed plugs...no start


What engine does this have? 2.5? If so these have a real problem with the distributors. The parts stores stock them.

Mar 01, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
1998 Dodge Avenger Logo

Related Topics:

1,269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...