Question about 1996 Plymouth Voyager

2 Answers

Whare is the waterpump? - 1996 Plymouth Voyager

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 8,197 Answers

The water pump on a Plymouth Voyager is hidded. Very Hidden. It is ran by the timing belt. Remove everything on the left hand side of the engine. Remove the Timing belt covers. Now you should be able to see the Water Pump. The pully on in the Upper center is the waterpump.

Posted on Nov 13, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Follow bottom radiator hose and it will lead to it. It is on front of motor.

Posted on Nov 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rodeo waterpump blew now wont start


Hi, The first thing I would check is the BATTERY. Check the connections and wire conditions. The waterpump has no connection to the battery. The motor drives the pump. Hope that helps.

Aug 13, 2014 | Cars & Trucks

1 Answer

Waterpump


pull out your coolant res.
pull off your belt.
you will see the old waterpump.
remove all four bolts.
clean off gasket off waterpump mount on motor.
place gasket.
install.

Jun 30, 2012 | 1999 Pontiac Sunfire

1 Answer

How do i tell if my overheating problem is the waterpump on my 2.0 l '96 contour?


remove coolant thermostat and run vehicle if overheating occurs waterpump is problem

Apr 12, 2012 | 1996 Ford Contour

1 Answer

Procedure on changing waterpump


  1. first drain the cooling system.
  2. loosen bolts on the waterpump pulley and remove the inner fender cover on the pass/side.
  3. remove the surpentine fan belt, note; make a diagram of the belt routing so belt will go back on the right way.
  4. remove the bolts you loosened on the pump pulley, use a pry bar to pry engine back to have enough room to remove the waterpump pulley.
  5. remove the bolts holding waterpump, you will want a pan under the van to catch coolant when waterpump is removed,
  6. remove the pump and clean old gasket off the block and install new pump,
  7. reverse to install new pump and fill system with coolant allow engine to run until thremostat opens,hope this is helpful. heres a few diagrams of the waterpump and the cover and the belt routing, good luck and hope this is helpful.
  8. e0c2b8f.png3e5449e.giff12ccdc.gif

Oct 27, 2010 | 2005 Dodge Caravan

2 Answers

Whare is the Cam position sensor located? 1998 Buick Lesaber with 3.8L Issue is Car will turnover but not crank on hot days only. In the morning the car will start every time but later during the day it...


It is on the front of the motor just under the rear part of the waterpump in the timing cover. But I doubt it is the problem. Sounds more like a bad crank sensor. Which is located behind the crank pulley.

Jun 27, 2010 | 1998 Buick LeSabre

1 Answer

Whare can i finde the speed sensor for my 91 accord and whare can i look to see a diogram of whare its located


Not sure where you can find a picture besides a repair manual, but the sensor is located on the pass side of the car below where the lower radiator hose hooks up to the engine, look straight down you will see a sensor with three wires going into it, two 10mm bolts hold it down.

Apr 28, 2010 | 1991 Honda Accord

2 Answers

Do you have to remove power steering belt pulley to change the water pump?


no, just remove the belt, then the cover over the waterpump then the waterpump pulley,NOTE; loosen waterpump pulley bolts before removing the belt,just loosen dont remove!,next is to remove bolts holding waterpump and pump comes out,9e51b2d.gif

Apr 10, 2010 | 2004 Chevrolet Impala

1 Answer

Exploded diagram 95 lincoln town car 4.6l


If your talking about the heater pipe and hose under the intake....(to ease removal you can remove the inlet air cowl/wipers/etc.) remove upper intake/coils/fuel line etc. the tube is bolted to the back of the RT head...replace the entire tube/hose assemble....IF the tube at the frt of the block is corroded/damaged/etc. you will need to replace that also (remove waterpump for access and installation)...change you T/Stat at this time also....hope this helped you...GL

Jul 08, 2009 | 1995 Lincoln Town Car

1 Answer

Trying to set timing on a 1992 mazda


i would suggest buying a book for the car...they are full of really good pictures and are fairly cheap...sometimes they even have them at the libary

Feb 21, 2009 | 1992 Mazda 626

2 Answers

Waterpump removing fan


Well, if it's a 5.0L engine, remove the 4 bolts holding the fan to the pulley. If it's a 4.0L engine, you need to hold the waterpump pulley still and break the nut loose holding the fan clutch to the waterpump. If you don't have a wrench that big, try using a long chisel on the edge of the nut and hitting it very hard with a hammer to break it loose.

Feb 15, 2009 | 1996 Ford Explorer

Not finding what you are looking for?
1996 Plymouth Voyager Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...