Question about 1999 Isuzu Rodeo

1 Answer

Start engine its ok after you drive away engine accelerate to about 1500 rpm,i have to shut engine off then restart again.it will be ok for awhile then i have to repeat it again.i have check throttle cable its free,it doesnt matter if its cold outside or if engine is cold its still idles high

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Isuzu Expert
  • 262 Answers

Your throttle is sticking spray some wd40 th loosen it

Posted on Nov 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1995 chevy silverado 1500 with the 305 auto. It will start and idles just fine. But if i turn the AC on, or put it in gear. or put any strain at all on the engine it will start to hesitate and...


if it has a carby ( you didn't bother to mention carby or EFI), have the carby overhauled as from your description, the accelerator and power sections of the carby are not working, Blocked jets or low float levels
if it is EFI have the fault codes read to check for MAF/VAF sensors and/ or heated oxygen sensor problems
your description indicates that the engine is not getting excess fuel to provide engine rpm acceleration be it either carby or electronic system

Mar 22, 2017 | Chevrolet 1500 Cars & Trucks

1 Answer

2007 VW 1.6 FSI 1KZ will shut off when at operating temperature. It will always restart and might or might not shut off again. Usually it happens after starting and pressing the accelerator. Other times it...


Have the 'Throttle' or 'Accelerator' re learn performed. Some will re learn as follows : Turn ignition to RUN with engine OFF. Push throttle pedal to the floor and hold it there for 30 seconds.

Turn ignition off and then release throttle. Start engine and allow it to idle until warm ( 80C.) Do not rev the engine or put it in gear dueing warm up. It must be allowed to warm up at idle only. When you hear the radiator fan come on, turn engine off. Wait 10 seconds and restart engine. Test drive.

This procedure MAY have caused the throttle to relearn. If the same problem is present, go to dealer or VW shop and have them 'relearn' the throttle with a scanner.

Oct 27, 2013 | Volkswagen Cars & Trucks

1 Answer

2011 Nissan Rogue SL AWD has sluggish acceleration


Start by checking for codes. Even if no check engine light still may have code. Sounds like app code

Jun 16, 2012 | 2011 Nissan Rogue

1 Answer

RPM is @1500 say 60 Km an hr, when I lift off throttle rpm jumps up aprox 300 rpm. And why does it take so long for rpm to come down?when it does it drops to 1000,i touch accelerator very light-ly it...


Disconnect the battery for 10 minutes reconnect the battery then start the car and put it into the D postion with your for on the brake for 30 seconds then while still holding the brake put the car the N postion for 30 seconds still holding the brake now put the car back into the D postion for 30 seconds then put the car into the PARK postion and shut it off. Wait 10 second then start it and take it for for a test drive. Make sure the a/c is off and the radio,wipers are off while doing this procedure. This is called an adaptive relearn.

Apr 28, 2011 | 2003 Chevrolet Impala

1 Answer

Pontiac turn of in low rpm


that would be your o2 sensor most likely. make sure its plugged in properly and that its not bad.

Mar 01, 2010 | 1999 Pontiac Grand Prix

2 Answers

RPM drops to zero at idling after engine accelerates when warm


This may been an ignition module or a MAF sensor, this car may need to be diagnosed using a OBD I computer code reader to accurately diagnose the problem.

Aug 06, 2009 | 1998 Mitsubishi Eclipse

1 Answer

2005 MPV shuts off after I let go of the gas after


I'd pull the "idle air control valve " (located on side of throttle body near front) off, and use some throttle body spray cleaner on it & the port it came out of. Spray pintle (pointed part) good to remove any gunk etc. Re-install, it & try it. if it cures your problem for a while & starts to act up again, replace it.

Aug 06, 2009 | 2007 Mazda MPV

2 Answers

Truck shuts off anfd restart right away, no trouble code.


First thing I'd check would be battery cables, at both ends for clean, good & tight. Does it ever do it while driving at highway speeds or just at slow speeds? Wet out, dry out?

Nov 18, 2008 | 2001 Dodge Ram 1500 Truck 2WD

2 Answers

Loss of power at 2400 rpm's


Check your mass airflow meter. If it's bad, at least on my 1990 300ZX, the car won't rev over 2400RPM (it's a safeguard built into the ECU of the car). Grab one from a scrapyard and swap it in and see if that fixes the issue.

Aug 23, 2008 | 1984 Nissan 300ZX

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...